PubMed Health⌕ Search

Biomedical subjects

Kazumasa Okamoto

Publications and source records attributed to Kazumasa Okamoto.

2 recordsLinked to original sources

Formation of trimer and dimer radical cations of methyl-substituted benzenes in gamma-irradiated low-temperature matrices.

Dimer and trimer radical cations of benzene, toluene, and xylenes were produced selectively after gamma-irradiation in low-temperature 2-methylpentane matrices with electron scavengers: oxygen (O(2)) and sec-butyl chloride (sec-BuCl). The charge resonance (CR) band of the trimer radical cation (M(3)(+)) produced via the corresponding dimer radical cation (M(2)(+)) is clearly seen in the solution containing O(2) as the temperature increases over a range from 80 to 90 K. In o-xylene solution, a fairly strong and distinct M(3)(+) CR absorption is observed; this is due to the large M(3)(+)/M(2)(+) relative extinction coefficient. All benzene derivatives show an equilibrium between dimer and trimer radical cations at approximately 90 K; however, the equilibrium constants of toluene and the xylenes are considerably lower than that of benzene. Formation of the trimer radical cation is inhibited in sec-BuCl, which has commonly been used as a low-temperature optical matrix for producing cationic species. An ab initio DFT method is applied to predict the geometry of M(3)(+), giving "slipped sandwich" (for benzene, m-xylene, and p-xylene) and "slipped fan-shaped" (toluene and o-xylene) structures as the most plausible geometries. The experimentally observed spectroscopic parameters reflect well those predicted by TD-DFT calculation based on geometry, suggesting strong dependence of the geometry of M(3)(+) on substitution patterns. This is the first report not only of direct spectroscopic observation of aromatic trimer radical cations in the condensed phase but also on the quantitative analysis of their equilibria.

Journal Article↗

Requirements for laser-induced desorption/ionization on submicrometer structures.

Laser-induced and matrix-free desorption/ionization on various submicrometer structures was investigated. First, to examine the effect of surface roughness on ionization, a silicon wafer or stainless steel was scratched with sandpaper. The fluences of a 337-nm nitrogen laser, required for ionization of synthetic polymers and reserpine, were markedly reduced on the scratched stainless steel or silicon as compared to the corresponding untreated surface. Next, arrays of submicrometer grooves, which had been lithographically fabricated on a silicon wafer, yielded protonated angiotensin, and the morphologic orientation demonstrated the positive relation between the laser and groove directions for promoting ionization. The fabricated structure also suggested the submicrometer, but not smaller, or nanometer, structures to be a key factor in direct desorption/ionization on rough surfaces. Finally, submicrometer porous structures of alumina or polyethylene yielded intense molecular ion signals of angiotensin and insulin, in response to direct UV irradiation, when the surface was coated with Au or Pt. The coating provided the additional advantage of prolonged activity for a porous alumina chip, exceeding a month even when the chip was left in the open air. These results indicate that laser-induced desorption/ionization of organic compounds can be implemented on submicrometer structures with an Au- or Pt-coated surface irrespective of the basal materials.

Adsorption↗