PubMed Health⌕ Search

Biomedical subjects

K Y Tong

Publications and source records attributed to K Y Tong.

10 recordsLinked to original sources

The mechanomyography of persons after stroke during isometric voluntary contractions.

This study was to investigate the properties of mechanomyography (MMG), or muscle sound, of the paretic muscle in the affected side of hemiplegic subjects after stroke during isometric voluntary contractions, in comparison with those from the muscle in the unaffected side of the hemiplegic subjects and from the healthy muscle of unimpaired subjects. MMG and electromyography (EMG) signals were recorded simultaneously from the biceps brachii muscles of the dominant arm of unimpaired subjects (n=5) and the unaffected and affected arms of subjects after stroke (n=8), when performing a fatiguing maximal voluntary contraction (MVC) associated with the decrease in elbow flexion torque, and then submaximal elbow flexions at 20%, 40%, 60% and 80% MVCs. The root mean squared (RMS) values, the mean power frequencies (MPF, in the power density spectrum, PDS) of the EMG and MMG, and the high frequency rate (HF-rate, the ratio of the power above 15Hz in the MMG PDS) were used for the analysis. The MMG RMS decreased more slowly during the MVC in the affected muscle compared to the healthy and unaffected muscles. A transient increase could be observed in the MMG MPFs from the unaffected and healthy muscles during the MVC, associated with the decrease in their simultaneous EMG MPFs due to the muscular fatigue. No significant variation could be seen in the EMG and MMG MPFs in the affected muscles during the MVC. The values in the MPF and HF-rate of MMG from the affected muscles were significantly lower than those from the healthy and unaffected muscles (P<0.05) at the high contraction level (80% MVC). Both the MMG and EMG RMS values in the healthy and unaffected groups were found to be significantly higher than the affected group (P<0.05) at 60% and 80% MVCs. These observations were related to an atrophy of the fast-twitch fibers and a reduction of the neural input in the affected muscles of the hemiplegic subjects. The results in this study suggested MMG could be used as a complementary to EMG for the analysis on muscular characteristics in subjects after stroke.

Adult↗

Firing properties of motor units during fatigue in subjects after stroke.

The purpose of this work was to investigate the electromyographic (EMG) fatigue representations in muscles of subjects after stroke at the level of motor unit, based on the analysis of mean power frequency (MPF) in the power density spectrum (PDS) for intramuscular EMG and our previous modeling and experiment studies on the neuromuscular transmission failure (NTF). NTF due to the local muscular fatigue had been captured in motor unit signals from healthy subjects during a submaximal fatigue contraction previously. In this study, the EMG signals for the biceps brachii muscles were collected by needle electrodes from the affected and unaffected arms of six hemiplegic subjects after stroke, and from the dominated arm of six healthy subjects during a full maximum voluntary contraction (MVC) and a subsequent 20% MVC. The MPF of EMG trials detected intramuscularly during the full and 20% MVCs, and the parameters of motor unit action potential trains (MUAPTs) during 20% MVC were analyzed in three groups: the normal (from healthy subjects), unaffected (from subjects after stroke), and affected (from subjects after stroke). It was found that during the full MVC the MPFs of the normal and unaffected groups decreased more than the affected when monitored by a moving time window of 2 s. The comparison on the overall MPF during the full MVC for these three groups over the whole time course of the EMG signal (18 s) were: the affected overall MPF was higher than the unaffected (P < 0.05); and the unaffected overall MPF was larger than the normal (P < 0.05). However, no significant decrease in MPF was found for these three groups during 20% MVC. The NTF was captured in most MUAPTs in the groups of the normal and unaffected rather than in the affected group, symbolized by the lowered rates of change (RCs) of firing rate (FR) (P < 0.05), more MUAPTs with positive RCs of maximum oscillation (MO) in MUAPT power density spectra (P < 0.05), and the significant higher RCs of minimum inter-pulse interval (MINI) (P < 0.05) in the normal and unaffected compared to the affected group. Enhanced neural drives to the motor units of the unaffected and affected groups were observed during 20% MVC, which possibly came from the bilateral neural inputs due to the disinhibition of the ipsilateral projections in subjects after stroke. For identifying the fatigue associated with NTF, the motor unit firing parameters, FR, MINI, and MO, were more sensitive than the MPF. The results obtained in this work provided a further understanding on the EMG of the fatigue processes in paretic and non-paretic muscles during voluntary contractions.

Action Potentials↗

Using recurrent artificial neural network model to estimate voluntary elbow torque in dynamic situations.

Muscle modelling is an important component of body segmental motion analysis. Although many studies had focused on static conditions, the relationship between electromyographic (EMG) signals and joint torque under voluntary dynamic situations has not been well investigated. The aim of this study was to investigate the performance of a recurrent artificial neural network (RANN) under voluntary dynamic situations for torque estimation of the elbow complex. EMG signals together with kinematic data, which included angle and angular velocity, were used as the inputs to estimate the expected torque during movement. Moreover, the roles of angle and angular velocity in the accuracy of prediction were investigated, and two models were compared. One model used EMG and joint kinematic inputs and the other model used only EMG inputs without kinematic data. Six healthy subjects were recruited, and two average angular velocities (60 degrees s(-1) and 90 degrees s(-1)) with three different loads (0 kg, 1 kg, 2 kg) in the hand position were selected to train and test the RANN between 90 degrees elbow flexion and full elbow extension (0 degrees). After training, the root mean squared error (RMSE) between expected torque and predicted torque of the model, with EMG and joint kinematic inputs in the training data set and the test data set, were 0.17 +/- 0.03 Nm and 0.35 +/- 0.06 Nm, respectively. The RMSE values between expected torque and predicted torque of the model, with only EMG inputs in the training data set and the test set, were 0.57 +/- 0.07 Nm and 0.73 +/- 0.11 Nm, respectively. The results showed that EMG signals together with kinematic data gave significantly better performance in the joint torque prediction; joint angle and angular velocity provided important information in the estimation of joint torque in voluntary dynamic movement.

Adult↗

Oscillations in the power spectra of motor unit signals caused by refractoriness variations.

The refractory period of a motor unit is an important mechanism that regulates the motor unit firing, and its variation has been found in many physiological cases. In this study, a new observation that an increase in the motor unit refractoriness results in an enhancement of oscillations, or ripple effects, in the motor unit output power density spectra (PDS) has been identified and studied. The effects of the refractoriness variation on the PDS of motor unit firing were investigated on three levels: theoretical modeling, simulation and electromyographic (EMG) experimentation on human subjects. Both theoretical modeling and simulation showed the enhanced oscillations, ripple effects, in MUAPT PDS, given the increase in the refractoriness. It was also found that the extent of the increment in output PDS oscillation could be related to the motor unit size and the mean firing rate of the stimulation. A needle EMG experiment on biceps brachii muscles of five healthy human subjects was carried out during isometric contraction at 20% maximum voluntary contraction (MVC) for 20 s with a fatigue effort proceeded by MVC. The increased oscillations in the PDS of the real MUAPTs were observed with the rising of the motor unit refractoriness due to fatigue. The study gives new information for EMG spectra interpretation, and also provides a potential method for accessing neuromuscular transmission failure (NTF) due to fatigue during voluntary contraction.

Action Potentials↗

Command control for functional electrical stimulation hand grasp systems using miniature accelerometers and gyroscopes.

Recent commercially available miniature sensors have the potential to improve the functions of functional electrical stimulation (FES) systems in terms of control, reliability and robustness. A new control approach using a miniature gyroscope and an accelerometer was studied. These sensors were used to detect the linear acceleration and angular velocity of residual voluntary movements on upper limbs and were small and easy to put on. Five healthy subjects and three cervical spinal cord injured subjects were recruited to evaluate this controller. Sensors were placed on four locations: the shoulder, upper arm, wrist and hand. A quick forward-and-backward movement was employed to produce a distinctive waveform that was different from general movements. A detection algorithm was developed to generate a command signal by identifying this distinctive waveform through the detection of peaks and valleys in the sensor's signals. This command signal was used to control different FES hand grasp patterns. With a specificity of 0.9, the sensors had a success rate of 85-100% on healthy subjects and 82-97% on spinal cord injured subjects. In terms of sensor placement, the gyroscope was better as a control source than the accelerometer for wrist and hand positions, but the reverse was true for the shoulder.

Adult↗

Development of computer-based environment for simulating the voluntary upper-limb movements of persons with disability.

Upper-limb orthotic systems have been designed for restoring the upper-limb functions of individuals with disabilities resulting from spinal cord injury (SCI), stroke and muscular dystrophy. These systems employ either functional electrical stimulation or external power. It is proposed that, instead of time-consuming and complicated monitoring using sensors and motion analysis, a software simulator with both angular displacement and acceleration parameters can facilitate the design of a control strategy for an orthosis. Reaching movements of three cervical SCI subjects are used to verify the simulator. A motion analysis system is used to measure the range of motion and joint angles during hand reaching. Results indicate that quaternion and spline curve techniques are suitable for interpolation of the hand reaching movements. The information needed for good simulation only compress the shoulder and elbow joint angles in a few key postures. Stimulated acceleration signals on the upper-arm segment have a high correlation coefficient (> 0.9) and a small root mean squared error (< 0.11 g) with a real bi-axial accelerometer.

Arm↗

[Direct determination of selenium and bismuth in antimony and antimony compound by hydride generation-atomic fluorescence spectrometry].

The interference of Sb in determination of Se and Bi in antimony powder and antimony compound has been studied in different acidity, it is found that the interference of antimony has been reduced apparently in high acidity. Simultaneously, according to the difference of hydride generation reaction between Sb5+ and Sb3+, a sensitive and rapid method has been developed and used to determine Se and Bi in real samples. The recovery of the method is 95%-105% for practical samples. Detection limits are 0.00004 x 10(-2) (content) for Se and 0.0001 x 10(-2) mg.L-1 (content) for Bi respectively. The relative standard deviations of Se are 2.4% (content = 0.00169 x 10(-2) mg.L-1) and 5.4% (content = 0.00056 x 10(-2) mg.L-1). The relative standard deviations of Bi are 5.0% (content = 0.00024 x 10(-2) mg.L-1) and 1.3% (content = 0.00229 x 10(-2) mg.L-1). The method has been applied to determination of Se and Bi in practical samples with satisfactory results.

Antimony↗

Gait control system for functional electrical stimulation using neural networks.

In functional electrical stimulation (FES) systems for restoring walking in spinal cord injured (SCI) individuals, hand switches are the preferred method for controlling stimulation timing. Through practice the user becomes an 'expert' in determining when stimulation should be applied. Neural networks have been used to 'clone' this expertise but these applications have used small numbers of sensors, and their structure has used a binary output, giving rise to possible controller oscillations. It was proposed that a three-layer structure neural network with continuous function, using a larger number of sensors, including 'virtual' sensors, can be used to 'clone' this expertise to produce good controllers. Using a sensor set of ten force sensors and another of 13 'virtual' kinematic sensors, a good FES control system was constructed using a three-layer neural network with five hidden nodes. The sensor set comprising three sensors showed the best performance. The accuracy of the optimum three-sensor set for the force sensors and the virtual kinematic sensors was 90% and 93%, respectively, compared with 81% and 77% for a heel switch. With 32 synchronised sensors, binary neural networks and continuous neural networks were constructed and compared. The networks using continuous function had significantly fewer oscillations. Continuous neural networks offer the ability to generate good FES controllers.

Electric Stimulation↗

Reliability of neural-network functional electrical stimulation gait-control system.

Functional electrical stimulation (FES) has been used for restoring walking in spinal-cord injured (SCI) persons. Using artificial intelligence (AI), FES controllers have been developed that allow the automatic phasing of stimulation, to replace the function of hand or heel switches. However, there has been no study to evaluate the reliability of these AI systems. Neural networks were used to construct FES controllers to control the timing of stimulation. Different numbers of sensors in the sensor set and different numbers of data points from each sensor were used. Two incomplete-SCI subjects were recruited, and each was tested on three separate occasions. The results show the neural-network controllers can maintain a high accuracy (around 90% for the two- and three-sensor groups and 80% for the one-sensor group) over a period of six months. Two or three sensors were sufficient to provide enough information to construct a reliable FES control system, and the number of data points did not have any effect on the reliability of the system.

Adult↗

Virtual artificial sensor technique for functional electrical stimulation.

In the control of Functional Electrical Stimulation (FES) gait systems artificial sensors are used to provide the controller with feedback information. The sensors used range in complexity from simple heel or hand switches to tri-axial accelerometers. There are three basic problems connected with the selection of sensors: the type(s) of sensor(s) to be used, the number of sensors required and the optimum location of the sensor set. In general the choice of the sensor sets has been based on the availability of actual sensors and the experts understanding of where these sensors should be located. Using motion analysis data it is possible to construct an almost unlimited number of virtual sensors on any location of the body surface. Our aim was to develop this technique for construction of virtual sensors and compare these virtual sensors with their physical counterparts. Virtual goniometers, inclinometers, accelerometers and foot switches were constructed and compared with their physical counterparts. In addition visualisation tools were developed to aid in the choice of sensor location. There was a very good correlation between all the virtual and physical sensors. This technique gives flexibility to place virtual sensors almost anywhere on the body surface and also allows the construction of novel sensors.

Acceleration↗