Biomedical subjects

Maryanne C J Large

Publications and source records attributed to Maryanne C J Large.

5 recordsLinked to original sources

PubMed2006

Exaggeration and suppression of iridescence: the evolution of two-dimensional butterfly structural colours.

Many butterfly species possess 'structural' colour, where colour is due to optical microstructures found in the wing scales. A number of such structures have been identified in butterfly scales, including three variations on a simple multi-layer structure. In this study, we optically characterize examples of all three types of multi-layer structure, as found in 10 species. The optical mechanism of the suppression and exaggeration of the angle-dependent optical properties (iridescence) of these structures is described. In addition, we consider the phylogeny of the butterflies, and are thus able to relate the optical properties of the structures to their evolutionary development. By applying two different types of analysis, the mechanism of adaptation is addressed. A simple parsimony analysis, in which all evolutionary changes are given an equal weighting, suggests convergent evolution of one structure. A Dollo parsimony analysis, in which the evolutionary 'cost' of losing a structure is less than that of gaining it, implies that 'latent' structures can be reused.

Adaptation, Physiological↗

PubMed2006

Hollow-core microstructured polymer optical fiber.

We have fabricated microstructured polymer optical fibers that guide light in a hollow core using the photonic bandgap mechanism. The hollow core allows the use of polymer fibers to be extended to wavelength ranges where material absorption typically prohibits their use, with attenuation lower than the material loss observed in the infrared. The fabrication method is similar to other microstructured polymer optical fibers, which has favorable implications for the feasibility of manufacturing such bandgap fibers.

Journal Article↗

PubMed2005

Continuous wave ultraviolet light-induced fiber Bragg gratings in few- and single-mode microstructured polymer optical fibers.

We report observations and measurements of the inscription of fiber Bragg gratings (FBGs) in two different types of microstructured polymer optical fiber: few-mode and an endlessly single mode. Contrary to the FBG inscription in silica microstructured fiber, where high-energy laser pulses are a prerequisite, we have successfully used a low-power cw laser source operating at 325 nm to produce 1 cm long gratings with a reflection peak at 1570 nm. Peak reflectivities of more than 10% have been observed.

Journal Article↗

PubMed2004

Fabrication and study of microstructured optical fibers with elliptical holes.

We report the fabrication of what are believed to be the first microstructured optical fibers with uniformly oriented elliptical holes. A high degree of hole ellipticity is achieved with a simple technique that relies on hole deformation during fiber draw. Both form and stress-optic birefringence are characterized over a broad wavelength range. These measurements are in excellent agreement with numerical modeling and demonstrate a birefringence as high as 1.0 x 10(-4) at a wavelength of 850 nm.

Journal Article↗

PubMed2004

Small-core single-mode microstructured polymer optical fiber with large external diameter.

A preform sleeving technique is demonstrated that allows the fabrication of single-mode polymer microstructured fiber with the smallest core and hole dimensions yet reported to our knowledge. For a fixed triangular hole pattern a range of fibers is produced by adjustment to the operating conditions of the draw tower. Numerical modeling is carried out for one of the fibers produced with a 570-microm external diameter, a core diameter of 2.23 microm, an average hole diameter of 0.53 microm, and an average hole spacing of 1.38 microm. This fiber was shown to be endlessly single mode.

Journal Article↗