PubMed Health⌕ Search

Biomedical subjects

Martin Schuettler

Publications and source records attributed to Martin Schuettler.

4 recordsLinked to original sources
PubMed2006

Design, in vitro and in vivo assessment of a multi-channel sieve electrode with integrated multiplexer.

This paper reports on the design, in vitro and in vivo investigation of a flexible, lightweight, polyimide based implantable sieve electrode with a hybrid assembly of multiplexers and polymer encapsulation. The integration of multiplexers enables us to connect a large number of electrodes on the sieve using few input connections. The implant assembly of the sieve electrode with the electronic circuitry was verified by impedance measurement. The 27 platinum electrodes of the sieve were coated with platinum black to reduce the electrode impedance. The impedance magnitude of the electrode sites on the sieve (geometric surface area 2,200 microm(2)) was |Z(f=1kHz)| = 5.7 kOmega. The sieve electrodes, encased in silicone, have been implanted in the transected sciatic nerve of rats. Initial experiments showed that axons regenerated through the holes of the sieve and reinnervated distal target organs. Nerve signals were recorded in preliminary tests after 3-7 months post-implantation.

Action Potentials↗
PubMed2006

Very low-noise ENG amplifier system using CMOS technology.

In this paper, we describe the design and testing of a system for recording electroneurographic signals (ENG) from a multielectrode nerve cuff (MEC). This device, which is an extension of the conventional nerve signal recording cuff, enables ENG to be classified by action potential velocity. In addition to electrical measurements, we provide preliminary in vitro data obtained from frogs that demonstrate the validity of the technique for the first time. Since typical ENG signals are extremely small, on the order of 1 1 microV, very low-noise, high-gain amplifiers are required. The ten-channel system we describe was realized in a 0.8 microm CMOS technology and detailed measured results are presented. The overall gain is 10 000 and the total input-referred root mean square (rms) noise in a bandwidth 1 Hz-5 kHZ is 291 nV. The active area is 12 mm(2) and the power consumption is 24 mW from +/-2.5 V power supplies.

Action Potentials↗
PubMed2003

Noninvasive measurement of torque development in the rat foot: measurement setup and results from stimulation of the sciatic nerve with polyimide-based cuff electrodes.

In neural rehabilitation, selective activation of muscles after electrical stimulation is mandatory for control of paralyzed limbs. For an evaluation of electrode selectivity, a setup to noninvasively measure the force development after electrical stimulation in the rat foot was developed. The setup was designed in accordance to the anatomical features of the rat model to test the isometric torque development at given ankle positions in an intact leg. In this paper, the setup design and development is presented and discussed. In a first study, the selectivity of small nerve cuffs with 12 electrodes implanted around the rat sciatic nerve was investigated. Special attention was drawn to the performance of the torque measurement setup in comparison to electrophysiological data obtained from compound muscle action potential recordings. Using one cuff around the nerve, electrical stimulation on different electrode tripoles led to plantarflexion and dorsiflexion of the foot without an a priori alignment of the cuff.

Animals↗