PubMed Health⌕ Search

Biomedical subjects

K L Schick

Publications and source records attributed to K L Schick.

8 recordsLinked to original sources
PubMed1993

Nucleotide exchange and rheometric studies with F-actin prepared from ATP- or ADP-monomeric actin.

It has recently been reported that polymer actin made from monomer containing ATP (ATP-actin) differed in EM appearance and rheological characteristics from polymer made from ADP-containing monomers (ADP-actin). Further, it was postulated that the ATP-actin polymer was more rigid due to storage of the energy released by ATP hydrolysis during polymerization (Janmey et al. 1990. Nature 347:95-99). Electron micrographs of our preparations of ADP-actin and ATP-actin polymers show no major differences in appearance of the filaments. Moreover, the dynamic viscosity parameters G' and G" measured for ATP-actin and ADP-actin polymers are very different from those reported by Janmey et al., in absolute value, in relative differences, and in frequency dependence. We suggest that the relatively small differences observed between ATP-actin and ADP-actin polymer rheological parameters could be due to small differences either in flexibility or, more probably, in filament lengths. We have measured nucleotide exchange on ATP-actin and ADP-actin polymers by incorporation of alpha-32P-ATP and found it to be very slow, in agreement with earlier literature reports, and in contradiction to the faster exchange rates reported by Janmey et al. This exchange rate is much too slow to cause "reversal" of ADP-actin polymer ATP-actin polymer as reported by Janmey et al. Thus our results do not support the notion that the energy of actin-bound ATP hydrolysis is trapped in and significantly modifies the actin polymer structure.

Actins↗
PubMed1991

Probe diffusion in solutions of filamentous actin formed in the presence of gelsolin.

Dynamic light scattering was used to characterize the diffusion of monodisperse polystyrene latex spheres (PLS) of different sizes (55-, 105-, and 265-nm radii) in column-purified 0.65 mg/mL actin solutions polymerized with 100 mM KCl in the absence and presence of various amounts of the actin-binding protein gelsolin. The gelsolin and its interaction with actin was initially studied to ensure that the gelsolin could be used to produce filament populations with well-defined mean lengths. Measurements with PLS diffusion probes present showed, in the absence of gelsolin, that the effective local microviscosity in the actin solutions was 5-20 times that of water and that a large fraction of the PLS are trapped within the pores of the actin filament network, as found previously [J. Newman, K. L. Schick, & K. S. Zaner, (1989) Biopolymers 28, 1969-1980]. As the molar ratio of gelsolin to actin was increased, the diffusion coefficients of the PLS approached those in pure water while the degree of PLS trapping went to zero. Measurements of the dependence of the PLS diffusion coefficients on the ratio of actin concentration to the semidilute overlap concentration showed, for the smaller PLS, a transition occurring near the mean global overlap concentration. These results reflect the dissolution of the actin network as the gelsolin concentration is increased and illustrate the role of gelsolin/actin interactions in the control of macromolecular transport within the periphery of cells.

Actins↗
PubMed1989

Dynamic light scattering measurements of the diffusion of probes in filamentous actin solutions.

The diffusion coefficients of monodisperse polystyrene latex spheres in solutions of polymerized actin were measured using dynamic light scattering. Four different probes with radii R, ranging from 50 to 500 nm, were separately used in actin solutions with concentrations c, ranging from 1.5 to 21 microM, which had been polymerized with either 1 mM MgCl2, 1 mM CaCl2, or 100 mM KCl. Under all conditions, and at four different scattering angles in the range of 30 degrees-90 degrees, the measured average diffusion coefficients D of the probes were systematically smaller for samples of increased actin concentration or of increased probe radius. Control experiments indicated that the probes did not bind to the actin. These data for Mg2+- and Ca2+-polymerized actin agree and were found to be quite well summarized by the scaling relation D/D0 = exp[-alpha R delta c nu], where D0 is the measured diffusion coefficient of the probes in water (and, as also measured, in the starting actin solutions prior to polymerization with added salt), with values of delta = 0.73 +/- 0.05, nu = 1.08 +/- 0.09, and alpha = (1.1 +/- 0.6) x 10(-3) (with c in microM and R in nm). Data for KCl-polymerized actin show much more restricted diffusivities of the probes at comparable actin concentrations. Inhomogeneities in the solution are reflected in the "effective polydispersity" of the probe diffusion coefficients, which depend on local microviscosity differences.

Actins↗
PubMed1989

Probe diffusion in cross-linked actin gels.

The diffusion of monodisperse polystyrene latex spheres (PLS) in column-purified 0.65 mg/mL actin solutions, polymerized with 100 mM KCl in the absence and presence of a cross-linker, actin binding protein (ABP), has been studied using dynamic light scattering. Measurements over a wide range of scattering angles from 90 degrees to 8 degrees, corresponding to inverse scattering vector probing distances of about 40-400 nm, respectively, give a measure of both the fraction of PLS mobile over the probing distance (from the normalized time autocorrelation function amplitude) and the average diffusion coefficient of the mobile PLS. Both 100- and 500-nm diameter PLS are fully mobile in polymerized actin solutions over distances of less than 100 nm, as reported previously (Newman, J., Schick, K. S. & Gukelberger, G. Biophys. J. 53, 573a, and Newman, J., Mroczka, N. & Schick, K. L. Biopolymers, 28, 655-666). At increasing probing distances, or when ABP is added at molar ratios of 1:750 or 1:150, greater fractions of the PLS are immobilized, up to almost 99% at the conditions of a 400-nm probing distance with 500-nm probes and at a ratio of 1:150 added ABP to actin. The degree of immobilization correlated well with the amount of added ABP, the size of the PLS, and the probing distance. At increasing probe distances, as the degree of immobilization increases, the remaining mobile fraction of PLS has an increasing average diffusion coefficient. These results suggest a range of pore sizes in the actin gels with a mean size of a few hundred nanometers.

Actins↗
PubMed1988

Rheology of G-actin solutions.

Recent reports that dilute solutions of G-actin form viscoelastic gels have been investigated using several experimental variations of three distinct physical techniques in independent laboratories. Direct measurement of storage and loss moduli were made using two rheometers of different design. Measurements of the diffusion of G-actin and of tracer particles added to G-actin solutions were carried out using dynamic light scattering and fluorescence photobleaching recovery techniques. Measurements were performed over a period of many hours, on actin solutions prepared under conditions for which anomalous gelation had been reported. All data from this investigation are consistent with the conclusion that dilute G-actin solutions behave as newtonian liquids.

Actins↗