Biomedical subjects
Publications and source records attributed to M L Doche.
In this paper, active zones of an ultrasonic reactor are underlined by laser tomography and electrochemical measurements.
This paper is devoted to the electroless plating of non-conductive substrates under ultrasound at 530 kHz. The ultrasonic irradiation is applied to the activation and to the plating steps. Effects are measured by following the final copper thickness obtained in 1 h of plating time, easily correlated to the average plating rate. It appears that ultrasound has a strong influence on the plating rates enhancement, and assumptions can be made that this increase could be linked to the catalyst cleaning. This is confirmed by XPS measurements.
This paper reports the study of ultrasonic irradiation effects on electroless copper coating on an epoxide resin. Several parameters were monitored, such as plating rates, practical adhesion and internal stress, versus varying acoustic powers at a constant frequency of 530 kHz. Exposure conditions were characterised by both transmitted power and interfacial mass transfer coefficients. Optimum conditions expressed in irradiation time and power were determined. The use of ultrasound during electroless copper plating affects the plating rates and the deposits properties, particularly the practical adhesion which increases whereas the internal stress decreases. Then, the changes in the coating mechanisms are discussed.
This paper describes the influence of 20 kHz ultrasound upon the corrosion behaviour of zinc in NaOH electrolytes. A systematic study of the effects exerted by ultrasound on the electrochemical interface was first carried out, so as to determine the transmitted power and to characterize mass transfer at the electrode. Then attention was focused on the corrosion passivation mechanism of zinc in sonicated NaOH solutions (0.1 and 1 M). Investigations were carried out using electrochemical techniques to determine corrosion and passivation kinetics parameters. SEM analysis of the sonicated zinc surfaces provides complementary information on the oxide layer composition and structure.
The present work has been carried out in order to design a new type of ultrasonic reactor consisting of a double-structured tank. The inner working compartment is built with a slant bottom to allow a better ultrasonic transmission. This paper reports the effect of the inclination angle on acoustic efficiency for several different plates, e.g. two plates made of glass (2 mm and 3 mm thickness) and one made of PVC (3 mm thickness). The acoustic efficiency was determined as the ratio of the signal measured by a hydrophone in the presence of the plate to that signal in the absence of the plate. Having optimised the system, the ultrasonic powers in the inner and the outer compartments of the slant bottom reactor were determined by hydrogen peroxide dosimetry.