Biomedical subjects
Publications and source records attributed to L B de Simon.
The flow behavior of five elastomeric impression materials was determined by extrusion viscometry. Initial viscosity ranged from 400 to 5,100 poise at a shear rate of 2.2 reciprocal seconds. All of the elastomers showed initial non-Newtonian behavior and increased viscosity with time.
Explore the source record for details and available documents.
Stress relaxation of four temporary restoratives was studied. In the vicinity of ambient mouth temperature, the relaxation characteristics of an unmodified zinc oxide-eugenol cement were more favorable than those of IRM and Cavit. The plastic behavior of gutta-percha temporary stopping precluded assessment of its relaxation at temperatures in excess of 22 degrees C.
Short-term stress relaxation of four dental amalgam alloys was studied. Test materials included two conventional lathe-cut restoratives, a spherical alloy, and a dispersed phase product. Specimens were 24-hr-old 4 X 8-mm cylinders. The specimens were compressed and held at constant strain on development of a stress (So) of 28 MN/m2. Subsequent stress relaxation (Dt) was recorded for 60 sec. Data were obtained at eight nominal temperatures between 0 and 55 degrees C. Over the experimental temperature range, fractional stress losses at 60 sec (Dt/So/60) for specimens made from lathe-cut alloys increased from 10% to 58%. The spherical material and the dispersed phase alloy showed fractional stress losses (Dt/So/60) ranging from 9% to 47% and 9% to 31%, respectively. It would appear that particle morphology and alloy composition affect stress-relaxation behavior of dental amalgam. Stress decay patterns enhance significantly the mechanical characterization of amalgam alloys.
The rheologic properties of seven endodontic sealers were investigated with a rotational viscometer. The effects of time and rate of shear on the measured viscosities were determined. Results indicated that one material exhibited Newtonian behavior, whereas the others were characterized by pseudoplasticity.
The effect of ultrasonic instrumentation on the retention of cemented cast restorations was studied. Forces required to dislodge castings from specimen assemblies subjected to ultrasonic vibrations did not differ significantly from those required to cause failure of noninstrumented specimens. The results indicate that clinical application of the ultrasonic device would not affect adversely the retention of properly cemented and well fitting cast restorations.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.