PubMed Health⌕ Search

Biomedical subjects

Khanh Kieu

Publications and source records attributed to Khanh Kieu.

4 recordsLinked to original sources

Fiber laser using a microsphere resonator as a feedback element.

We show that a glass microsphere resonator can be used as a wavelength-selective mirror in fiber lasers. Due to their high quality factor (Q approximately 10(8)), microsphere resonators possess a narrow reflection bandwidth. This feature enables construction of single-frequency fiber lasers even when the laser cavity is long. Nonlinear effects (such as stimulated Raman lasing) were also observed in our setup at relatively low pump powers.

Journal Article↗

Active Q switching of a fiber laser with a microsphere resonator.

We propose and demonstrate an active Q-switched fiber laser using a high-Q microsphere resonator as the Q-switching element. The laser cavity consists of an Er-doped fiber as the gain medium, a glass microsphere reflector (coupled through a fiber taper) at one end of the cavity, and a fiber Bragg grating reflector at the other end. The reflectivity of the microsphere is modulated by changing the gap between the microsphere and the fiber taper. Active Q switching is realized by oscillating the microsphere in and out of contact with the taper. Using this novel technique, we have obtained giant pulses (maximum peak power approximately 102 W, duration approximately 160 ns) at a low pump-power threshold (approximately 3 mW).

Journal Article↗

Investigation of crystallization and amorphization dynamics of phase-change thin films by subnanosecond laser pulses.

We report experimental results on amorphization and crystallization dynamics of reversible phase-change (PC) thin-film samples, GeSbTe and GeBiTe, for optical disk data storage. The investigation was conducted with subnanosecond laser pulses using a pump-and-probe configuration. Amorphization of the crystalline films could be achieved with a single subnanosecond laser pulse; the amorphization dynamics follow closely the temperature kinetics induced in the irradiated spot. As for crystallization of the samples initially in the amorphous state, a single subnanosecond pulse was found to be insufficient to fully crystallize the irradiated spot, but we could crystallize the PC film (in the area under the focused spot) by applying multiple short pulses. Our multipulse studies reveal that the GeSbTe crystallization is dominated by the growth of nuclei whose initial formation is slow but, once formed, their subsequent growth (under a sequence of subnanosecond pulses) happens quickly. In the case of GeBiTe samples, the crystalline nuclei appear to be present in the material initially, as they grow immediately upon illumination with laser pulses. Whereas our amorphous GeSbTe samples required approximately 200 pulses for full crystallization, for the GeBiTe samples approximately 15 pulses sufficed.

Journal Article↗

Tuning of fiber lasers by use of a single-mode biconic fiber taper.

We report a novel scheme to build a compact, tunable fiber laser. The tuning mechanism is based on the transmission property of a single-mode biconic fiber taper. While pulling the taper, we observe oscillations in the transmitted optical power that are due primarily to interference between a pair of excited modes within the tapered region, which are eventually coupled into the unstretched single-mode fiber at the end of the taper. A similar mechanism causes the modulation of the transmitted optical spectrum after the taper has been pulled and stabilized. It is this spectral modulation by the taper that is exploited here to control the wavelength of a fiber laser. The modulation can be adjusted by stretching the taper, thus enabling the tuning of the laser wavelength. We have built a 32 mW Er-doped tunable ring fiber laser with a continuous tuning range of over 20 nm and a signal-to-noise ratio of better than 45 dB over the entire tuning range; our output power is limited only by the available pump power.

Journal Article↗