Biomedical subjects

M H Rafailovich

Publications and source records attributed to M H Rafailovich.

7 recordsLinked to original sources

PubMed2005

Size-controlled synthesis and characterization of thiol-stabilized gold nanoparticles.

Size-controlled synthesis of nanoparticles of less than a few nanometers in size is a challenge due to the spatial resolution limit of most scattering and imaging techniques used for their structural characterization. We present the self-consistent analysis of the extended x-ray absorption fine-structure (EXAFS) spectroscopy data of ligand-stabilized metal nanoclusters. Our method employs the coordination number truncation and the surface-tension models in order to measure the average diameter and analyze the structure of the nanoparticles. EXAFS analysis was performed on the two series of dodecanethiol-stabilized gold nanoparticles prepared by one-phase and two-phase syntheses where the only control parameter was the gold/thiol ratio xi, varied between 6:1 and 1:6. The two-phase synthesis resulted in the smaller particles whose size decreased monotonically and stabilized at 16 A when xi was lowered below 1:1. This behavior is consistent with the theoretically predicted thermodynamic limit obtained previously in the framework of the spherical drop model of Au nanoparticles.

Journal Article↗

PubMed2005

Effect of density fluctuating supercritical carbon dioxide on polymer interfaces.

We investigated an effect of CO2 sorption on the compatibility of immiscible polystyrene (PS) and polybutadiene (PB) bilayers by using in situ neutron reflectivity. By labeling either polymer with deuterium, we found that the excess CO2 molecules were adsorbed to both top PS and bottom PB layers when the bilayers were exposed to CO2 at the narrow T and P regime near the critical point of pure CO2. Furthermore, we clarified that this excess sorption of CO2 molecules increased the interfacial width between the layers up to 100 angstroms even near room temperature, while the interfacial width without CO2 exposure has been reported to be at most 40 A even at the highest temperature (T congruent with 175 degrees C).

Journal Article↗

PubMed2005

Dynamics of ultrathin films in the glassy state.

We report hole growth experiments in free-standing polystyrene (PS) films at temperatures up to 10 degrees C below the bulk glass transition. The data show an unexpected result: the growth rate of nucleated holes increases with increasing molecular weight, up to a limiting value beyond which the rate is approximately constant. Film thicknesses of 45, 80, and 100 nm were studied, using PS molecular weights ranging from 65K to 11.4 Mg/mol. Hole diameters grew linearly with time, and no growing rims were observed to form around the developing holes. Possible explanations in terms of elasticity, yield, and influence of sample preparation and confinement effects are discussed.

Journal Article↗

PubMed2005

Deviations from liquidlike behavior in molten polymer films at interfaces.

We have performed x-ray specular and diffuse scattering on liquid polymer films and analyzed the spectra as a function of film thickness and molecular weight. The results show that films whose molecular weight is close to the entanglement length behave as simple liquids except that the shortest wavelength is determined by the radius of gyration (R(g)) rather than the monomer-monomer distance. When the molecular weight is higher than the entanglement length, the strong deviations from liquidlike behavior are observed. We find that the long wavelength cutoff vector, q(l,c), scales with film thickness, d as d(-1.1+/-0.1) rather than the usual d(-2) expected for simple liquids. If we assume that these deviations are due to surface pinning of the polymer chains, then our results are consistent with the formalism developed by Fredrickson et al. to explain the capillary wave spectrum that can propagate in a polymer brush.

Journal Article↗

PubMed2003

X-ray scattering from freestanding polymer films with geometrically curved surfaces.

We show that the x-ray surface scattering from a freestanding polymer film exhibits features that cannot be explained by the usual stochastic formalism for surfaces with random height fluctuations. Instead, a geometric description of the film morphology assuming two curved surfaces characterized by a radius of curvature and a lateral cutoff length successfully accounts for the phase difference between the Kiessig fringes of the nominal "specular" and "off-specular" components of the scattering. The formalism allows one to distinguish unambiguously between conformal and anticonformal curvature morphologies at long length scales.

Journal Article↗

PubMed2001

Mobility of polymer chains confined at a free surface.

Dynamic secondary ion mass spectrometry was used to investigate the chain mobility of polystyrene (MW ranging from 4.3 to 957 kg/mol) at the free surface. The data show that the diffusion coefficient was reduced relative to the bulk value within a distance, d < or = 4R(g), from the surface and scaled as 1/N(2.5) at fixed d. These results are in excellent agreement with self-consistent field calculations of the surface segmental distribution and provide the first direct confirmation of various theoretical models that predict asymmetric segmental fluctuation which arises from surface induced orientation of polymer chains.

Journal Article↗

PubMed2000

DNA electrophoresis on a flat surface.

We report a new approach for performing DNA electrophoresis. Using experimental studies and molecular dynamics simulations, we show that a perfectly flat silicon wafer, without any surface features, can be used to fractionate DNA in free solution. We determine that the ability of a flat surface to separate DNA molecules results from the local friction between the surface and the adsorbed DNA segments. We control this friction by coating the Si surface with silane monolayer films and show that it is possible to systematically change the size range of DNA that can be separated.

DNA↗