PubMed Health⌕ Search

Biomedical subjects

Kasper L Pasma

Publications and source records attributed to Kasper L Pasma.

3 recordsLinked to original sources

In situ light dosimetry during photodynamic therapy of Barrett's esophagus with 5-aminolevulinic acid.

BACKGROUND AND OBJECTIVES: Previous studies with PhotoDynamic Therapy (PDT) in bladder and bronchi have shown that due to scattering and reflection, the actually delivered fluence rate on the surface in a hollow organ can be significantly higher than expected. In this pilot study, we investigated the differences between the primary calculated and the actual measured fluence rate during PDT of Barrett's Esophagus (BE) using 23 independent clinical measurements in 15 patients. STUDY DESIGN/MATERIALS AND METHODS: A KTP-dye module laser at 630 nm was used as light source. Light delivery was performed using a cylindrical light diffuser inserted in the center of an inflatable transparent balloon with a length corresponding to the length of the Barrett's epithelium. The total light output power of the cylindrical diffuser was calibrated using an integrating sphere to deliver a primary fluence rate of 100 mW cm(-2). Two fiber-optic pseudo sphere isotropic detectors were placed on the balloon and were used to measure fluence rate at the surface of the esophageal wall during PDT. RESULTS AND CONCLUSIONS: The actual fluence rate measured was 1.5-3.9 times higher than the primary fluence rate for 630 nm. In general, the fluence rate amplification factor decreased with increasing redness of the tissue and was less for shorter diffusers. Fluence rate variations in time were observed which coincided with patients coughing, movement, and esophageal spasms. These factors combined with inter patient variability of the fluence rate measured appears to justify the routine application of this technique in PDT of BE.

Aminolevulinic Acid↗

Portal dose image prediction for dosimetric treatment verification in radiotherapy. II. An algorithm for wedged beams.

A method is presented for calculation of a two-dimensional function, T(wedge)(x,y), describing the transmission of a wedged photon beam through a patient. This in an extension of the method that we have published for open (nonwedged) fields [Med. Phys. 25, 830-840 (1998)]. Transmission functions for open fields are being used in our clinic for prediction of portal dose images (PDI, i.e., a dose distribution behind the patient in a plane normal to the beam axis), which are compared with PDIs measured with an electronic portal imaging device (EPID). The calculations are based on the planning CT scan of the patient and on the irradiation geometry as determined in the treatment planning process. Input data for the developed algorithm for wedged beams are derived from (the already available) measured input data set for transmission prediction in open beams, which is extended with only a limited set of measurements in the wedged beam. The method has been tested for a PDI plane at 160 cm from the focus, in agreement with the applied focus-to-detector distance of our fluoroscopic EPIDs. For low and high energy photon beams (6 and 23 MV) good agreement (approximately 1%) has been found between calculated and measured transmissions for a slab and a thorax phantom.

Algorithms↗

Fast and accurate leaf verification for dynamic multileaf collimation using an electronic portal imaging device.

A prerequisite for accurate dose delivery of IMRT profiles produced with dynamic multileaf collimation (DMLC) is highly accurate leaf positioning. In our institution, leaf verification for DMLC was initially done with film and ionization chamber. To overcome the limitations of these methods, a fast, accurate and two-dimensional method for daily leaf verification, using our CCD-camera based electronic portal imaging device (EPID), has been developed. This method is based on a flat field produced with a 0.5 cm wide sliding gap for each leaf pair. Deviations in gap widths are detected as deviations in gray scale value profiles derived from the EPID images, and not by directly assessing leaf positions in the images. Dedicated software was developed to reduce the noise level in the low signal images produced with the narrow gaps. The accuracy of this quality assurance procedure was tested by introducing known leaf position errors. It was shown that errors in leaf gap as small as 0.01-0.02 cm could be detected, which is certainly adequate to guarantee accurate dose delivery of DMLC treatments, even for strongly modulated beam profiles. Using this method, it was demonstrated that both short and long term reproducibility in leaf positioning were within 0.01 cm (1sigma) for all gantry angles, and that the effect of gravity was negligible.

Calibration↗