Jun Satonobu | PubMed Health

PubMed2003

A single-element tuning fork piezoelectric linear actuator.

This paper describes the design of a piezoelectric tuning-fork, dual-mode motor. The motor uses a single multilayer piezoelectric element in combination with tuning fork and shearing motion to form an actuator using a single drive signal. Finite-element analysis was used in the design of the motor, and the process is described along with the selection of the device's materials and its performance. Swaging was used to mount the multilayer piezoelectric element within the stator. Prototypes of the 25-mm long bidirectional actuator achieved a maximum linear no-load speed of 16.5 cm/s, a maximum linear force of 1.86 N, and maximum efficiency of 18.9%.

Journal Article↗

PubMed2002

Numerical analysis of the hybrid transducer ultrasonic motor: comparison of characteristics calculated by transmission-line and lumped-element models.

In this paper, a hybrid transducer ultrasonic motor is numerically analyzed by using two equivalent electrical circuit models. A transmission-line model for the torsional vibration in the stator, which can model any torsional vibration mode and their combinations, was introduced and compared with a lumped-element model, which modeled the fundamental torsional resonance mode in the stator. The calculation result by using the transmission-line model demonstrated that the second harmonic torsional vibration increased either with the static spring force by which the rotor was pressed to the stator or with the load torque placed on the rotor. The difference in the calculated motor performance between the two models appeared when the second harmonic torsional vibration became large at a sufficient static spring force.

Transducers↗