Biomedical subjects

Le-Cheng Lei

Publications and source records attributed to Le-Cheng Lei.

5 recordsLinked to original sources

PubMed2006

Study on NO(2) absorption by ascorbic acid and various chemicals.

Study on NO(2) absorption aimed at seeking a better NO(2) absorption chemical at pH 4.5 approximately 7.0 for application to existing wet flue gas desulfurization (FGD). The results from the double-stirred reactor indicated that ascorbic acid has very high absorption rate at this pH range. The rate constant of ascorbic acid reaction with NO(2) (0 approximately 1,000 x 10(-6) mol/mol) is about 3.54 x 10(6) mol/(Ls) at pH 5.4 approximately 6.5 at 55 degrees C.

Absorption↗

PubMed2005

Experimental study on the inhibition of biological reduction of Fe(III)EDTA in NO(x) absorption solution.

Scrubbing of NO(x) from the gas phase with Fe(II)EDTA has been shown to be highly effective. A new biological method can be used to convert NO to N(2) and regenerate the chelating agent Fe(II)EDTA for continuous NO absorption. The core of this biological regeneration is how to effectively simultaneous reduce Fe(III)EDTA and Fe(II)EDTA-NO, two mainly products in the ferrous chelate absorption solution. The biological reduction rate of Fe(III)EDTA plays a main role for the NO(x) removal efficiency. In this paper, a bacterial strain identified as Klebsiella Trevisan sp. was used to demonstrate an inhibition of Fe(III)EDTA reduction in the presence of Fe(II)EDTA-NO. The competitive inhibition experiments indicted that Fe(II)EDTA-NO inhibited not only the growth rate of the iron-reduction bacterial strain but also the Fe(III)EDTA reduction rate. Cell growth rate and Fe(III)EDTA reduction rate decreased with increasing Fe(II)EDTA-NO concentration in the solution.

Adsorption↗

PubMed2004

Synergetic effects for p-nitrophenol abatement using a combined activated carbon adsorption-electrooxidation process.

A novel fluidized electrochemical reactor that integrated advanced electrochemical oxidation with activated carbon (AC) fluidization in a single cell was developed to model pollutant p-nitrophenol (PNP) abatement. AC fluidization could enhance COD removal by 22%-30%. In such a combined process, synergetic effects on PNP and COD removal was found, with their removal rate being enhanced by 137.8% and 97.8%, respectively. AC could be electrochemically regenerated and reused, indicating the combined process would be promising for treatment of biorefractory organic pollutants.

Charcoal↗

PubMed2004

Synthesis of TiO(2) supported on activated carbon by MOCVD: operation parameters study.

The metallo-organic chemical vapor deposition (MOCVD) technique has been applied to the preparation of the photocatalyst titanium dioxide supported on activated carbon. The effects of various condition parameters such as carrier gas flow rate, source temperature and deposition temperature on the deposition rate were investigated. The maximum deposition rate of 8.2 mg/(g x h) was obtained under conditions of carrier gas flow rate of 400 ml/min, source temperature of 423 K and deposition temperature of 913 K. The deposition rate followed Arrhenius behavior at temperature of 753 K to 913 K, corresponding to activation energy E(a) of 51.09 kJ/mol. TiO(2) existed only in anatase phase when the deposition temperature was 773 K to 973 K. With increase of deposition temperature from 1073 K to 1273 K, the rutile content sharply increased from 7% to 70%. It was found that a deposition temperature of 773 K and a higher source temperature of 448 K resulted in finely dispersed TiO(2) particles, which were mainly in the range of 10-20 nm.

Adsorption↗

PubMed2003

Photochemically enhanced degradation of phenol using heterogeneous Fenton-type catalysts.

The degradation of phenol was carried out using heterogeneous Fenton-type catalysts in the presence of H2O2 and UV. Catalysts were prepared by exchanging and immobilizing Fe2+ in zeolite 13X, silica gel or Al2O3. The concentration of phenol solution was 100 mg/L. The amount of H2O2 added was the stoichiometric amount of H2O2 required for the total oxidation of phenol. Under the irradiation of medium pressure light (300 W) phenol was mineralized within 1 h in the presence of Fe2+/zeolite 13X. The COD removal rate was enhanced in the presence of Fe2+/zeolite 13X compared to that of Fe2+/silica gel or Fe2+/Al2O3. Analogous homogenous photo-Fenton reaction with equivalent Fe2+ was also carried out to evaluate the catalysis efficiency of Fe2+/zeolite 13X. Results showed that the COD removal rate was near to that of homogeneous Fenton, while heterogeneous Fe2+/zeolite 13X catalyst could be recycled.

Catalysis↗