PubMed Health⌕ Search

Biomedical subjects

M L Serralheiro

Publications and source records attributed to M L Serralheiro.

6 recordsLinked to original sources

Kinetic properties of wild-type and altered recombinant amidases by the use of ion-selective electrode assay method.

A novel assay method was investigated for wild-type and recombinant mutant amidases (EC 3.5.1.4) from Pseudomonas aeruginosa by ammonium ion-selective electrode (ISE). The initial velocity is proportional to the enzyme concentration by using the wild-type enzyme. The specific activities of the purified amidase were found to be 88.2 and 104.2 U mg protein(-1) for the linked assay and ISE methods, respectively. The kinetic constants--Vmax, Km, and Kcat--determined by Michaelis-Menten plot were 101.13 U mg protein(-1), 1.12x10(-2) M, and 64.04 s(-1), respectively, for acrylamide as the substrate. On the other hand, the lower limit of detection and range of linearity of enzyme concentration were found to be 10.8 and 10.8 to 500 ng, respectively, for the linked assay method and 15.0 and 15.0 to 15,000 ng, respectively, for the ISE method. Hydroxylamine was found to act as an uncompetitive activator of hydrolysis reaction catalyzed by amidase given that there is an increase in Vmax and Km when acetamide was used as the substrate. However, the effect of hydroxylamine on the hydrolysis reaction was dependent on the type of amidase and substrate involved in the reaction mixture. The degrees of activation (epsilon(a)) of the wild-type and mutant (T103I and C91A) enzymes were found to be 2.54, 12.63, and 4.33, respectively, for acetamide as the substrate. However, hydroxylamine did not activate the reaction catalyzed by wild-type and altered (C91A and W138G) amidases by using acrylamide and acetamide, respectively, as the substrate. The activating effect of hydroxylamine on the hydrolysis of acetamide, acrylamide, and p-nitrophenylacetamide can be explained by the fact that additional formation of ammonium ions occurred due to the transferase activity of amidases. However, the activating effect of hydroxylamine on the hydrolysis of p-nitroacetanilide may be due to a change in conformation of enzyme molecule. Therefore, the use of ISE permitted the study of the kinetic properties of wild-type and mutant amidases because it was possible to measure initial velocity of the enzyme-catalyzed reaction in real time.

Acetamides↗

Application of factorial design to the optimization of peroxidase activity in reverse micelles of bis(2-ethylhexyl)sodium sulfosuccinate/ isooctane.

Two cationic peroxidases isolated from Vaccinium myrtillus were encapsulated in reverse micelles of bis(2-ethylhexyl)sodium sulfosuccinate/isooctane. By using a central composite design, some relevant parameters for the enzymatic activity, such as surfactant and water concentration, pH, and buffer molarity, were analyzed. With the results obtained from this experimental planning, the response surface curves were established. The maximum specific activity obtained (0.19 mM/min. mM of enzyme) was approximately the same for both peroxidases, but the experimental conditions under which this value was attained differed considerably.

Journal Article↗

Dipeptide synthesis and separation in a reversed micellar membrane reactor.

The synthesis of dipeptide AcPheLeuNH2 catalyzed by alpha-chymotrypsin encapsulated in TTAB/octanol/heptane reversed micelles was investigated in a tubular ceramic membrane reactor, operated in a batch mode. The reaction medium conditions (TTAB concentration, buffer molarity, and pH) were optimized using a factorial design in order to achieve maximum synthesis rates. Hydrated reversed micelles permeated through the membrane together with the substrate ester, dipeptide, and by-products. However, as a result of the low solubility of the peptide in the reaction medium, selective precipitation occurred, thus enabling the complete retention of the solid product by the ultrafiltration membrane and therefore an integration of a separation step in the biotransformation process. In spite of the continuous accumulation of solids inside the reactor, constant permeation flow rates could be maintained throughout the operation. The influence of alpha-chymotrypsin, TTAB, and water concentration on the kinetics and mass transfer of the system was also investigated. The behavior of the system during a continuous experiment was also evaluated.

Biotechnology↗

Thin layer chromatographic confirmation of aflatoxin M1 extracted from milk.

Aflatoxin M1 can be confirmed directly on a thin layer plate by reacting the toxin with a mixture of reagents containing p-anisaldehyde. This confirmatory procedure requires only 2 elutions in the same direction using 2 different solvents. The mixture containing p-anisaldehyde is overspotted on M1 after the plate has been developed in toluene-ethyl acetate-ethyl ether-formic acid (25 + 35 + 40 + 5). The plate is heated at 110 degrees C for 10 min and then developed in hexane-acetone-chloroform (15 + 50 + 35). The Rf value of the green fluorescent derivative is less than that of the M1 standard. This confirmatory procedure requires only one-dimensional TLC, so several sample extracts and the standard can be run simultaneously. The minimum detectable quantity of aflatoxin M1 on the TLC plate with this test is 0.3 ng. p-Anisaldehyde reagent solution may also be used as a spray reagent for the confirmation of aflatoxin M1. The procedures described were satisfactory for confirming the mycotoxin in spiked samples of powdered and liquid milk.

Aflatoxin M1↗

Rapid thin layer chromatographic determination of aflatoxin M1 in powdered milk.

A method has been developed for the detection of aflatoxin M1 in milk. The toxin is extracted with chloroform, the extract is evaporated, and the residue is partitioned between carbon tetrachloride and an aqueous saline-methanol solution. The toxin is once again extracted with chloroform from the methanol solution and analyzed by thin layer chromatography. The limit of detection of M1 in powdered milk is 0.5 microgram/kg; recoveries of added M1 are about 83%. The limit of detection can be improved to 0.3 microgram/kg if the plate is sprayed with an aqueous solution of H2SO4 after development.

Aflatoxin M1↗