Biomedical subjects

L Kreplak

Publications and source records attributed to L Kreplak.

10 recordsLinked to original sources

PubMed2006

Exploring the mechanical properties of single vimentin intermediate filaments by atomic force microscopy.

Intermediate filaments (IFs), together with actin filaments and microtubules, compose the cytoskeleton. Among other functions, IFs impart mechanical stability to cells when exposed to mechanical stress and act as a support when the other cytoskeletal filaments cannot keep the structural integrity of the cells. Here we present a study on the bending properties of single vimentin IFs in which we used an atomic force microscopy (AFM) tip to elastically deform single filaments hanging over a porous membrane. We obtained a value for the bending modulus of non-stabilized IFs between 300 MPa and 400 MPa. Our results together with previous ones suggest that IFs present axial sliding between their constitutive building blocks and therefore have a bending modulus that depends on the filament length. Measurements of glutaraldehyde-stabilized filaments were also performed to reduce the axial sliding between subunits and therefore provide a lower limit estimate of the Young's modulus of the filaments. The results show an increment of two to three times in the bending modulus for the stabilized IFs with respect to the non-stabilized ones, suggesting that the Young's modulus of vimentin IFs should be around 900 MPa or higher.

Aluminum Oxide↗

PubMed2005

Exploring the mechanical behavior of single intermediate filaments.

Intermediate filaments (IFs) are structural elements of eukaryotic cells with distinct mechanical properties. Tissue integrity is severely impaired, in particular in skin and muscle, when IFs are either absent or malfunctioning due to mutations. Our knowledge on the mechanical properties of IFs is mainly based on tensile testing of macroscopic fibers and on the rheology of IF networks. At the single filament level, the only piece of data available is a measure of the persistence length of vimentin IFs. Here, we have employed an atomic force microscopy (AFM) based protocol to directly probe the mechanical properties of single cytoplasmic IFs when adsorbed to a solid support in physiological buffer environment. Three IF types were studied in vitro: recombinant murine desmin, recombinant human keratin K5/K14 and neurofilaments isolated from rat brains, which are composed of the neurofilament triplet proteins NF-L, NF-M and NF-H. Depending on the experimental conditions, the AFM tip was used to laterally displace or to stretch single IFs on the support they had been adsorbed to. Upon applying force, IFs were stretched on average 2.6-fold. The maximum stretching that we encountered was 3.6-fold. A large reduction of the apparent filament diameter was observed concomitantly. The observed mechanical properties therefore suggest that IFs may indeed function as mechanical shock absorbers in vivo.

Animals↗

PubMed2005

Investigation of the morphology of intermediate filaments adsorbed to different solid supports.

Morphologically, glutaraldehyde-fixed and -dried intermediate filaments (IFs) appear flexible, and with a width of 8-12 nm when observed by electron microscopy. Sometimes, the filaments are even unraveled on the carbon-coated grid and reveal a protofilamentous architecture. In this study, we have used atomic force microscopy to further investigate the morphology of IFs in a more physiological environment. First, we have imaged hydrated glutaraldehyde-fixed IFs adsorbed to a graphite support. In such conditions, human vimentin and desmin IFs appeared compact with a height of 5-8 nm and revealed either a beading repeat or a helical morphology. Second, we have analyzed the architecture of hydrated vimentin, desmin, and neurofilament IFs adsorbed to mica, graphite, and hydrophilic glass without the presence of fixative. On mica, vimentin IFs had a height of only 3-5 nm, whereas desmin IFs appeared as 8-10 nm height filaments with a helical twist. Neurofilaments were 10-12 nm in height with a pronounced 30-50 nm beading along their length. On graphite, the different IFs were either not adsorbing properly or their architecture was modified yielding, for example, broad, flattened filaments. Finally, hydrophilic glass was the surface which seemed to best preserve the architecture of the three IFs, even if, in some cases, unraveled vimentin filaments were observed on this support. These results are straightening the idea that mature IFs are dynamic polymers in vitro and that IFs can be distinguished from each others by their physicochemical properties.

Adsorption↗

PubMed2004

Atomic force microscopy reveals defects within mica supported lipid bilayers induced by the amyloidogenic human amylin peptide.

To date, over 20 peptides or proteins have been identified that can form amyloid fibrils in the body and are thought to cause disease. The mechanism by which amyloid peptides cause the cytotoxicity observed and disease is not understood. However, one of the major hypotheses is that amyloid peptides cause membrane perturbation. Hence, we have studied the interaction between lipid bilayers and the 37 amino acid residue polypeptide amylin, which is the primary constituent of the pancreatic amyloid associated with type 2 diabetes. Using a dye release assay we confirmed that the amyloidogenic human amylin peptide causes membrane disruption; however, time-lapse atomic force microscopy revealed that this did not occur by the formation of defined pores. On the contrary, the peptide induced the formation of small defects spreading over the lipid surface. We also found that rat amylin, which has 84% identity with human amylin but cannot form amyloid fibrils, could also induce similar lesions to supported lipid bilayers. The effect, however, for rat amylin but not human amylin, was inhibited under high ionic conditions. These data provide an alternative theory to pore formation, and how amyloid peptides may cause membrane disruption and possibly cytotoxicity.

Aluminum Silicates↗

PubMed2004

Assessing the flexibility of intermediate filaments by atomic force microscopy.

Eukaryotic cells contain three cytoskeletal filament systems that exhibit very distinct assembly properties, supramolecular architectures, dynamic behaviour and mechanical properties. Microtubules and microfilaments are relatively stiff polar structures whose assembly is modulated by the state of hydrolysis of the bound nucleotide. In contrast, intermediate filaments (IFs) are more flexible apolar structures assembled from a approximately 45 nm long coiled-coil dimer as the elementary building block. The differences in flexibility that exist among the three filament systems have been described qualitatively by comparing electron micrographs of negatively stained dehydrated filaments and by directly measuring the persistence length of F-actin filaments (approximately 3-10 microm) and microtubules (approximately 1-8 mm) by various physical methods. However, quantitative data on the persistence length of IFs are still missing. Toward this goal, we have carried out atomic force microscopy (AFM) in physiological buffer to characterise the morphology of individual vimentin IFs adsorbed to different solid supports. In addition, we compared these images with those obtained by transmission electron microscopy (TEM) of negatively stained dehydrated filaments. For each support, we could accurately measure the apparent persistence length of the filaments, yielding values ranging between 0.3 microm and 1 microm. Making simple assumptions concerning the adsorption mechanism, we could estimate the persistence length of an IF in a dilute solution to be approximately 1 microm, indicating that the lower measured values reflect constraints induced by the adsorption process of the filaments on the corresponding support. Based on our knowledge of the structural organisation and mechanical properties of IFs, we reason that the lower persistence length of IFs compared to that of F-actin filaments is caused by the presence of flexible linker regions within the coiled-coil dimer and by postulating the occurrence of axial slipping between dimers within IFs.

Actin Cytoskeleton↗

PubMed2004

New aspects of the alpha-helix to beta-sheet transition in stretched hard alpha-keratin fibers.

The putative transformation of alpha-helices into beta-sheets has been studied for more than 50 years in the case of hard alpha-keratin. In a previous study of stretched keratin fibers, we specified the conditions for beta-sheet appearance within horsehair: the formation of beta-sheets requires at least 30% relative humidity. However, this phenomenon was observed in the whole tissue. Then there was no clear chemical identification of the beta-sheets (keratin or matrix proteins) and the exact location of the beta-sheets across the fiber could not be specified. In this study, using wide-angle x-ray scattering and high spatial resolution infrared microspectroscopy, we could determine and characterize the structural elements across hair sections stretched in water, which provides new information about the aforementioned transition. Our results show that the process can be split into three steps: 1), unraveling of the alpha-helical coiled-coil domains, which starts at roughly 5% macroscopic strain; 2), further transformation of the unraveled coiled-coils into beta-sheet structures, which occurs above roughly 20% macroscopic strain; and 3), spatial expanding of the beta-structured zones from the sample center to its periphery.

Animals↗

PubMed2002

A new deformation model of hard alpha-keratin fibers at the nanometer scale: implications for hard alpha-keratin intermediate filament mechanical properties.

The mechanical behavior of human hair fibers is determined by the interactions between keratin proteins structured into microfibrils (hard alpha-keratin intermediate filaments), a protein sulfur-rich matrix (intermediate filaments associated proteins), and water molecules. The structure of the microfibril-matrix assembly has already been fully characterized using electron microscopy and small-angle x-ray scattering on unstressed fibers. However, these results give only a static image of this assembly. To observe and characterize the deformation of the microfibrils and of the matrix, we have carried out time-resolved small-angle x-ray microdiffraction experiments on human hair fibers stretched at 45% relative humidity and in water. Three structural parameters were monitored and quantified: the 6.7-nm meridian arc, which is related to an axial separation between groups of molecules along the microfibrils, the microfibril's radius, and the packing distance between microfibrils. Using a surface lattice model of the microfibril, we have described its deformation as a combination of a sliding process and a molecular stretching process. The radial contraction of the matrix is also emphasized, reinforcing the hydrophilic gel nature hypothesis.

Hair↗

PubMed2001

Investigation of human hair cuticle structure by microdiffraction: direct observation of cell membrane complex swelling.

The cuticle of mammalian hair fibres protects the core of the fibre against physical and chemical stress. The structure and some of the properties of the cuticle have been extensively studied by electron microscopy. However, there is still a need for a less invasive structural probe. For this purpose, microdiffraction experiments have been carried out on human hair samples showing a characteristic small-angle X-ray scattering pattern for the cuticle. This pattern has been assigned to the cell membrane complex (CMC) between each cuticle scale. Using a simple model of the electron density within the CMC, values have been derived for the average thickness of the beta- and delta-layers which are close to those obtained by electron microscopy. In order to illustrate the potentialities of microdiffraction in studying the properties of the cuticle, the effect of water sorption has been monitored. Using the intensity modelling described above, a 10% swelling of the delta-layer's thickness has been observed. This study shows that structural modifications of the CMC by physical or chemical stress can be followed directly on the cuticle of human hair fibres by microdiffraction analysis.

Cell Membrane↗

PubMed2001

Unraveling double stranded alpha-helical coiled coils: an x-ray diffraction study on hard alpha-keratin fibers.

Transformations of proteins secondary and tertiary structures are generally studied in globular proteins in solution. In fibrous proteins, such as hard alpha-keratin, that contain long and well-defined double stranded alpha-helical coiled coil domains, such study can be directly done on the native fibrous tissue. In order to assess the structural behavior of the coiled coil domains under an axial mechanical stress, wide angle x-ray scattering and small angle x-ray scattering experiments have been carried out on stretched horse hair fibers at relative humidity around 30%. Our observations of the three major axial spacings as a function of the applied macroscopic strain have shown two rates. Up to 4% macroscopic strain the coiled coils were slightly distorted but retained their overall conformation. Above 4% the proportion of coiled coil domains progressively decreased. The main and new result of our study is the observation of the transition from alpha-helical coiled coils to disordered chains instead of the alpha-helical coiled coil to beta-sheet transition that occurs in wet fibers.

Animals↗

PubMed2000

Exploring a biological tissue from atomic to macroscopic scale using synchrotron radiation: example of hair.

A combined approach, using synchrotron radiation-based diffraction and infrared microspectrometry, has been used to study the structure and molecular composition of hair samples. These methods allowed us to get an insight at different structural scales into the composition and structure of hair. Firstly, information about the configuration of amino-acid residues was obtained at atomic scale, secondly, a model was presented for the geometry and the packing of the microfibrils at medium scale and finally different structural zones were evidenced by microdiffraction at macroscopic scale. We also showed that the two main components of hair--proteins and lipids--are not evenly distributed within the fiber. In addition, these two components exhibit different structure, depending upon their location. Moreover, diffraction and microdiffraction data indicate that the cuticle zone is mainly composed of lipid granules, whereas the cortex and the medulla zones are composed primarily of alpha-keratin. Infrared microspectroscopy, using an enhanced lateral resolution thanks to synchrotron radiation, indicates, on one hand, that the protein structure between the cuticle and cortex are different, and on the other hand, that the concentration of lipids, inside the medulla, is much higher than everywhere else. This work emphasizes the complementarity between both techniques, and highlights the potentialities they can offer in the case of various other studies in biology.

Hair↗