Biomedical subjects

M Prentiss

Publications and source records attributed to M Prentiss.

17 recordsLinked to original sources

PubMed2006

Comparison of the measured phase diagrams in the force-temperature plane for the unzipping of two different natural DNA sequences.

In this work, we consider the critical force required to unzip two different naturally occurring sequences of double-stranded DNA (dsDNA) at temperatures ranging from 20 degrees C to 50 degrees C, where one of the sequences has a 53% average guanine-cytosine (GC) content and the other has a 40% GC content. We demonstrate that the force required to separate the dsDNA of the 53% GC sequence into single-stranded DNA (ssDNA) is approximately 0.5 pN, or approximately 5% greater than the critical force required to unzip the 40% GC sequence at the same temperature. In the temperature range between 20 and 40 degrees C the measured critical forces correspond reasonably well to predictions based on a simple theoretical homopolymeric model, but at temperatures above 40 degrees C the measured critical forces are much smaller than the predicted forces. The correspondence between theory and experiment is not improved by using Monte Carlo simulations that consider the heteropolymeric nature of the sequences.

Bacteriophage lambda↗

PubMed2005

Pause point spectra in DNA constant-force unzipping.

Under constant applied force, the separation of double-stranded DNA into two single strands is known to proceed through a series of pauses and jumps. Given experimental traces of constant-force unzipping, we present a method whereby the locations of pause points can be extracted in the form of a pause point spectrum. A simple theoretical model of DNA constant-force unzipping is presented, which generates theoretical pause point spectra through Monte Carlo simulation of the unzipping process. The locations of peaks in the experimental and theoretical pause point spectra are found to be nearly coincident below 6000 basepairs for unzipping the bacteriophage lambda-genome. The model only requires the sequence, temperature, and a set of empirical basepair binding and stacking energy parameters, and the good agreement with experiment suggests that pause point locations are primarily determined by the DNA sequence. The model is also used to predict pause point spectra for the bacteriophage phi X174 genome. The algorithm for extracting the pause point spectrum might also be useful for studying related systems which exhibit pausing behavior such as molecular motors.

Algorithms↗

PubMed2004

Dynamical instability of a doubly quantized vortex in a Bose-Einstein condensate.

Doubly quantized vortices were topologically imprinted in /F=1> 23Na condensates, and their time evolution was observed using a tomographic imaging technique. The decay into two singly quantized vortices was characterized and attributed to dynamical instability. The time scale of the splitting process was found to be longer at higher atom density.

Journal Article↗

PubMed2004

Measurement of the phase diagram of DNA unzipping in the temperature-force plane.

We separate double stranded lambda phage DNA by applying a fixed force at a constant temperature ranging from 15 to 50 degrees C, and measure the minimum force required to separate the two strands. The measurements also offer information on the free energy of double stranded DNA (dsDNA) at temperatures where dsDNA does not thermally denature in the absence of force. While parts of the phase diagram can be explained using existing models and free energy parameters, others deviate significantly. Possible reasons for the deviations between theory and experiment are considered.

Biophysics↗

PubMed2000

Measuring the forces involved in polyvalent adhesion of uropathogenic Escherichia coli to mannose-presenting surfaces.

Mechanisms of bacterial pathogenesis have become an increasingly important subject as pathogens have become increasingly resistant to current antibiotics. The adhesion of microorganisms to the surface of host tissue is often a first step in pathogenesis and is a plausible target for new antiinfective agents. Examination of bacterial adhesion has been difficult both because it is polyvalent and because bacterial adhesins often recognize more than one type of cell-surface molecule. This paper describes an experimental procedure that measures the forces of adhesion resulting from the interaction of uropathogenic Escherichia coli to molecularly well defined models of cellular surfaces. This procedure uses self-assembled monolayers (SAMs) to model the surface of epithelial cells and optical tweezers to manipulate the bacteria. Optical tweezers orient the bacteria relative to the surface and, thus, limit the number of points of attachment (that is, the valency of attachment). Using this combination, it was possible to quantify the force required to break a single interaction between pilus and mannose groups linked to the SAM. These results demonstrate the deconvolution and characterization of complicated events in microbial adhesion in terms of specific molecular interactions. They also suggest that the combination of optical tweezers and appropriately functionalized SAMs is a uniquely synergistic system with which to study polyvalent adhesion of bacteria to biologically relevant surfaces and with which to screen for inhibitors of this adhesion.

Bacterial Adhesion↗

PubMed2000

Guiding neutral atoms on a chip

We demonstrate the guiding of neutral atoms by the magnetic fields due to microfabricated current-carrying wires on a chip. Atoms are guided along a magnetic field minimum parallel to and above the current-carrying wires. Two guide configurations are demonstrated: one using two wires with an external magnetic field, and a second using four wires without an external field. These guide geometries can be extended to integrated atom optics circuits, including beam splitters.

Journal Article↗

PubMed1998

Localization of metastable atom beams with optical standing waves: nanolithography at the heisenberg limit

The spatially dependent de-excitation of a beam of metastable argon atoms, traveling through an optical standing wave, produced a periodic array of localized metastable atoms with position and momentum spreads approaching the limit stated by the Heisenberg uncertainty principle. Silicon and silicon dioxide substrates placed in the path of the atom beam were patterned by the metastable atoms. The de-excitation of metastable atoms upon collision with the surface promoted the deposition of a carbonaceous film from a vapor-phase hydrocarbon precursor. The resulting patterns were imaged both directly and after chemical etching. Thus, quantum-mechanical steady-state atom distributions can be used for sub-0.1-micrometer lithography.

Journal Article↗

PubMed1996

Complex Optical Surfaces Formed by Replica Molding Against Elastomeric Masters

Complex, optically functional surfaces in organic polymers can be fabricated by replicating relief structures present on the surface of an elastomeric master with an ultraviolet or thermally curable organic polymer, while the master is deformed by compression, bending, or stretching. The versatility of this procedure for fabricating surfaces with complex, micrometer- and submicrometer-scale patterns was demonstrated by the production of (i) diffraction gratings with periods smaller than the original grating; (ii) chirped, blazed diffraction gratings (where the period of a chirped grating changes continuously with position) on planar and curved surfaces; (iii) patterned microfeatures on the surfaces of approximately hemispherical objects (for example, an optical surface similar to a fly's eye); and (iv) arrays of rhombic microlenses. These topologically complex, micropatterned surfaces are difficult to fabricate with other techniques.

Journal Article↗

PubMed1995

Microlithography by using neutral metastable atoms and self-assembled monolayers.

Lithography can be performed with beams of neutral atoms in metastable excited states to pattern self-assembled monolayers (SAMs) of alkanethiolates on gold. An estimated exposure of a SAM of dodecanethiolate (DDT) to 15 to 20 metastable argon atoms per DDT molecule damaged the SAM sufficiently to allow penetration of an aqueous solution of ferricyanide to the surface of the gold. This solution etched the gold and transformed the patterns in the SAMs into structures of gold; these structures had edge resolution of less than 100 nanometers. Regions of SAMs as large as 2 square centimeters were patterned by exposure to a beam of metastable argon atoms. These observations suggest that this system may be useful in new forms of micro- and nanolithography.

Argon↗

PubMed1995