Biomedical subjects

Longtu Li

Publications and source records attributed to Longtu Li.

3 recordsLinked to original sources

PubMed2006

A disk-pivot structure micro piezoelectric actuator using vibration mode B11.

Micro piezoelectric actuator using vibration mode B(11) (B(mn), where m is the number of nodal circles, n is the nodal diameters) is designed. Different from conventional wobble-type ultrasonic motor using piezoelectric rod or cylinder, piezoelectric disc is used to excite wobble modes and metal cylinder stator is used to amplify the transverse displacement, metal rod rotor is actuated to rotate. The outer diameter of the actuator is 14mm. There are features such as low drive voltage, micromation, and convenient control of wobble state by modifying the structure of stator, etc. Finite element analysis (FEA) of the stator has been made. It is found that the resonant frequency of vibration mode B(11) is 49.03kHz, which is measured at 45.7kHz by the laser vibrometer and impedance analyzer. The rotation speed has been measured, which could be as high as 10,071rpm under an alternating current 100V. Such piezoelectric actuator can be optimized and adjusted to fit practical conditions. It can be applied in the fields of precise instrument, bioengineering and other micro actuator system.

Journal Article↗

PubMed2006

Simulations and analysis of a piezoelectric micropump.

A number of micropumps have been proposed in the last few years based on different actuating principles and fabricated by different technologies. However, many of those micropumps have been designed taking into account primarily available microfabrication technologies rather than appropriate pump performance analysis. In fact, not all papers are available in the literature presenting theoretical models usable to describe the functioning and predict the performance of those micropumps. In this paper, we present a new micropump model and FEA method suitable for guiding the design and predicting the performance of a micropump actuated by a piezoelectric actuator. The model takes into account the influence of piezoelectric transducer and pump geometry. Simulations have been performed and compared with results of experiments on a prototype micropump fabricated in our laboratory.

Journal Article↗

PubMed2004

High resolution miniaturized stepper ultrasonic motor using differential composite motion.

Experiments show that there is a limited minimum stepped angle in ultrasonic motors (USM). The research on the minimum angle of stepper USM with 15 mm in diameter and wobbling mode is being carried out. This paper presents a novel way to decrease the minimum stepped angle of USM based on the principle of differential composite motion (DCM), i.e. clockwise and counterclockwise rotation. The prototype was fabricated and experiments proved that this method is useful and also keeps a high torque for a large stepped angle. The stator of the prototype is steel, and rotor is fiberglass, antifriction material or steel. The prototype can operate well over 150 h with a 5 kHz wide frequency band. The minimum stepped angle is 46" using a coventional method while 12" using DCM method proposed in this paper.

Electric Power Supplies↗