Biomedical subjects

Manickam Sivakumar

Publications and source records attributed to Manickam Sivakumar.

8 recordsLinked to original sources

PubMed2006

Fabrication of zinc ferrite nanocrystals by sonochemical emulsification and evaporation: observation of magnetization and its relaxation at low temperature.

A new ultrasound assisted emulsion (consisting of rapeseed oil and aqueous solution of Zn(2+) and Fe(2+) acetates) and evaporation protocol has been developed for the synthesis of zinc ferrite (ZnFe(2)O(4)) nanoparticles with narrow size distribution. The as-synthesized sample consisted of crystalline zinc ferrite particles with an average diameter of approximately 4 nm, whereas the average size of the heat-treated ferrite particles increases to approximately 12 nm. To remove the small amount of oil present on the surface of the as-synthesized ferrite sample, heat treatment was carried out at 350 degrees C for 3 h. The as-synthesized and heat-treated ferrites were characterized by X-ray diffraction (XRD), infrared spectroscopy (IR), TGA/DTA, transmission electron microscopy (TEM), and energy dispersion X-ray spectroscopy (EDS) techniques. Magnetic measurements show that the nanocrystalline ZnFe(2)O(4), prepared through this technique, is either at par with those obtained in other cases or even more improved. Both the as-synthesized and heat-treated samples reveal relaxation of magnetization. Our study also shows that one can tailor the magnetization and relaxation pattern by suitably controlling the particle size of the nanocrystalline ZnFe(2)O(4). The key features of this method are avoiding (a) the cumbersome conditions that exist in the conventional methods, (b) the usage of necessary additive components (stabilizers or surfactants, precipitants), and (c) calcination requirements. In addition, rapeseed oil has replaced organic nonpolar solvents used in earlier studies. As a whole, this simple straightforward sonochemical approach results in a better pure phase system of nanoferrite with improved magnetic properties.

Emulsions↗

PubMed2006

Influence of dissolved-air concentration on spatial distribution of bubbles for sonochemistry.

The pulsation of ultrasonic cavitation bubbles at various dissolved-air concentration in a sonochemical reaction field of standing-wave type is investigated experimentally by laser-light scattering. When a thin light sheet, finer than half the wavelength of sound, is introduced into the cavitation bubbles at an antinode of sound pressure, the scattered light intensity oscillates. The peak-to-trough light intensity is correlated with the number of bubbles that contribute to the sonochemical reaction. It is shown that as the dissolved air concentration becomes higher, the weighted center of the spatial distribution of the peak-to-trough intensity tends to shift towards the liquid surface. At higher concentration of the dissolved air, a great deal of bubbles with size distribution generated due to coalescence between bubbles disturbs sound propagation to change the sound phase easily. A standing wave to trap tiny oscillating bubbles is established only at the side which is nearer to the liquid surface. Also at higher concentration, liquid flow induced by drag motion of bubbles by the action of radiation force becomes apparent and position-unstable region of bubble is enlarged from the side of sound source towards the liquid surface. Therefore, the position of oscillating bubbles active for sonochemical reaction is limited at the side which is nearer to the liquid surface at higher concentration of the dissolved air.

Air↗

PubMed2005

Theoretical study of single-bubble sonochemistry.

Numerical simulations of bubble oscillations in liquid water irradiated by an ultrasonic wave are performed under the experimental condition for single-bubble sonochemistry reported by Didenko and Suslick [Nature (London) 418, 394 (2002)]. The calculated number of OH radicals dissolving into the surrounding liquid from the interior of the bubble agrees sufficiently with the experimental data. OH radicals created inside a bubble at the end of the bubble collapse gradually dissolve into the surrounding liquid during the contraction phase of an ultrasonic wave although about 30% of the total amount of OH radicals that dissolve into the liquid in one acoustic cycle dissolve in 0.1 micros at around the end of the collapse. The calculated results have indicated that the oxidant produced by a bubble is not only OH radical but also O atom and H2O2. It is suggested that an appreciable amount of O atom is produced by bubbles inside a standing-wave-type sonochemical reactor filled with water in which oxygen is dissolved as in the case of air.

Journal Article↗

PubMed2005

Correlation between acoustic cavitation noise and yield enhancement of sonochemical reaction by particle addition.

The mechanism of the effect of particle addition on sonochemical reaction is studied through the measurements of frequency spectrum of sound intensity for evaluating the cavitation noise and the absorbance for the liberation of iodine from an aqueous solution of KI as an index of oxidation reaction by ultrasonic irradiation in the presence or absence of alumina particles. As it is expected that both the acoustic noise and a rise in temperature in the liquid irradiated by intense ultrasound will increase with the number of collapsing bubbles, these are supposed to be the best tools for evaluating the relative number of bubbles. In the present investigation, it has been shown that the addition of particles with appropriate amount and size results in an increase in the absorbance when both the acoustic noise and the rise in the liquid temperature due to cavitation bubbles also increase. This suggests that the enhancement in the yield of sonochemical reaction by appropriate particle addition comes from an increase in the number of cavitation bubbles. The existence of particle in liquid provides a nucleation site for cavitation bubble due to its surface roughness, leading to the decrease in the cavitation threshold responsible for the increase in the number of bubbles when the liquid is irradiated by ultrasound. Thus, from the present investigation, it is clarified that the particle addition has a potential to enhance the yield in the sonochemical reaction.

Chemical Phenomena↗

PubMed2005

Characterisation of dentin surfaces processed with KrF excimer laser radiation.

In the present work, the surface microtexture and chemical changes induced in human dentin by laser processing with KrF excimer laser radiation using fluences ranging from 0.5 to 20 J/cm2 were studied by SEM, XPS and FTIR. Two distinct behaviours were observed in the evolution of surface topography. In some samples, the laser-treated surface remained flat, independently of the fluence used. It was covered by a layer formed of redeposited ablation particles, which occluded the dentinal apertures. In other samples the surface topography depended on radiation fluence. When the fluence was lower than 1 J/cm2, preferential removal of intertubular dentin occurs, producing a columnar structure in which the columns are essentially formed of peritubular material. If the fluence exceeded 1 J/cm2 the processed surface was flat and covered with resolidified material. Despite these topographic changes, the dentin was not significantly affected by the laser treatment. The observed behaviour can be explained by differences in the constitution of dentin.

Carbon↗

PubMed2004

Ultrasonic cavitation in microspace.

Ultrasound was irradiated to a micro-1D and -2D space having a characteristic length of 200 microm, and the presence of cavitation was confirmed from video images, and the generation of OH radicals, which was quantitatively evaluated with fluorometry.

Journal Article↗

PubMed2004

Insights into the sonochemical decomposition of Fe(CO)5: theoretical and experimental understanding of the role of molar concentration and power density on the reaction yield.

The present work analyses, in detail, the optimization of a sonochemical process with respect to concentration of precursor and power supplied in a system. This is due to that even a small change in power dramatically changes the high-energy conditions created with the bubble collapse. A model reaction that has been considered for this purpose involves the decomposition of Fe(CO)5 in decalin solvent as this reaction is strongly influenced by the cavitation conditions. Sonochemical treatment of this carbonyl results in the formation of amorphous Fe2O3, which on heat treatment gives nanocrystalline Fe2O3. It has been observed that concentration and power density parameters play an important role to obtain higher decomposition of Fe(CO)5 and hence higher yield of the amorphous Fe2O3 product. Also, using the experimentally observed results, a correlation (polynomial) has been developed.

Journal Article↗

PubMed2002

Wastewater treatment: a novel energy efficient hydrodynamic cavitational technique.

A novel method of treating a dye solution has been studied by hydrodynamic cavitation using multiple hole orifice plates. The present work deals with the effect of geometry of the multiple hole orifice plates on the degradation of a cationic dye rhodamine B (rhB) solution. The efficiency of this technique has been compared with the cavitation generated by ultrasound and it has been found that there is substantial enhancement in the extent of degradation of this dye solution using hydrodynamic cavitation. Large-scale operation coupled with better energy efficiency makes this technique a viable alternative for conventional cavitational reactors.

Journal Article↗