Biomedical subjects

Mark van Loosdrecht

Publications and source records attributed to Mark van Loosdrecht.

6 recordsLinked to original sources

PubMed2006

On the reproducibility of microcosm experiments - different community composition in parallel phototrophic biofilm microcosms.

Phototrophic biofilms were cultivated simultaneously using the same inoculum in three identical flow-lane microcosms located in different laboratories. The growth rates of the biofilms were similar in the different microcosms, but denaturing gradient gel electrophoresis (DGGE) analysis of both 16S and 18S rRNA gene fragments showed that the communities developed differently in terms of species richness and community composition. One microcosm was dominated by Microcoleus and Phormidium species, the second microcosm was dominated by Synechocystis and Phormidium species, and the third microcosm was dominated by Microcoleus- and Planktothrix- affiliated species. No clear effect of light intensity on the cyanobacterial community composition was observed. In addition, DGGE profiles obtained from the cultivated biofilms showed a low resemblance with the profiles derived from the inoculum. These findings demonstrate that validation of reproducibility is essential for the use of microcosm systems in microbial ecology studies.

Biofilms↗

PubMed2006

rRNA and poly-beta-hydroxybutyrate dynamics in bioreactors subjected to feast and famine cycles.

Feast and famine cycles are common in activated sludge wastewater treatment systems, and they select for bacteria that accumulate storage compounds, such as poly-beta-hydroxybutyrate (PHB). Previous studies have shown that variations in influent substrate concentrations force bacteria to accumulate high levels of rRNA compared to the levels in bacteria grown in chemostats. Therefore, it can be hypothesized that bacteria accumulate more rRNA when they are subjected to feast and famine cycles. However, PHB-accumulating bacteria can form biomass (grow) throughout a feast and famine cycle and thus have a lower peak biomass formation rate during the cycle. Consequently, PHB-accumulating bacteria may accumulate less rRNA when they are subjected to feast and famine cycles than bacteria that are not capable of PHB accumulation. These hypotheses were tested with Wautersia eutropha H16 (wild type) and W. eutropha PHB-4 (a mutant not capable of accumulating PHB) grown in chemostat and semibatch reactors. For both strains, the cellular RNA level was higher when the organism was grown in semibatch reactors than when it was grown in chemostats, and the specific biomass formation rates during the feast phase were linearly related to the cellular RNA levels for cultures. Although the two strains exhibited maximum uptake rates when they were grown in semibatch reactors, the wild-type strain responded much more rapidly to the addition of fresh medium than the mutant responded. Furthermore, the chemostat-grown mutant culture was unable to exhibit maximum substrate uptake rates when it was subjected to pulse-wise addition of fresh medium. These data show that the ability to accumulate PHB does not prevent bacteria from accumulating high levels of rRNA when they are subjected to feast and famine cycles. Our results also demonstrate that the ability to accumulate PHB makes the bacteria more responsive to sudden increases in substrate concentrations, which explains their ecological advantage.

Biomass↗

PubMed2006

Effect of formaldehyde on biofilm activity and morphology in an ultracompact biofilm reactor for carbonaceous wastewater treatment.

The effects of formaldehyde on biofilm morphology and biomass activity were investigated in an ultracompact biofilm reactor (UCBR) for carbonaceous wastewater treatment. The wastewater contained a fixed amount of glucose (with a chemical oxygen demand concentration of 600 mg/L) and an increasing concentration of formaldehyde (ranging from 21.4 to 271.1 mg/L). An influent formaldehyde concentration higher than 75 mg/L could facilitate filamentous growth (on biofilm) control and lead to a higher biofilm density, which is desirable as it enhanced the UCBR performance stability. However, at an influent formaldehyde concentration higher than 214.4 mg/L, biomass production was inhibited and deteriorations of biofilm morphology and biomass activity were observed. This study showed that it was desirable to maintain an influent formaldehyde concentration lower than 202.2 mg/L, as this concentration could achieve a good biofilm morphology while not inhibiting its microbial activity.

Biodegradation, Environmental↗

PubMed2005

Nitrate-dependent [Fe(II)EDTA]2- oxidation by Paracoccus ferrooxidans sp. nov., isolated from a denitrifying bioreactor.

Enrichments with [Fe(II)EDTA]2- as electron donor and nitrate or nitrite as electron acceptor were established using an inoculum from a bioreactor performing denitrification. A nitrate-reducing, [Fe(II)EDTA]2- oxidizing strain was isolated and named strain BDN-1. The G + C content of strain BDN-1 was 67%, and the organism was closely affiliated to Paracoccus denitrificans, P. pantotrophus and P. versutus by 16S rRNA sequence comparison. Results from DNA-DNA hybridization, rep-PCR, and whole cell protein analysis gave congruent results confirming the genotypic and phenotypic differences between strain BDN-1 and the other species of Paracoccus. From these results, we considered strain BDN-1 as a novel species for which we propose the name Paracoccus ferrooxidans. Apart from [Fe(II)EDTA]2-, BDN-1 could also use thiosulfate and thiocyanate as inorganic electron donors. Nitrate, nitrite, N2O, [Fe(II)EDTA.NO]2- and oxygen could be used by strain BDN-1 as electron acceptors. Repeated transfer on a culture medium with bicarbonate as the sole carbon source confirmed that strain BDN-1 was a facultative autotroph. [Fe(II)EDTA]2- oxidation dependent denitrification was also performed by other Paracoccus species, that were closely affiliated to P. ferrooxidans.

Bacterial Proteins↗

PubMed2005

Modeling biofilm and floc diffusion processes based on analytical solution of reaction-diffusion equations.

Biofilm modeling is often considered as a complex mathematical subject. This paper evaluates simple equations to describe the basic processes in a biofilm system with the main aim to show several interesting applications. To avoid mathematical complexity the simulations are carried out in a simple spreadsheet. Frequently, only the solution for zero-order reaction kinetics of the reaction-diffusion equation is used (better known as half-order kinetics). A weighted average of the analytical solutions for zero- and first-order reactions is proposed as basic and useful model to describe steady-state (in biofilm composition) biofilm reactors. This approach is compared with several modeling approaches, such as the simple solution for zero-order reaction and more complex ones (i) direct numerical solution for the diffusion equations, (ii) 1-D AQUASIM and (iii) 2-D modeling. The systems evaluated are single and multiple species biofilms. It is shown that for describing conversions in biofilm reactors, the zero-order solution is generally sufficient; however, for design purposes large deviations of the correct solution can occur. Additionally, the role of diffusion in flocculated and granular sludge systems is discussed. The relation between the measured (apparent) substrate affinity constant and diffusion processes is outlined.

Biofilms↗

PubMed2003

Growth physiology and competitive interaction of obligately chemolithoautotrophic, haloalkaliphilic, sulfur-oxidizing bacteria from soda lakes.

Two different groups of haloalkaliphilic, obligately autotrophic, sulfur-oxidizing bacteria belonging to the genera Thioalkalimicrobium and Thioalkalivibrio have recently been discovered in highly alkaline and saline soda lakes. To understand response to their extreme environment and different occurrence in soda lakes, the growth kinetics and competitive behavior of several representatives have been characterized in detail using batch and pH-controlled continuous cultivation. The bacteria belong to the true alkaliphiles, growing within the pH range 7.5-10.6 with maximum growth rate and maximum growth yield at pH 9.5-10. On the basis of their response to salt content, three groups can be identified. All the Thioalkalimicrobium strains and some of the Thioalkalivibrio strains belonged to the moderate halophiles. Some of the Thioalkalivibrio strains from hypersaline soda lakes were extremely salt-tolerant and capable of growth in saturated soda brines. The Thioalkalimicrobium strains demonstrated relatively high specific growth rates, low growth yield, high maintenance, and extremely high rates of thiosulfate and sulfide oxidation. In contrast, the Thioalkalivibrio strains, in general, were slow-growing, high-yield organisms with lower maintenance and much lower rates of oxidation of sulfide and thiosulfate. Moreover, the latter survived starvation much better than Thioalkalimicrobium. Different growth characteristics and salt resistance appear to determine the outcome of the enrichment cultures from different soda lakes: Thioalkalimicrobium dominated in the enrichments with freshly obtained samples from diluted soda lakes at low-medium salinity, while Thioalkalivibrio was the predominant organism in enrichments from aged samples and at hypersaline conditions. In mixed thiosulfate-limited chemostat cultures at low salinity, Thioalkalimicrobium strains (mu(max)=0.33 h(-1)) out-competed Thioalkalivibrio strains (mu(max)=0.15 h(-1)) at D>0.02 h(-1). The overall results suggest that Thioalkalimicrobium and Thioalkalivibrio represent two different ecological strategies.

Bacteria↗