PubMed Health⌕ Search

Biomedical subjects

M K de Kreuk

Publications and source records attributed to M K de Kreuk.

6 recordsLinked to original sources

Kinetic model of a granular sludge SBR: influences on nutrient removal.

A mathematical model was developed that can be used to describe an aerobic granular sludge reactor, fed with a defined influent, capable of simultaneously removing COD, nitrogen and phosphate in one sequencing batch reactor (SBR). The model described the experimental data from this complex system sufficiently. The effect of process parameters on the nutrient removal rates could therefore be reliably evaluated. The influence of oxygen concentration, temperature, granule diameter, sludge loading rate, and cycle configuration were analyzed. Oxygen penetration depth in combination with the position of the autotrophic biomass played a crucial role in the conversion rates of the different components and thus on overall nutrient removal efficiencies. The ratio between aerobic and anoxic volume in the granule strongly determines the N-removal efficiency as it was shown by model simulations with varying oxygen concentration, temperature, and granule size. The optimum granule diameter for maximum N- and P-removal in the standard case operating conditions (DO 2 mg L(-1), 20 degrees C) was found between 1.2 and 1.4 mm and the optimum COD loading rate was 1.9 kg COD m(-3) day(-1). When all ammonia is oxidized, oxygen diffuses to the core of the granule inhibiting the denitrification process. In order to optimize the process, anoxic phases can be implemented in the SBR-cycle configuration, leading to a more efficient overall N-removal. Phosphate removal efficiency mainly depends on the sludge age; if the SRT exceeds 30 days not enough biomass is removed from the system to keep effluent phosphate concentrations low.

Ammonia↗

Formation of aerobic granules and conversion processes in an aerobic granular sludge reactor at moderate and low temperatures.

Temperature changes can influence biological processes considerably. To investigate the effect of temperature changes on the conversion processes and the stability of aerobic granular sludge, an aerobic granular sludge sequencing batch reactor (GSBR) was exposed to short-term and long-term temperature changes. Start-up at 8 degrees C resulted in irregular granules that aggregated as soon as aeration was stopped, which caused severe biomass washout and instable operation. The presence of COD during the aerobic phase is considered to be the major reason for this granule instability. Start-up at 20 degrees C and lowering the temperature to 15 degrees C and 8 degrees C did not have any effect on granule stability and biomass could be easily retained in the system. The temperature dependency of nitrification was lower for aerobic granules than usually found for activated sludge. Due to decreased activity in the outer layers of granules at lower temperatures, the oxygen penetration depth could increase, which resulted in a larger aerobic biomass volume, compensating the decreased activity of individual organisms. Consequently the denitrifying capacity of the granules decreased at reduced temperatures, resulting in an overall poorer nitrogen removal capacity. The overall conclusion that can be drawn from the experiments at low temperatures is that start-up in practice should take place preferentially during warm summer periods, while decreased temperatures during winter periods should not be a problem for granule stability and COD and phosphate removal in a granular sludge system. Nitrogen removal efficiencies should be optimized by changes in reactor operation or cycle time during this season.

Acclimatization↗

Simultaneous COD, nitrogen, and phosphate removal by aerobic granular sludge.

Aerobic granular sludge technology offers a possibility to design compact wastewater treatment plants based on simultaneous chemical oxygen demand (COD), nitrogen and phosphate removal in one sequencing batch reactor. In earlier studies, it was shown that aerobic granules, cultivated with an aerobic pulse-feeding pattern, were not stable at low dissolved oxygen concentrations. Selection for slow-growing organisms such as phosphate-accumulating organisms (PAO) was shown to be a measure for improved granule stability, particularly at low oxygen concentrations. Moreover, this allows long feeding periods needed for economically feasible full-scale applications. Simultaneous nutrient removal was possible, because of heterotrophic growth inside the granules (denitrifying PAO). At low oxygen saturation (20%) high removal efficiencies were obtained; 100% COD removal, 94% phosphate (P-) removal and 94% total nitrogen (N-) removal (with 100% ammonium removal). Experimental results strongly suggest that P-removal occurs partly by (biologically induced) precipitation. Monitoring the laboratory scale reactors for a long period showed that N-removal efficiency highly depends on the diameter of the granules.

Bacteria, Aerobic↗

Effects of oxygen concentration on N-removal in an aerobic granular sludge reactor.

In order to optimise nitrogen removal in an aerobic granular sludge system, short- and long-term effects of decreased oxygen concentrations on the reactor performance were studied. Operation at decreased oxygen concentration is required to obtain efficient N-removal and low aeration energy requirement. A short-term oxygen reduction (from 100% to 50%, 40%, 20% or 10% of the saturation concentration) did not influence the acetate uptake rate. A lower aerobic acetate uptake at lower oxygen concentrations was obviously compensated by anoxic acetate uptake. Nitrogen removal was favoured by decreased oxygen concentrations, reaching a value of 34% for the lowest oxygen concentration tested. Long-term effects were evaluated at two oxygen saturation levels (100% and 40%). Nitrogen removal increased from 8% to 45% when the oxygen saturation was reduced to 40%. However, the granules started to disintegrate and biomass washout occurred. It was impossible to obtain stable granular sludge at this decreased oxygen concentration under applied conditions. A solution to obtain stable aerobic granular sludge at low oxygen concentrations is needed in order to make aerobic granular sludge reactors feasible in practice.

Acetates↗

Aerobic granular sludge technology: an alternative to activated sludge?

Laboratory experiments have shown that it is possible to cultivate aerobic granular sludge in sequencing batch reactors. In order to direct future research needs and the critical points for successful implementation at large scale, a full detailed design of a potential application was made. The design was based on the laboratory results, and two variants of a full-scale sewage treatment plant based on Granular sludge Sequencing Batch Reactors (GSBRs) were evaluated. As a reference a conventional treatment plant based on activated sludge technology was designed for the same case. Based on total annual costs both GSBR variants proved to be more attractive than the reference alternative (7-17% lower costs). From a sensitivity analysis it appeared that the GSBR technology was less sensitive to the land price and more sensitive to a rain weather flow (RWF). This means that the GSBR technology becomes more attractive at lower permissible RWF/DWF ratios and higher land prices. The footprint of the GSBR variants was only 25% compared to the reference. However, the GSBR with primary treatment only cannot meet the present effluent standards for municipal wastewater in The Netherlands, mainly because of a too high suspended solids concentration in the effluent. A growing number of sewage treatment plants in the Netherlands are going to be faced with more stringent effluent standards. In general, activated sludge plants will have to be extended with a post treatment step (e.g. sand filtration) or be transformed into Membrane Bioreactors. In this case a GSBR variant with primary treatment as well as post treatment can be an attractive alternative.

Bacteria, Aerobic↗

Selection of slow growing organisms as a means for improving aerobic granular sludge stability.

Recently, several groups have showed the occurrence of aerobic granular sludge. The excellent settling characteristics of aerobic granular sludge allow the design of very compact wastewater treatment plants. In laboratory experiments, high oxygen concentrations were needed to obtain stable granulation. However, in order to obtain energy efficient aeration and good denitrification low oxygen concentrations would be required. From earlier research on biofilm morphology, it was learned that slow growing organisms influence the density and stability of biofilms positively. To decrease the growth rate of the organisms in the aerobic granules, easily degradable substrate (e.g. acetate) has to be converted to slowly degradable COD like microbial storage polymers (e.g. PHA). Phosphate or glycogen accumulating bacteria perform this conversion step most efficiently. In this paper it is shown that the selection of such bacteria in aerobic granules indeed led to stable granular sludge, even at low oxygen concentrations.

Bacteria, Aerobic↗