PubMed Health⌕ Search

Biomedical subjects

M Burghammer

Publications and source records attributed to M Burghammer.

8 recordsLinked to original sources

X-ray micro-diffraction analysis of reconstructed bone at Zr prosthetic surface with sub-micrometre spatial resolution.

The purpose of the present investigation is to demonstrate the power of the x-ray micro-diffraction technique in biological studies. In particular the reported experiment concerns the study of the interface between a Zr prosthetic device implanted in a rat femur and the newly-formed bone, with a spatial resolution of 0.5 microm. The obtained results give interesting information on the Zr deformation and on the crystallographic phase, the grain size and the orientation of the new bone. Moreover the study reveals a marked difference in the structure of the reconstructed bone with respect to the native bone, which cannot be appreciated with other techniques.

Animals↗

Two-dimensional x-ray waveguides and point sources.

We show that resonant coupling of synchrotron beams into suitable nanostructures can be used for the generation of coherent x-ray point sources. A two-dimensionally confining x-ray waveguide structure has been fabricated by e-beam lithography. By shining a parallel undulator beam onto the structure, a discrete set of resonant modes can be excited in the dielectric cavity, depending on the two orthogonal coupling angles between the beam and the waveguide interfaces. The resonant excitation of the modes is evidenced from the characteristic set of coupling angles as well as the observed far-field pattern. The x-ray nanostructure may be used as coherent x-ray point sources with a beam cross section in the nanometer range.

Journal Article↗

Twisted plywood pattern of collagen fibrils in teleost scales: an X-ray diffraction investigation.

The distribution and orientation of collagen fibrils, and apatite crystals, in the scales of a bony fish (Leuciscus cephalus) were investigated by X-ray diffraction. The small-angle diffraction patterns obtained with a microfocus scanning setup from most of the examined areas exhibit a distribution of intensity of the collagen reflections according to five preferential orientations, at 36 degrees from one another. It is suggested that the peculiar small-angle X-ray diffraction pattern is due to a plywood arrangement of collagen fibrils in successive layers parallel to the surface of the scale. The fibrils are strictly aligned in each layer and the alignment rotates by 36 degrees in successive layers, according to a discontinuous twist that generates a symmetric plywood pattern. The large spread of the wide-angle reflections does not allow one to distinguish the five directions of orientation in the intensity distribution of the 002 reflection of apatite. However, the patterns recorded from the less ordered regions of the scales display two different orientations of the 002 reflection and allow one to infer a preferential distribution of the apatite crystals with their c-axes parallel to the collagen fibrils. Although much electron microscopic evidence of plywood arrangements in calcified, as well as uncalcified, tissues has been reported, these are the very first diffraction data which unambiguously confirm the presence of these peculiar structures and suggest that this kind of investigation represents a powerful tool with which to study plywood arrangements in biological tissues.

Animals↗

Microstructural homogeneity of support silk spun by Eriophora fuliginea (C.L. Koch) determined by scanning X-ray microdiffraction.

Scanning X-ray microdiffraction (SXD) permits the 'imaging' in-situ of crystalline phases, crystallinity and texture in whole biopolymer samples on the micrometre scale. SXD complements transmission electron microscopy (TEM) techniques, which reach sub-nanometre lateral resolution but require thin sections and a vacuum environment. This is demonstrated using a support thread from a web spun by the orb-weaving spider Eriophora fuliginea (C.L. Koch). Scanning electron microscopy (SEM) shows a central thread composed of two fibres to which thinner fibres are loosely attached. SXD of a piece of support thread approximately 60 microns long shows in addition the presence of nanometre-sized crystallites with the beta-poly(L-alanine) structure in all fibres. The crystallinity of the thin fibres appears to be higher than that of the central thread, which probably reflects a higher polyalanine content of the fibroins. The molecular axis of the polymer chains in the central thread is orientated parallel to the macroscopic fibre axis, but in the thin fibres the molecular axis is tilted by about 71 degrees to the macroscopic fibre axis. A helical model is tentatively proposed to describe this morphology. The central thread has a homogeneous distribution of crystallinity along the macroscopic fibre axis.

Animals↗

The single-crystal structure of the organic superconductor betaCO-(BEDT-TTF)2I3 from a powder grain.

Synchrotron radiation diffraction data have been collected at 200 K on a microscopic single crystal (dimensions 12 x 10 x 2 µm) of the title compound, where BEDT-TTF is bis(ethylenedithio)tetrathiafulvalene, C(10)H(8)S(8). The quality of the diffraction data allowed a full structure refinement and enabled the determination of structural details such as the conformations of the ethylene groups as well as the occupancy of the triiodide sites. The compound was found to be slightly iodine-deficient and better described as beta(CO)-(BEDT-TTF)(2)I(3-x) [x = 0.014 (3)]. One of the ethylene groups of the BEDT-TTF cation is disordered at this temperature and exists in two distinct conformations with occupancies which are identical within the standard uncertainty.

Journal Article↗

Protein microcrystals and the design of a microdiffractometer: current experience and plans at EMBL and ESRF/ID13.

There is a growing demand for the examination of protein microcrystals at third-generation synchrotron sources. After successful pilot experiments at EMBL/ESRF, which proved that protein microcrystals are often suitable for data collection, operation of the microfocus beamline ID13 was made more user-friendly and suitable for macromolecular crystallography experiments. Given the excellent quality of the beamline microfocusing optics, the key element for successful experiments becomes the handling and visualization of microcrystals. To address this, a microdiffractometer has been designed to allow maximum precision combined with ease of usage and is currently under construction.

Cryoprotective Agents↗

Structural processes during starch granule hydration by synchrotron radiation microdiffraction.

Starch granule hydration has been examined on the level of a single potato starch granule by static and dynamic synchrotron radiation (SR) microdiffraction techniques. A cryofrozen, hydrated granule was mapped through a 5 microm SR-beam in order to investigate its internal organization. The edge of the granule showed fiber texture scattering due to radially oriented amylopectin helices. The variation of fiber texture across the granule center supports the model of concentric shells. The crystalline phase appears, however, to increase strongly toward the granule center due to a random amylopectin fraction, which could be related to crystallization of short-range ordered amylopectin during hydration. During gelatinization, the shell structure breaks down and remaining fiber-textured amylopectin domains belong probably to the swollen starch granule envelope. Hydration of a granule was initiated by a microdrop generator and followed in situ by SR-microdiffraction. A fast hydration process with a half time of about 7 s seems to reflect the porous nature of starch granules. The size of the hydrated domains suggests that this process is limited to the level of amylopectin side chain clusters. Longer hydration times are assumed to involve remaining short-range ordered amylopectin and results in larger domains.

Kinetics↗