Kamal Shaeer | PubMed Health

PubMed2006

Penile girth augmentation using flaps "Shaeer's augmentation phalloplasty": a case report.

INTRODUCTION: Current girth augmentation techniques rely either on liposuction/injection or on the use of dermal fat grafts. These procedures have serious disadvantages, including regression in gained size, deformities, irregular contour, and asymmetry. Ideally, the augmentation technique should ensure durability and symmetry. This case report describes the first application of a flap (superficial circumflex iliac artery island flap) in penile girth augmentation. MATERIALS AND METHODS: The superficial circumflex iliac vessels were identified and the groin flap was elevated from lateral to medial, rotated toward the penis, and tunneled into a penopubic incision. It was wrapped around the penis short of the corpus spongiosum and insinuated under the glans. RESULTS: Six months after surgery, the patient had an erect girth of 19.5 cm and a flaccid girth of 16.5 cm, compared with 11 cm and 7 cm, respectively, before surgery, thus maintaining the intraoperative girth gain. The outer surface felt smooth with no lobulation. The size of the glans was proportionate to the shaft's girth. CONCLUSION: This case report shows that the application of flaps in penile girth augmentation may provide a reliable alternative to the currently applied techniques. Glans flaring promotes the aesthetic results and is applicable with other techniques of penile girth augmentation.

Adult↗

PubMed2006

Minimizing the losses in penile lengthening: "V-Y half-skin half-fat advancement flap" and "T-closure" combined with severing the suspensory ligament.

INTRODUCTION: The technique most commonly used for penile lengthening is the release of the suspensory ligament in combination with an inverted V-Y skin plasty. This technique has drawbacks such as the possibility of reattachment of the penis to the pubis, a hump that forms at the base of the penis, in addition to alteration in the angle of erection. AIM: In this work, we describe a new technique that overrides these drawbacks and minimize the loss of gained length. METHODS: The suspensory ligament was released through a penopubic incision. The caudal flap of the resected ligaments was reflected caudally and sutured to the Buck's fascia. The V flap was incised. The caudal half of the V was deskinned, leaving a cranial skin-covered V flap, and a caudal, rectangular fat flap. The fat flap was pulled into the gap between the base of the penis and the pubis and secured in position by suturing its deep surface and lower edge to the pubis. This maneuver filled up the gap. The V incision was closed as a Y. The penopubic incision was closed as a T shape, to avoid pulling the penis back at skin closure. A stay suture stretched from the glans to the thigh, maintaining the penis in the stretched position. A urinary catheter was inserted. RESULTS: Six months after surgery, there was no loss in the length gained. The angle of erection (as reported by the patient) was similar to that prior to the procedure. The skin incisions left no hump and a faint scar that was not troublesome to the patient. CONCLUSION: "V-Y half-skin half-fat advancement flap" and "T-closure" may improve the results of suspensory ligament release for penile lengthening. The reported techniques minimize the losses compromising length gain, whether in-surgery or following it.

Adult↗