Biomedical subjects

M S Van Lysel

Publications and source records attributed to M S Van Lysel.

12 recordsLinked to original sources

PubMed2001

Comparison of vessel contrast measured with a scanning-beam digital x-ray system and an image intensifier/television system.

Vessel contrast was measured in the fluoroscopic images produced by a scanning-beam digital x-ray (SBDX) system and an image intensifier/television (II/TV) based system. The SBDX system electronically scans a series of pencil x-ray beams across the patient, each of which is directed at a distant small-area detector array. The reduction in detected scatter achieved with this geometry was expected to provide an increase in image contrast. Vessel contrast was evaluated from images of a phantom containing iodinated tubes. The vessels were inserted into an acrylic stack to provide a patient-mimicking scattering medium. Vessel diameter ranged from 0.3 to 3.1 mm. Images were acquired at 100 kVp with the SBDX and II/TV systems and averaged to reduce x-ray noise. The II/TV system was operated in the 6-in. image intensifier mode with an anti-scatter grid. The increase in contrast in the SBDX images, expressed as a ratio of the measured SBDX and II/TV contrasts, ranged from 1.63 to 1.79 for individual vessels. This agreed well with a prediction of the contrast improvement ratio for this experiment, based on measurements of the scatter fraction, object-plane line spread functions, and consideration of the source spectrum and detector absorption properties. The predicted contrast improvement ratio for SBDX relative to II/TV images was 1.62 to 1.77.

Angiography↗

PubMed1994

Optimization of beam parameters for dual-energy digital subtraction angiography.

Dual-energy digital subtraction angiography (DSA) is immune to the misregistration artifacts which plague conventional temporal subtraction DSA. However, since the signal-to-noise ratio (SNR) of dual-energy DSA is lower than temporal subtraction it is important to optimize the dual-energy technique with respect to the SNR. This study investigates the optimization of x-ray exposure parameters for the low- and high-energy x-ray beams, drawing upon our experience with dual-energy DSA studies in 20 cardiac patients. It is shown that the SNR is optimized, with respect to patient exposure, when the image intensifier (II) exposure for the high-energy beam is approximately 5 times higher than the low-energy beam. The unequal distribution of exposure between the low- and high-energy beams is achieved by selecting different video apertures for the two beams, and is therefore referred to as the "dual-aperture" technique. The dual-aperture technique achieves the same SNR as the single-aperture technique (which uses equal II exposures for the two beams) with 45% less patient exposure. In addition, the dual-aperture technique enhances the ability to maintain an optimum low-energy kVp, which increases the dual-energy signal amplitude. The optimum high-beam filter thickness for use with the dual-aperture approach is determined. The optimum filter thickness, which is dependent upon the desired tube loading, is found to range from 1.3 to 2.0 mm Cu for tube loads ranging from 188 to 688 J/beam pair.

Adult↗

PubMed1993

Densitometric assessment of regional left ventricular systolic function during graded ischemia in the dog by use of dual-energy digital subtraction ventriculography.

Densitometric analysis of images obtained by digital subtraction angiography (DSA) allows for more reproducible and less operator-dependent quantitation of ventricular function. Conventional DSA uses temporal subtraction but is limited by misregistration artifacts. Dual-energy digital subtraction angiography (DE-DSA) is immune to such misregistration artifacts. The ability of DE-DSA to quantitate changes in regional ventricular volume resulting from ischemia was tested. Densitometric analysis of both phase-matched and ejection fraction DE-DSA images was used to quantitate regional left ventricular systolic function during four levels of ischemia ranging from mild to severe in open-chest dogs (n = 10). DE-DSA left ventriculograms were obtained by means of central venous injections of iodinated contrast medium. Ischemia was graded according to percentage of systolic wall thickening as measured by sonomicrometry. Phase-matched end-systolic images were obtained at each of four levels of ischemia by subtracting an end-systolic control image from each end-systolic ischemic image. Ejection fraction images were obtained at the control level and at each level of ischemia by subtracting an end-systolic image from an end-diastolic image of the same cardiac cycle. The resulting wall motion difference signals represent the changes in regional ventricular volumes and were quantitated by densitometry. Densitometry was able to detect the effect of all levels of ischemia on regional function, even the mildest. Densitometric analysis of both phase-matched and ejection fraction DE-DSA images provides a sensitive technique for detecting and quantitating the changes in regional left ventricular systolic volume that occur with ischemia.

Angiography, Digital Subtraction↗

PubMed1991

Left ventricular dual-energy digital subtraction angiography: a motion immune digital subtraction technique.

Digital subtraction angiography (DSA) allows quantitative analysis of ventricular function via densitometric and parametric imaging techniques. However, DSA is limited by the artifacts in temporal subtraction images that result from patient and cardiac motion. Dual-energy subtraction imaging is insensitive to motion. This study evaluated the initial application of dual-energy subtraction in cardiac patients. The image quality of dual-energy subtraction left ventriculograms obtained from a pulmonary artery injection of contrast was assessed in 13 patients, ranging in weight from 54 to 100 kg. The dual-energy images were compared with left ventricular images obtained using standard left ventricular injection cine angiography. End-systolic and end-diastolic ventricular volumes calculated from the cine (C) and dual-energy (DE) images using the Area-Length method were compared. The resulting regression line was DE = 0.98 C+ 7.0 ml, and the r value was 0.987. Dual-energy subtraction provided good left ventricular visualization, free from misregistration artifacts, even during patient motion.

Adult↗

PubMed1983

Videodensitometric quantitation of mean blood flow.

Standard angiography demonstrates the anatomy of arterial occlusive disease but does not define its physiological significance. However, measurement of flow in a compromised vessel at rest and following peripheral dilatation provides important physiological information. Using digital subtraction angiography, femoral arterial flows determined by the cross-correlation transit time technique were compared to measurements by electromagnetic flowmeter. Thirty-five femoral arterial flow measurements were obtained in nine dogs instrumented with an electromagnetic flow probe and balloon occluder. Renografin 76 (7 cc) was power-injected at 14 cc/sec into the distal abdominal aorta. Angiographic flow measurements correlated well with electromagnetic flowmeter measurements (r = 0.94, standard deviation of the difference (SDD) = 15 ml/min). Intravenous studies provided somewhat poorer correlation due to difficulties in defining dimensions (r = 0.72, SDD = 36). Paired contrast injections (2 injections in succession) in 11 studies increased flow from an average of 80 to 250 ml/min (a 210 +/- 100% increase), providing an estimate of a vessel's capacity to provide increased flow during peripheral dilatation. Thus, reliable angiographic flow determinations may be obtained by arterial and intravenous contrast injections, adding physiological information to anatomical definition.

Absorptiometry, Photon↗

PubMed1983

Work in progress: hybrid temporal-energy subtraction in digital fluoroscopy.

Initial clinical results using a digital fluoroscopic implementation of the combined time-energy ("hybrid") subtraction technique are described, with emphasis on carotid and renal imaging. Where patient motion artifacts are due to soft-tissue motion alone, hybrid subtraction can remove them. Due to the need for a finite separation time between high- and low-energy pairs, however, the present implementation of the hybrid technique is not completely immune to soft-tissue motion. The intrinsic signal-to-noise ratio of hybrid imaging is less than that of conventional temporal subtraction. However, since the low-energy temporal subtraction images are included in the hybrid data set, the diagnostic quality of the examination is not compromised.

Analog-Digital Conversion↗

PubMed1982

A technique of scatter and glare correction for videodensitometric studies in digital subtraction videoangiography.

The logarithmic amplification of video signals and the availability of data in digital form make digital subtraction videoangiography a suitable tool for videodensitometric estimation of physiological quantities. A system for this purpose was implemented with a digital video image processor. However, it was found that the radiation scattering and veiling glare present in the image-intensified video must be removed to make meaningful quantitations. An algorithm to make such a correction was developed and is presented. With this correction, the videodensitometry system was calibrated with phantoms and used to measure the left ventricular ejection fraction of a canine heart.

Absorptiometry, Photon↗

PubMed1981

Normalized organ doses for various diagnostic radiologic procedures.

Organ-absorbed doses for 24 diagnostic examination projections were measured using an Alderson Rando phantom. The organs of interest were testes, ovaries, thyroid, eyes, uterus, and active bone marrow. The reported values were normalized to the unit entrance exposure of each examination. Subsequent comparison of these measured values with the experimental and calculated values of other investigators showed reasonable agreement.

Bone Marrow↗

PubMed1981

Estimation and minimization of fetal absorbed dose: data from common radiographic examinations.

A simple method of estimating fetal absorbed dose from common abdominal and pelvic radiographic examinations is presented. The method uses experimentally determined normalized depth dose curves (rad/Roentgen exposure free-in-air) and sonographic localization of the fetus. The method is useful for estimating fetal absorbed dose when a pregnant woman inadvertently undergoes a radiographic examination. However, its primary value is in minimizing fetal dose when a woman, known to be pregnant, must undergo a radiographic examination. Selection of proper projection and deliberate adjustment of bladder volume can result in significant fetal dose reduction particularly in the critical first trimester.

Female↗

PubMedDate not supplied

A correlated noise reduction algorithm for dual-energy digital subtraction angiography.

It has long been recognized that the problems of motion artifacts in conventional time subtraction digital subtraction angiography (DSA) may be overcome using energy subtraction techniques. Of the variety of energy subtraction techniques investigated, non-k-edge dual-energy subtraction offers the best signal-to-noise ratio (SNR). However, this technique achieves only 55% of the temporal DSA SNR. Noise reduction techniques that average the noisier high-energy image produce various degrees of noise improvement while minimally affecting iodine contrast and resolution. A more significant improvement in dual-energy DSA iodine SNR, however, results when the correlated noise that exists in material specific images is appropriately cancelled. The correlated noise reduction (CNR) algorithm presented here follows directly from the dual-energy computed tomography work of Kalender who made explicit use of noise correlations in material specific images to reduce noise. The results are identical to those achieved using a linear version of the two-stage filtering process described by Macovski in which the selective image is filtered to reduce high-frequency noise and added to a weighted, high SNR, nonselective image which has been processed with a high-frequency bandpass filter. The dual-energy DSA CNR algorithm presented here combines selective tissue and iodine images to produce a significant increase in the iodine SNR while fully preserving iodine spatial resolution. Theoretical calculations predict a factor of 2-4 improvement in SNR compared to conventional dual-energy images. The improvement factor achieved is dependent upon the x-ray beam spectra and the size of blurring kernel used in the algorithm.(ABSTRACT TRUNCATED AT 250 WORDS)

Algorithms↗

PubMedDate not supplied

Measurement of absolute blood iodine concentration during digital subtraction ventriculography.

A system to measure the absolute iodine concentration (mg iodine/milliliter blood) in the left ventricle (LV) during digital subtraction ventriculography has been developed. The technique uses a catheter to draw blood from the LV through a detection cell. This occurs as the iodine bolus passes through the heart. The cell determines iodine concentration by measuring x-ray attenuation as the iodinated blood passes between a low-power x-ray tube and a diode detector. In vitro and in vivo testing of the system was conducted. The system response was linear (r = 0.99) with respect to iodine concentration. This response was independent of hematocrit. Dispersion of contrast medium in the catheter caused distortion of the shape of the time-concentration curve. The impulse response of the system was measured and found to be independent of hematocrit. A correction algorithm based on Wiener filter deconvolution was developed. In vitro testing using simulated time-concentration curves demonstrated that the rms error in the iodine measurement after dispersion correction did not exceed 4% over the region of the time-concentration curve extending from the peak to the point on the tail where the signal fell to 50% of its peak value. Cardiac output was measured from the time-concentration curve via the indicator-dilution method in an animal model. This cardiac output measurement (COI) agreed closely with cardiac output measured simultaneously with an aortic flow probe (CO(P)), namely, COI = 1.02 CO(P)-0.03 L/min, r = 0.95, SEE = 10%, p < 0.001.(ABSTRACT TRUNCATED AT 250 WORDS)

Animals↗

PubMedDate not supplied

The AAPM/RSNA physics tutorial for residents: fluoroscopy: optical coupling and the video system.

In fluoroscopic/fluorographic systems, an image intensifier is optically coupled to recording cameras. The optical distributor is responsible for transmitting a focused image from the output phosphor of the image intensifier to the focal planes of the cameras. Each camera has an aperture, which is used to control the level of light reaching its focal plane. The aperture setting determines the patient x-ray exposure level and the image noise level. Increasing the x-ray exposure reduces image noise; reducing the x-ray exposure increases image noise. Fluoroscopic/fluorographic systems always include a video camera. The functions of the video system are to provide for multiple observers and to facilitate image recording. The camera head contains an image sensor, which converts the light image from the image intensifier into a voltage signal. The device used to generate the video signal is a pickup tube or a charge-coupled device sensor. The method used is raster scanning, of which there are two types: progressive and interlaced. The vertical resolution of the system is primarily determined by the number of scan lines; the horizontal resolution is primarily determined by the bandwidth. Frame rate reduction can be a powerful tool for exposure reduction.

Angiography, Digital Subtraction↗