PubMed Health⌕ Search

Biomedical subjects

M C Burgos

Publications and source records attributed to M C Burgos.

4 recordsLinked to original sources
PubMed2005

Simulation of germanium detector calibration using the Monte Carlo method: comparison between point and surface source models.

Simulation of detector calibration using the Monte Carlo method is very convenient. The computational calibration procedure using the MCNP code was validated by comparing results of the simulation with laboratory measurements. The standard source used for this validation was a disc-shaped filter where fission and activation products were deposited. Some discrepancies between the MCNP results and laboratory measurements were attributed to the point source model adopted. In this paper, the standard source has been simulated using both point and surface source models. Results from both models are compared with each other as well as with experimental measurements. Two variables, namely, the collimator diameter and detector-source distance have been considered in the comparison analysis. The disc model is seen to be a better model as expected. However, the point source model is good for large collimator diameter and also when the distance from detector to source increases, although for smaller sizes of the collimator and lower distances a surface source model is necessary.

Algorithms↗
PubMed2005

Assessment of mammography spectra using compton spectrometry techniques.

The quality control of mammography units is necessary to reduce the dose imparted to women as much as possible. An accurate characterisation of the primary X-ray spectra is very useful for this purpose. Primary spectra can be obtained using Compton spectrometry techniques. In this work, a commercial spectrometer used to characterise a mammography X-ray tube has been simulated using the Monte Carlo method by means of the MCNP code. Using the developed model, a Response matrix is obtained. Owing to the fact that this matrix is ill-conditioned, the inversion is not a simple process. This problem has been solved using the truncated singular value decomposition method. Results obtained when this methodology was applied have been compared with theoretical X-ray spectra.

Body Burden↗
PubMed2004

Developing a virtual reality application for training nuclear power plant operators: setting up a database containing dose rates in the refuelling plant.

Operators in Nuclear Power Plants can receive high doses during refuelling operations. A training programme for simulating refuelling operations will be useful in reducing the doses received by workers as well as minimising operation time. With this goal in mind, a virtual reality application is developed within the framework of the CIPRES project. The application requires doses, both instantaneous and accumulated, to be displayed at all times during operator training. Therefore, it is necessary to set up a database containing dose rates at every point in the refuelling plant. This database is based on radiological protection surveillance data measured in the plant during refuelling operations. Some interpolation routines have been used to estimate doses through the refuelling plant. Different assumptions have been adopted in order to perform the interpolation and obtain consistent data. In this paper, the procedures developed to set up the dose database for the virtual reality application are presented and analysed.

Computer Simulation↗