Biomedical subjects

Lars Hauer Larsen

Publications and source records attributed to Lars Hauer Larsen.

4 recordsLinked to original sources

PubMed2005

Kinetics, diffusional limitation and microscale distribution of chemistry and organisms in a CANON reactor.

In the Completely Autotrophic Nitrogen removal Over Nitrite (CANON) process, aerobic and anaerobic ammonia oxidizing bacteria cooperate to remove ammonia in one oxygen-limited reactor. Kinetic studies, microsensor analysis, and fluorescence in situ hybridization on CANON biomass showed a partial differentiation of processes and organisms within and among aggregates. Under normal oxygen-limited conditions ( approximately 5 microM O2), aerobic ammonia oxidation (nitrification) was restricted to an outer shell (<100 microm) while anaerobic ammonia oxidation (anammox) was found in the central anoxic parts. Larger type aggregates (>500 microm) accounted for 68% of the anammox potential whereas 65% of the nitrification potential was found in the smaller aggregates (<500 microm). Analysis with O2 and NO2- microsensors showed that the thickness of the activity zones varied as a function of bulk O2 and NO2- concentrations and flow rate.

Aerobiosis↗

PubMed2005

Pericellular oxygen depletion during ordinary tissue culturing, measured with oxygen microsensors.

Recent research has found important differences in oxygen tension in proximity to certain mammalian cells when grown in culture. Oxygen has a low diffusion rate through cell culture media, thus, as a result of normal respiration, a decrease in oxygen tension develops close to the cells. Therefore, for the purpose of standardization and optimization, it is important to monitor pericellular oxygen tension and cell oxygen consumption. Here, we describe an integrated oxygen microsensor and recording system that allows measurement of oxygen concentration profiles in vertical transects through a 1.6-mm deep, stagnant, medium layer covering a cell culture. The measurement set-up reveals that, when confluent, a conventional culture of adherent cells, although exposed to the constant oxygen tension of ambient air, may experience pericellular oxygen tensions below the level required to sustain full oxidative metabolism. Depletions reported are even more prominent and potentially aggravating when the cell culture is incubated at reduced oxygen tensions (down to around 4% oxygen). Our results demonstrate that, if the pericellular oxygen tension is not measured, it is impossible to relate in vitro culture results (for example, gene expression to the oxygen tension experienced by the cell), as this concentration may deviate very substantially from the oxygen concentration recorded in the gas phase.

Calibration↗

PubMed2004

Bacterium-based NO2- biosensor for environmental applications.

A sensitive NO2- biosensor that is based on bacterial reduction of NO2- to N2O and subsequent detection of the N2O by a built-in electrochemical N2O sensor was developed. Four different denitrifying organisms lacking NO3- reductase activity were assessed for use in the biosensor. The relevant physiological aspects examined included denitrifying characteristics, growth rate, NO2- tolerance, and temperature and salinity effects on the growth rate. Two organisms were successfully used in the biosensor. The preferred organism was Stenotrophomonas nitritireducens, which is an organism with a denitrifying pathway deficient in both NO3- and N2O reductases. Alternatively Alcaligenes faecalis could be used when acetylene was added to inhibit its N2O reductase. The macroscale biosensors constructed exhibited a linear NO2- response at concentrations up to 1 to 2 mM. The detection limit was around 1 microM NO2-, and the 90% response time was 0.5 to 3 min. The sensor signal was specific for NO2-, and interference was observed only with NH2OH, NO, N2O, and H2S. The sensor signal was affected by changes in temperature and salinity, and calibration had to be performed in a system with a temperature and an ionic strength comparable to those of the medium analyzed. A broad range of water bodies could be analyzed with the biosensor, including freshwater systems, marine systems, and oxic-anoxic wastewaters. The NO2- biosensor was successfully used for long-term online monitoring in wastewater. Microscale versions of the NO2- biosensor were constructed and used to measure NO2- profiles in marine sediment.

Alcaligenes faecalis↗

PubMed2002

Microscale biosensor for measurement of volatile fatty acids in anoxic environments.

A microscale biosensor for acetate, propionate, isobutyrate, and lactate is described. The sensor is based on the bacterial respiration of low-molecular-weight, negatively charged species with a concomitant reduction of NO(-)(3) to N(2)O. A culture of denitrifying bacteria deficient in N(2)O reductase was immobilized in front of the tip of an electrochemical N(2)O microsensor. The bacteria were separated from the outside environment by an ion-permeable membrane and supplied with nutrients (except for electron donors) from a medium reservoir behind the N(2)O sensor. The signal of the sensor, which corresponded to the rate of N(2)O production, was proportional to the supply of the electron donor to the bacterial mass. The selectivity for volatile fatty acids compared to other organic compounds was increased by selectively enhancing the transport of negatively charged compounds into the sensor by electrophoretic migration (electrophoretic sensitivity control). The sensor was susceptible to interference from O(2), N(2)O, NO(2)(-), H(2)S, and NO(-)(3). Interference from NO(-)(3) was low and could be quantified and accounted for. The detection limit was equivalent to about 1 microM acetate, and the 90% response time was 30 to 90 s. The response of the sensor was not affected by changes in pH between 5.5 and 9 and was also unaffected by changes in salinity in the range of 2 to 32 per thousand. The functioning of the sensor over a temperature span of 7 to 30 degrees C was investigated. The concentration range for a linear response was increased five times by increasing the temperature from 7 to 19.5 degrees C. The life span of the biosensor varied between 1 and 3 weeks after manufacturing.

Anaerobiosis↗