PubMed Health⌕ Search

Biomedical subjects

K Gausch

Publications and source records attributed to K Gausch.

At least 19 recordsLinked to original sources

Comparison of resin-bonded prosthesis groove parallelism with the use of four tooth preparation methods.

STATEMENT OF PROBLEM: A precise preparation is required to develop resistance form resulting in mechanical stability of the framework for resin-bonded prostheses (RBPs). PURPOSE: The effects of 4 methods of tooth preparation (freehand, guiding pin, extraoral parallelometer, and intraoral parallelometer) on the deviation of proximal grooves from a preestablished path of insertion (guide planes) were investigated under clinical conditions. MATERIAL AND METHODS: Tooth preparation of proximal grooves was performed by 32 dentists on resin substitutes of posterior segments intraorally with a single test patient. A Latin-square randomized cross-over design was selected as the experimental design. RESULTS: The significant least angular deviation of proximal grooves from path of insertion was achieved with an intraoral parallelometer (mean +/- SD 3.15 +/- 1.67 degrees). Compared with freehand tooth preparations (4.37 +/- 2. 11 degrees), neither use of a guiding pin (4.10 +/- 1.62 degrees) nor an extraoral parallelometer (5.06 +/- 2.33 degrees) improved the results. CONCLUSION: Divergence of guiding grooves from path of insertion was reduced with the use of an intra-oral parallelometer. This should improve mechanical stability of posterior RBPs.

Acrylic Resins↗

Quantitative analysis of masseter and temporalis EMGs: a comparison of anterior guided versus balanced occlusal concepts in patients wearing complete dentures.

The lack of easily measurable, objective physiological activity parameters of the masseter and temporalis muscle during jaw movements in humans has led to the consideration to revise data of surface electromyographies (EMGs) by applying a computerized quantification method. The aim of this follow-up analysis was to get quantitative data out of EMG-records of an earlier study. These records were obtained with two different splints, splint 1 providing an anterior front-canine guidance and splint 2 providing bilateral balanced occlusion. Utilizing a computer aided integration method led to numeric results which statistically proves the prediction of the previous investigation. Applying the integration method, the EMG raw signal was transformed into area-values which enabled a statistical work up of the data. Wilcoxon test statistics shows a significant (P<0.05) lower muscle activity in patients wearing dentures providing anterior front-canine guidance compared to those with balanced occlusion. It is concluded that the neuromuscular activity of the elevator muscles is highly reproducible and that the neuromuscular function is similar in edentulous subjects to that found in people with natural teeth. Furthermore, the study statistically proves earlier visual data that all those subjects, whose muscle activities were observed with anterior guidance (splint 1) compared to bilateral balanced occlusion (splint 2) showed significantly lower values with regard to subjects wearing splint 2.

Centric Relation↗

Masseter and temporalis surface electromyography in patients wearing complete dentures comparing anterior and posterior occlusal concepts--a pilot study.

The activity of jaw elevator muscles (masseter and anterior temporal muscle) was studied by surface electromyography in 17 patients wearing complete dentures with anterior-canine guidance. Baseline electromyography was recorded with the dentures and compared to recordings obtained with two different splints adapted to the upper denture, one providing anterior guidance leading to immediate disclusion of the posterior teeth during any jaw movement, the other providing posterior guidance buccally on the working side and lingually on the non-working side (bilaterally balanced occlusion). Recordings were obtained during a sequence of different jaw movements: postural position, maximal tooth contact in intercuspal position, protrusive movement of the mandible (under tooth contact) and during lateral excursions, also carried out under tooth contact. Muscle activity was not significantly different as recorded with dentures only versus with the splints providing anterior guidance. However, a significant increase in activity was observed with bilaterally balanced occlusion. The results of this study in edentulous people are similar to those found in patients with natural teeth.

Aged↗

Distance alterations of dies in sagittal direction in dependence of the die material.

The distance alterations between the first premolar and second molar in the sagittal direction were measured on complete arch models in two planes. Two dental stones, three resins, and silver-plating were used to make reproductions of a master cast under standardized conditions. Special emphasis was directed to the distinction between the right half of the model with teeth between the dies and the left side edentulous between the dies. The stones Die Keen and Fuji Rock showed the least distortion, identical bilaterally. The epoxy resins Blue Star E and Metapox exhibited a significant distinction between the right and the left sides. In addition to the pronounced distance reduction caused by polymerization shrinkage, a divergence between the dies and the model base on the side with teeth was measured. This phenomenon was also observed with polyurethane Blue Star P resin, but was less substantial. Silver-plating recorded a slightly greater reduction in distance between the dies than Fuji Rock. However, no significant differences were found between both sides.

Calcium Sulfate↗

[Surface structures and substance loss during the etching of ceramic materials].

The progressive development of all-ceramic systems used in prosthetic dentistry gives material-specific aspects a new significance. It was the purpose of this study to examine the surface morphology of various ceramics (Mirage, Dicor, Optec, Vitadur N, Ceramco II) etched with various solutions (Super-Etch, Stripit, hydrofluoric acid 40%, Dicor retention gel) and etching times (1, 2, 3, and 4 min), using a SEM. With the exception of Dicor, the etched surface of ceramics showed similar structures within each material group, regardless of the etching time and the etching solution used. Dicor showed a different pattern depending on the etching time. An additional measurement of the surface roughness revealed an advisable etching time of 1 min with an average loss of ceramic material of 1.6 microns for those ceramics treated with the etching solutions Super-Etch, Stripit and Dicor retention gel. Hydrofluoric acid 40% caused a significant loss of substance and should not be used. A qualitative evaluation of the surface structure of composite cements (Chameleon, Dicor, Optec and Dual cement) in etched ceramics and in etched enamel showed completely filled microretentions.

Acid Etching, Dental↗

[Arthrography of the functionally disordered temporomandibular joint].

Arthrography provides accurate information concerning abnormal changes and function of the soft tissue components of the T.M.J. It is superior to all other clinical and radiological methods of examination for elucidating functional abnormalities. The increasing incidence of functional T.M.J. abnormalities and improvements in treatment make arthrography of the T.M.J. of increasing importance. The importance of views in the sagittal plane and of video recordings is stressed.

Contrast Media↗

Occlusal therapy of neuromuscular problems in the orofacial region.

Neuromuscular problems in the orofacial region are often caused by a disturbance of the occluso-articular relation. It is therefore often possible to alleviate the symptoms by appropriate occlusal corrections. However, since there is no guarantee of success in treatment, particular store is set by initial therapy with a programmed functional splint, which is without risk of introducing irreversible changes. This splint incorporates the essential features of the occlusion and is at the same time programmable to reposition malpositioned condyles. Definitive treatment measures are justified only when the symptoms have completely disappeared and when the position of the mandible has been controlled and fixed for a relatively long period.

Dental Occlusion, Balanced↗

[Dental and gnathological aspects of facial neuralgia (author's transl)].

Disturbances of dental occlusion may lead to hyperactivity of the regional musculature, accompanied by a displacement of the lower jaw. The muscle and joint pains which then occur are the principal causes of the complex picture of facial neuralgia from the gnathological point of view, but the emotional factor must not be overlooked. The dental treatment of the pain syndrome demands extremely high expenditure in time and technical equipment. It usually consists of repositioning the displaced mandible with subsequent stabilization by dental technical measures. It is, moreover, important to keep parafunctional activity of the masseter muscles as low as possible or to suppress it altogether by purposeful arrangement of the occlusal surface complex.

Dental Occlusion, Balanced↗

[The condymeter].

The condymeter serves for the technical measurement of condylar displacement where the usual condylar position (habitual intercuspidation) is used as a relative constant. Technical fitting and calibration of the machine with the commercially available SAM-Articulator System ensures its time-saving use in diagnosis and and therapy of diseases of the temporo-mandibular joint and the neuromuscular system.

Dental Articulators↗