Biomedical subjects

Loreto Lunar

Publications and source records attributed to Loreto Lunar.

6 recordsLinked to original sources

PubMed2006

Analysis of linear alkylbenzene sulfonate homologues in environmental water samples by mixed admicelle-based extraction and liquid chromatography/mass spectrometry.

Hemimicelles and admicelles of cetyltrimethylammonium bromide (CTAB) and cetylpyridinium chloride (CPC), adsorbed onto silica, were tested as sorbents for the solid phase extraction (SPE) of linear alkylbenzene sulfonate (LAS) homologues from environmental water samples. LASs were quantitatively retained on both surfactants due to high hydrophobic and ionic interactions, which led to the formation of analyte-extractant mixed aggregates. Parameters affecting the SPE of LASs were optimised. Recoveries of analytes from wastewater influent and effluent and river water samples ranged between 86 and 110%. Combination of SPE with liquid chromatography/mass spectrometry provided detection limits for the different LAS homologues of about 4 ng L(-1). The precision of the method, expressed as relative standard deviation, ranged from 5 to 9%. The method was applied to the analysis of LASs in wastewater and river samples using sample volumes between 10 and 25 mL. The LAS concentrations found ranged from 9 to 503 microg L(-1). No cleaning step was required to get accurate results.

Journal Article↗

PubMed2005

Hemimicelle-based solid-phase extraction of estrogens from environmental water samples.

Hemimicelles and admicelles of sodium dodecyl sulfate (SDS) on alumina and cetyltrimethyl ammonium bromide (CTAB) on silica were evaluated for the concentration and purification of the priority estrogens estrone (E(1)), 17beta-estradiol (E(2)) and ethynylestradiol (EE(2)) from sewage and river samples. Retention was based on analyte-sorbent hydrophobic and cation-pi interactions. Parameters affecting the SPE of estrogens on both types of sorbents were comparatively investigated. Adsolubilization was quantitative for SDS hemimicelles/admicelles and CTAB admicelles. SDS hemimicelle-coated alumina was the sorbent selected on the basis of the lower elution volume required and the higher sample flow rate allowed. Combination of estrogen adsolubilization-based SPE with liquid chromatography-diode array/fluorescence detection permitted the quantification of the target compounds with detection limits ranging from 20 to 100 ng l(-1). The relative standard deviation ranged from 3 to 8%. The approach developed was applied to the determination of estrogens in raw and treated sewage and river samples. The recovery found for estrogens in these environmental matrices was between 85 and 105%.

Adsorption↗

PubMed2004

Differentiation and quantification of linear alkyl benzenesulfonate isomers by liquid chromatography-ion-trap mass spectrometry.

Discrimination and quantitation of the 20 positional isomers of C10-C13 linear alkyl benzenesulfonates (LASs), based on the use of reversed-phase liquid chromatography-electrospray ionisation in negative ion mode ion-trap mass spectrometry, was undertaken. Discrimination was achieved by LAS MS-MS analysis into the ion trap, by monitoring specific fragment ions resulting from the benzylic cleavage of the carbon alkyl chain on both side of the LAS phenyl group. Parameters affecting the electrospray ionisation source and the ion-trap operation were optimised. Calibration curves for the different isomers were established and this permitted their quantitation by mass spectrometry for the first time. MS-MS responses were dependent on both the position of the phenyl group on the alkyl chain and the length of this alkyl chain, these responses being higher for the external isomers and the longer alkyl chain homologues. The precision, expressed as relative standard deviation ranged between 9 and 13%. Detection limits for LAS isomers were between 0.03 and 0.07 mg/l and therefore the method is sensitive enough to be applied to environmental samples.

Benzenesulfonates↗

PubMed2004

Boron deficiency causes accumulation of chlorogenic acid and caffeoyl polyamine conjugates in tobacco leaves.

The effects of boron (B) deficiency on carbohydrate concentrations and the pattern of phenolic compounds were studied in leaves of tobacco plants (Nicotiana tabacum L.). Plants grown under B deficiency showed a notable increase in leaf carbohydrates and total phenolic compounds when compared to controls. The qualitative composition of phenolics was analyzed by HPLC-mass spectrometry. The level of caffeate conjugates (i.e., chlorogenic acid) increased in B-deficient plants. In addition, the accumulation of two caffeic acid amides (N-caffeoylputrescine and putative dicaffeoylspermidine) was observed.

Boron↗

PubMed2002

Identification of the main by-products of the developing agent N-hydroxyethyl-N-ethyl-3-methyl-p-phenylenediamine in photographic effluents by liquid chromatography/mass spectrometry.

N-Hydroxyethyl-N-ethyl-3-methyl-p-phenylenediamine (CD(4)) is commonly used as a developing agent in color photographic processes. The main by-products formed in developer baths used in the process were separated and identified by liquid chromatography/electron ionization mass spectrometry (LC/EI-MS) and liquid chromatography/atmospheric pressure ionization mass spectrometry (LC/API-MS). A number of side reactions, in addition to the main reactions involved in the developing process, were found to occur. Such side reactions involved in the formation of CD(4) by-products included oxidation, hydroxylation, sulfonation and the formation of coupling products. A reaction pathway for the degradation of CD(4) based on the nature of the by-products identified is proposed and discussed.

Environmental Monitoring↗

PubMed2002

H2O2/TiO2 photocatalytic oxidation of metol. Identification of intermediates and reaction pathways.

The applicability of H2O2 to increase the efficiency of TiO2 photocatalytic degradations was investigated. The photographic developer metol [N-methyl-p-aminophenol] that does not adsorb on the surface of TiO2 particulates was used as a model for this purpose. It was proved that metol was mineralised under oxidation with H2O2/TiO2/UV through different thermal and photochemical reactions. Identification of intermediates by both HPLC-electron impact-MS and HPLC-electrospray ionisation-MS helped to elucidate the role of H2O2 and TiO2 in the degradation process and to establish degradation pathways. Intermediates yielded were partially oxygenated aromatic species and dimers, which were amenable to oxidation. The optimal degradation conditions found for mineralisation were 0.4 M H2O2, 5 mg/ml TiO2, pH 9 and irradiation centred at 360 nm (4.9 mW/cm2). The use of oxidants opens an interesting medium to the treatment of effluents containing a diversity of organics since they increase substantially the efficiency of TiO2 photocatalytic degradations.

Aminophenols↗