Biomedical subjects

M A Larotonda

Publications and source records attributed to M A Larotonda.

7 recordsLinked to original sources

PubMed2006

Pulse duration measurements of grazing-incidence-pumped high repetition rate Ni-like Ag and Cd transient soft x-ray lasers.

We have measured the pulse duration of gain-saturated 13.9 nm Ni-like Ag and 13.2 nm Ni-like Cd transient collisional lasers excited by grazing-incidence-pumping for several pumping conditions. High-resolution streak-camera measurements yielded FWHM pulse durations close to 5 ps for both lasers under optimum pumping conditions. The very high brightness and short pulse duration of these new high repetition tabletop soft x-ray lasers make them an attractive source for dynamic applications.

Journal Article↗

PubMed2006

High-brightness injection-seeded soft-x-ray-laser amplifier using a solid target.

We demonstrate the generation of an intense soft-x-ray-laser beam by saturated amplification of high harmonic seed pulses in a dense transient collisional soft-x-ray-laser plasma amplifier created by heating a titanium target. Amplification in the 32.6 nm line of Ne-like Ti generates laser pulses of subpicosecond duration that are measured to approach full spatial coherence. The peak spectral brightness is estimated to be approximately 2 x 10(26) photons/(s mm(2) mrad(2) 0.01% bandwidth). The scheme is scalable to produce extremely bright lasers at very short wavelengths with full temporal and spatial coherence.

Journal Article↗

PubMed2006

Continuous high-repetition-rate operation of collisional soft-x-ray lasers with solid targets.

We have generated a laser average output power of 2 microW at a wavelength of 13.9 nm by operating a tabletop laser-pumped Ni-like Ag laser at a 5 Hz repetition rate, using a solid helicoidal target that is continuously rotated and advanced to renew the target surface between shots. More than 2 x 10(4) soft-x-ray laser shots were obtained by using a single target. Similar results were obtained at 13.2 nm in Ni-like Cd with a Cd-coated target. This scheme will allow uninterrupted operation of laser-pumped tabletop collisional soft-x-ray lasers at a repetition rate of 10 Hz for a period of hours, enabling the generation of continuous high average soft-x-ray powers for applications.

Journal Article↗

PubMed2006

Sub-38 nm resolution tabletop microscopy with 13 nm wavelength laser light.

We have acquired images with a spatial resolution better than 38 nm by using a tabletop microscope that combines 13 nm wavelength light from a high-brightness tabletop laser and Fresnel zone plate optics. These results open a gateway to the development of compact and widely available extreme-ultraviolet imaging tools capable of inspecting samples in a variety of environments with a 15-20 nm spatial resolution and a picosecond time resolution.

Journal Article↗

PubMed2005

Saturated 13.2 nm high-repetition-rate laser in nickellike cadmium.

We report gain-saturated operation of a 13.2 nm table-top laser in Ni-like Cd at a 5 Hz repetition rate. A gain-length product G x L = 17.6 was obtained by heating a precreated plasma with 8 ps duration Ti:sapphire laser pulses with an energy of only 1 J impinging at a grazing angle of 23 degrees. With an average power of approximately 1 muW [corrected] this laser is an attractive coherent source for at-wavelength metrology of extreme UV lithography optics and other applications.

Journal Article↗

PubMed2005

Saturated high-repetition-rate 18.9-nm tabletop laser in nickellike molybdenum.

We report saturated operation of an 18.9-nm laser at 5-Hz repetition rate. An amplification with a gain-length product GL of 15.5 is obtained in the 4d 1S0-4p 1P1 laser line of Ni-like Mo in plasmas heated at grazing incidence with approximately 1-J pulses of 8.1-ps duration from a tabletop laser system. Lasing is obtained over a broad range of time delays and pumping conditions. We also measure a GL of 13.5 in the 22.6-nm transition of the same ion. The results are of interest for numerous applications requiring high-repetition-rate lasers at wavelengths below 20 nm.

Journal Article↗

PubMed2004

Guiding of intense laser beams in highly ionized plasma columns generated by a fast capillary discharge.

We have demonstrated the guiding of laser pulses with peak intensities up to 2.2 x 10(17) W/cm(2) in a 5.5 cm long plasma column containing highly charged Ar ions generated by a fast capillary discharge. A rapid discharge-driven hydrodynamic compression guides progressively lower order modes through a plasma with increasing density and degree of ionization, until the guide collapses on axis. The lowest order mode (FWHM approximately 50 microm) is guided with 75% transmission efficiency shortly before the plasma reaches the conditions for lasing in Ne-like Ar. The subsequent rapid plasma expansion forms a significantly leakier and more absorbent guide.

Journal Article↗