PubMed Health⌕ Search

Biomedical subjects

Liquan Chen

Publications and source records attributed to Liquan Chen.

13 recordsLinked to original sources

Direct Modeling of the Interfacial Resistance in All-Solid-State Battery.

Interfacial reconstruction and its associated high resistance govern the performance of all-solid-state batteries (ASSBs). However, indirectly inferring interfacial potentials from bulk band alignments masks the true solid-solid electrochemistry, causing orders-of-magnitude discrepancies in predicting space-charge layer (SCL) resistances and impeding interface screening. Herein, by traversing 310 distinct interfaces from &#x223c;29,000 literatures, we develop a non-empirical numerical procedure that directly maps lithium&#x2011;ion redistribution to interfacial resistance by integrating ligand&#x2011;field theory with the SCL model. Considering electric potential differences and intrinsic carrier properties during interfacial reconstruction via a modified ligand-field splitting strength (MLFSS) descriptor yields unprecedented bridging between modeling and measurement, reducing predicted resistance discrepancies from over ten orders of magnitude to within two. On this basis, we resolve the highly system-dependent controversy over oxide interfacial resistances by identifying extreme MLFSS disparities (>3.5&#xa0;eV) as the decisive factor, while emphasizing ion&#x2011;intercalation sulfides (<0.2&#xa0;eV) as cathodes for their intrinsic SCL suppression. The predictive capability of this tunable criterion is validated in an all-sulfide V0.5Cr1.5S4/Li10GeP2S12/75% Li2S-24% P2S5-1% P2O5/Li prototype. The resulting ultralow interfacial resistance of 8.8 &#x3a9; cm2 ensures superior cycling stability at an active-material energy density of 562&#xa0;Wh kg-1, establishing a practical paradigm for breaking the energy and kinetics trade-off in ASSBs.

all&#x2010;solid&#x2010;state battery↗

Mesoscale organization of nearly monodisperse flowerlike ceria microspheres.

Nearly monodisperse flowerlike CeO2 microspheres were synthesized via a simultaneous polymerization-precipitate reaction, metamorphic reconstruction, and mineralization under hydrothermal condition as well as subsequent calcination. The obtained CeO2 microsphere consists of 20-30 nm thick nanosheets as petals. It has an open three-dimensional (3D) porous and hollow structure and possesses high surface area, large pore volume, and marked hydrothermal stability. It can be doped easily after synthesis, and the initial 3D texture is maintained. The controlling factors and a possible formation mechanism are discussed in detail. This novel material can be used as a support for catalysts with various purposes. With CuO loaded on flowerlike CeO2, the catalytic activities and hydrothermal stability of Cu/CeO2 for ethanol stream reforming were examined. At 300 degrees C, the H2 selectivity reached a maximum value of 74.9 mol %, while CO was not detected within the precision of the gas chromatogram. It produced a hydrogen-rich gas mixture in the wide temperature range (300-500 degrees C) and showed excellent hydrothermal stability at high temperature (550 degrees C), which is a good choice for ethanol processors for hydrogen fuel cell applications.

Journal Article↗

Cheap and environmentally benign electrochemical energy storage and conversion devices based on AlI3 electrolytes.

Cheap and environmentally benign electrochemical energy conversion and storage devices, including a dye-sensitized solar cell (DSSC) using an AlI3-ethanol electrolyte and a new Al/I2 primary battery, are reported. The AlI3-ethanol electrolyte can be prepared simply by adding aluminum powder and iodine into ethanol at ambient conditions. The DSSC using this AlI3-ethanol electrolyte achieved an energy conversion efficiency of 5.9% at AM 1.5 (100 mW/cm-2). In the Al/I2 battery, AlI3 is formed spontaneously when aluminum and iodine electrodes are brought into contact at room temperature. Then I- anions transport across the AlI3 solid electrolyte for further electrochemical reactions.

Journal Article↗

Li-biphenyl-1,2-dimethoxyethane solution: calculation and its application.

Metallic lithium reacts with biphenyl in 1,2-dimethoxyethane (DME) solvent at room temperature. This reaction has been studied using density functional theory (DFT) at the B3LYP level together with the 6-311++G (d,p) basis set. From the energy results of the corresponding optimized geometries for intermediate complexes, the reaction can be interpreted as a charge-transfer process between lithium and biphenyl followed by Li+ coordination with ether oxygens in DME. In addition, the experimentally observed vibrational bands can be unambiguously assigned and interpreted according to the normal modes calculated for the biphenyl-Li-DME complex. This organic complex solution has been demonstrated as a very effective chemical lithiation agent. V2O5 can be lithiated up to 1.45 lithium ions per formula. The lithiated V2O5 shows a high Li-extraction capacity of 173 mAh/g as cathode material for lithium ion batteries.

Journal Article↗

A spontaneous combustion reaction for synthesizing Pt hollow capsules using colloidal carbon spheres as templates.

Here we report a spontaneous combustion reaction in synthesizing Pt hollow capsules. In brief, Pt nanoparticles were loaded on the surface of colloidal carbon spheres by wet-chemical impregnation. When Pt-loaded carbon spheres were taken out of an argon-filled tube furnace at room temperature and exposed to air, they underwent spontaneous combustion. The internal carbon spheres templates were removed to leave nanostructured Pt hollow capsules. There are at least two critical conditions for the occurrence of the spontaneous combustion: the Pt particle size is below 5.8 nm, and the hydrogen content in the carbon spheres is above 2.570 wt %. Such a reaction is interesting for the preparation of metal hollow spheres and is also relevant with respect to removal of accumulated carbon on catalysts and for soot oxidation at room temperature.

Journal Article↗

Effect of iodine addition on solid-state electrolyte LiI/3-hydroxypropionitrile (1:4) for dye-sensitized solar cells.

It was observed that the ionic conductivity of the solid-state electrolyte LiI/3-hydroxypropionitrile (HPN) = 1:4 (molar ratio) decreased dramatically with increasing iodine (I(2)) concentration, which differs from the conduction behavior of the Grotthuss transport mechanism observed in liquid or gel electrolytes. The short-circuit photocurrent density (J(sc)) of the dye-sensitized solar cell (DSSC) based on this electrolyte system increases with increasing I(2) concentration until LiI/I(2) is 1:0.05 (molar ratio). Beyond this limitation, the J(sc) decreases. At low I(2) concentrations (I(2)/LiI < or = 0.05), the J(sc) is mainly affected by the diffusion of I(3)(-). An increase of the I(2) concentration leads to the enhancement of the diffusion of I(3)(-) and an increase of the J(sc). At high I(2) concentrations (I(2)/LiI > 0.05), the factors, including the increased light absorption by the I(3)(-), the increased recombination of electrons at the photoanode with I(3)(-), and the reduced ionic conductivity of the electrolyte, lead to a decrease of J(sc). At the same time, the open-circuit voltage (V(oc)) of the DSSC decreases monotonically with the ratio of I(2)/LiI due to increased dark current in the DSSC. The increased absorption of visible light by the electrolyte, the enhanced dark current, and the reduced ionic conductivity of the electrolyte contribute to the performance variation of the corresponding solid-state DSSC with increasing I(2) concentration.

Journal Article↗

Influences of permeation of vanadium ions through PVDF-g-PSSA membranes on performances of vanadium redox flow batteries.

The preparation and physical characterization of a poly(vinylidene fluoride)-graft-poly(styrene sulfonic acid) (PVDF-g-PSSA) membrane prepared by a solution-grafting method were described. These membranes exhibited high conductivity with a value 3.22 x 10(-2) S/cm at 30 degrees C. ICP studies revealed that the PVDF-g-PSSA membrane showed dramatically lower vanadium ion permeability compared to Nafion 117. Trivalent vanadium ions had the highest permeability through all these membranes in contrast to pentavalent vanadium ions with the lowest. The VRB with the low-cost PVDF-g-PSSA membrane exhibited a higher performance than that with Nafion 117 under the same operating conditions, and its energy efficiency reached 75.8% at 30 mA/cm(2). The performance of VRB with the PVDF-g-PSSA membrane can be maintained after more than 200 cycles at a current density of 60 mA/cm(2).

Journal Article↗

Solid-state composite electrolyte LiI/3-hydroxypropionitrile/SiO2 for dye-sensitized solar cells.

A new compound, LiI(3-hydroxypropionitrile)(2), is reported here. According to its single-crystal structure (C2/c), this compound has 3-D transporting paths for iodine. Further ab initio calculation shows that the activation energy for diffusion of iodine (0.73 eV) is much lower than that of lithium ion (8.39 eV) within the lattice. Such a mono-ion transport feature is favorable as solid electrolyte to replace conventional volatile organic liquid electrolytes used in dye-sensitized solar cells (DSSC). LiI and 3-hydroxypropionitrile (HPN) can form a series of solid electrolytes. The highest ambient conductivity is 1.4 x 10(-)(3) S/cm achieved for LiI(HPN)(4). However, it tends to form large crystallites and leads to poor filling and contact within porous TiO(2) electrodes in DSSC. Such a drawback can be greatly improved by introducing micrometer-sized and nanosized SiO(2) particles into the solid electrolyte. It is helpful not only in enhancing the conductivity but also in improving the interfacial contact greatly. Consequently, the light-to-electricity conversion efficiency of 5.4% of a DSSC using LiI(HPN)(4)/15 wt % nano-SiO(2) was achieved under AM 1.5 simulated solar light illumination. Due to the low cost, easy fabrication, and relatively high conversion efficiency, the DSSC based on this new solid-state composite electrolyte is promising for practical applications.

Journal Article↗

Spectroscopic studies on the cation-anion, cation-solvent and anion-solvent interactions in the LiCF3SO3/acetamide complex system.

A molten salt electrolyte composed of lithium triflate (LiCF3SO3) and acetamide (CH3CONH2) has been prepared and characterized by Raman, IR spectroscopy and ac impedance. It is found that acetamide molecule not only complexes with the Li+ cation but also interacts with the CF3SO3- anion via hydrogen bonding due to its two polar groups (C=O group and NH2 group) capable of coordinating with cations and anions, respectively. Cation-anion interaction is strengthened while cation-solvent and anion-solvent interactions are weakened with the increases of salt concentration and temperature in the LiCF3SO3/acetamide complex. The ionic conductivities of the LiCF3SO3/acetamide complex with different molar ratios depend strongly on the ionic association in the complex system.

Acetamides↗

Spectroscopic and DFT studies to understand the liquid formation mechanism in the LiTFSI/acetamide complex system.

It is interesting that although both lithium bis(trifluoromethane sulfone) imide (LiN(SO2CF3)2, LiTFSI) and acetamide (CH3CONH2) are solid, their mixture is a liquid in an appropriate molar ratio range at room temperature. The liquid formation mechanism of the LiTFSI/acetamide complex has been investigated by FT-IR and FT-Raman spectroscopy. The spectroscopic studies show that the Li+ ions coordinate with the C=O group of acetamide whereas the SO2 group in TFSI- anions interacts with the NH2 group of acetamide via hydrogen bonding. These interactions lead to the breakage of the hydrogen bonds between acetamide molecules and to the dissociation of LiTFSI, resulting in the formation of this molten salt. Furthermore, it has been found that moderate interaction between LiX and RCONH2 (R = -NH2, -CH3 and -CF3) is favorable for forming a LiX/RCONH2 molten salt system with low eutectic temperature and high conductivity based on density functional theory (DFT) calculational and experimental comparison for different R groups in RCONH2 and different lithium salts.

Acetamides↗