PubMed Health⌕ Search

Biomedical subjects

Kiho Kang

Publications and source records attributed to Kiho Kang.

6 recordsLinked to original sources
PubMed2006

Comparison of temperature increase in the pulp chamber during the polymerization of materials used for the direct fabrication of provisional restorations.

STATEMENT OF PROBLEM: Polymerization of resin materials used for the fabrication of provisional restorations is associated with an exothermic reaction. This temperature rise may present a serious biological problem, since it can cause iatrogenic thermal trauma to the pulp. PURPOSE: This in vitro study compared the temperature increase in the pulp chamber of a molar placed in contact with different resins used for the direct fabrication of provisional restorations. MATERIAL AND METHODS: Polymethyl methacrylate (Jet), polyethyl methacrylate (Snap), polyvinylethyl methacrylate (Trim), Bis-acrylic composite (Protemp II), and a VLP urethane dimethacrylate (Revotec LC) were compared with respect to their exothermic reaction properties during polymerization. A mandibular molar prepared for a complete coverage restoration was placed in an acrylic resin block. A thermal probe connected to a digital thermometer was placed into the pulp chamber. Specimens were submerged in a water bath to simulate intraoral conditions. The provisional resin materials tested were measured and mixed according to manufacturer's instructions. The resin mixture was placed into a vacuum-formed acetate template and was then positioned on the prepared molar tooth. The temperature was recorded during polymerization at 30-second intervals until it was evident that the peak temperature had been reached. Temperature increase was measured ( degrees C) for both the initial crown fabrication and the reline procedures. Data were analyzed with descriptive statistics, 1-way analysis of variance, and Tukey Honestly Significant Difference tests (alpha=.05). RESULTS: One-way ANOVA revealed significant differences (F=57.010, P<.0001) in temperature rise for different provisional resin materials. Mean temperature increase for the provisional crown fabrication ranged from 37.76 degrees C for the polyvinylethyl methacrylate to 39.40 degrees C for the polymethyl methacrylate. Mean temperature rise for the reline procedures ranged from 36.80 degrees C for the polyvinylethyl methacrylate to 37.69 degrees C for the polymethyl methacrylate. All of the tested materials produced an exothermic chemical reaction. CONCLUSIONS: Polymethyl methacrylate produced the higher exothermic reaction in both initial crown fabrication and reline procedures. Polyethyl methacrylate, polyvinylethyl methacrylate, and Bis-acrylic resins tested were not significantly different from each other.

Acrylic Resins↗
PubMed2006

Attachment systems for implant retained overdentures: a literature review.

This article presents a comparison between different attachment systems used to retain and support maxillary and mandibular overdentures in completely edentulous patients. A literature review based on a MEDLINE search limited to English-language articles published from 1988 to the present was performed, and a large number of attachments available in the dental market were reviewed with regard to several factors, including: (1) implant survival rate, (2) marginal bone loss, (3) soft tissue complications, (4) retention, (5) stress distribution, (6) space requirements, (7) maintenance complications, and (8) patient satisfaction. These factors are considered essential for the successful outcome and good long-term prognosis of the prostheses. Selection criteria previously published in the literature are discussed as well. Product names and manufacturers are mentioned only if related to attachment systems, as they are cited in the original articles.

Alveolar Bone Loss↗
PubMed2003

Penile apoptosis in association with p53 under lack of testosterone.

It is known that testosterone deficiency induces apoptosis in the prostate and that p53 protein is involved in this apoptosis. Therefore, p53 protein may also be involved in apoptosis induction in a testosterone-deficient state in the penis. In this study, we investigated whether castration and chemical castration induce apoptosis at penile tissue in rats, and whether p53 protein is involved in this apoptosis. Male SD rats aged 8 weeks were divided into four groups: 1) the Control group; 2) the Castration group; 3) the Estrogen group, in which rats received betaestradiol 17-(beta-D-glucuronide) injection of 500 microg/body/day; and 4) the LH-RH group, in which rats received LH-RH analogue (leuprorelin acetate) injection of 2 mg/kg. The rats were sacrificed after treatment on days 1, 3, 5, 14, and 28 by cervical dislocation. Apoptotic cells and p53 protein-positive cells were observed on the 5th day after treatment and thereafter in all castration, estrogen, and LH-RH groups. These findings showed that both castration and chemical castration induced p53 protein in vascular endothelial cells in the corpus cavernosus during the process of losing testosterone. It was also suggested that in such states, apoptosis is induced in vascular endotherial cells in the corpus cavernosus.

Animals↗