PubMed Health⌕ Search

Biomedical subjects

Marie-Astrid Ottenhof

Publications and source records attributed to Marie-Astrid Ottenhof.

4 recordsLinked to original sources
PubMed2005

Comparative study of the retrogradation of intermediate water content waxy maize, wheat, and potato starches.

The retrogradation of extruded starches from three different botanical sources was studied in concentrated conditions (34 +/- 1% water) at 25 degrees C using differential scanning calorimetry (DSC) and isothermal calorimetry, Fourier transform infrared spectroscopy (FTIR), and wide-angle X-ray scattering. Potato starch showed the highest rate of retrogradation (approximately 0.17 h(-1)) followed by waxy maize (approximately 0.12 h(-1)), while the retrogradation of wheat starch was the slowest (approximately 0.05 h(-1)). In addition to the kinetics, the extent of molecular order in the retrograded samples was studied in detail in terms of "short-range" (helical) and "long-range" (crystalline) distance scales. The amylopectin crystallinity indices were essentially the same (approximately 47-51% amylopectin basis) for the three starches. However, significant differences were found in the enthalpy of melting measured by DSC after "full" retrogradation (potato, 11.6 +/- 0.7; waxy maize, 9.0 +/- 0.5; and wheat, 6.1 +/- 0.3 J/g of amylopectin). The degree of short-range molecular order in the retrograded state determined by FTIR was waxy maize > potato > wheat. The effect of amylopectin average chain length and the polymorphism of the crystalline phase were taken into account to explain the differences in the retrogradation enthalpies.

Amylopectin↗
PubMed2003

FTIR study of state and phase transitions of low moisture sucrose and lactose.

Mid-infrared spectra of freeze-dried sucrose and lactose systems were acquired over a range of temperatures (30-200 degrees C) and water contents (0-6.3%). Starting from the glassy state, the experimental conditions were selected to cover the main thermal transitions: the glass-rubber transition, the crystallisation and, for some samples, the subsequent melting. The FTIR spectra were very sensitive to the physical state. While subtle but systematic spectral differences between the glassy and rubbery states were detectable throughout the spectrum, a very pronounced increase in spectral resolution was observed as crystallisation occurred and was followed by the expected spectral broadening during melting. The temperatures at which these changes occurred were in satisfactory agreement with the transition temperatures measured by differential scanning calorimetry (DSC). The increase in molecular mobility as a result of increasing temperature or plasticisation by water led to a significant shift of the O-H stretching band to higher wavenumbers indicating a weakening of hydrogen bonding. This shift reached a maximum as the DSC measured crystallisation temperature range was approached. As expected, the crystallisation led to a highly effective hydrogen bonding network. This was more significant for lactose than for sucrose. No significant step change in hydrogen bonding was observed at Tg. As anticipated, the temperature at which these transitions occurred decreased with increasing water content but overlapped when observed in the context of the shifted temperature (T-Tg).

Calorimetry, Differential Scanning↗
PubMed2002

Monitoring chemical and physical changes during thermal flavor generation.

On-line techniques were developed to monitor chemical and physical changes occurring during the heating of skim milk powder (SMP). Atmospheric pressure chemical ionization mass spectrometry (APCIMS) followed the generation and release of volatile compounds from SMP in a packed-bed reactor. Operating conditions were optimized to avoid condensation of high boiling compounds such as maltol, and the system was highly reproducible (CV < 7%). Differential scanning calorimetry (DSC) of SMP identified a potential glass transition at an onset temperature of 67.9 degrees C and a series of exothermic events that were related to different stages of the Maillard reaction. No lactose crystallization was found after heating. Using a heated stage reflectance FTIR device, spectra were obtained at different temperatures. Analysis of the data showed a correlation between the intensity ratio at wavenumbers 1017 and 1064 cm(-1) and the glass transition measured by DSC. This FTIR system was not sensitive enough to detect Maillard intermediates. Combining data from the three techniques provides a fuller picture of the physical changes during the Maillard reaction and their effects on the chemical reactions.

Animals↗