Masami Kageshima | PubMed Health

PubMed2006

Origin of p(2 x 1) phase on Si(001) by noncontact atomic force microscopy at 5 k.

The controversial issue of the origin of the p(2 x 1) reconstruction of the Si(001) surface observed in recent low temperature scanning tunneling microscopy experiments is clarified here using 5 K noncontact atomic force microscopy. The c(4 x 2) phase is observed at separations corresponding to weak tip-surface interactions, confirming that it is the ground state of the surface. At larger frequency shifts the p(2 x 1) phase of symmetric dimers is observed. By studying the interaction of a reactive Si tip with the c(4 x 2) Si(001) surface using an ab initio method, we find that the observed change in the surface reconstruction is an apparent effect caused by tip induced dimer flipping resulting in a modification of the surface structure and appearance of the p(2 x 1) phase in the image. Using an appropriate scanning protocol, one can manipulate the surface reconstruction at will, which has significance in nanotechnology.

Journal Article↗

PubMed2004

Mechanical force analysis of peptide interactions using atomic force microscopy.

Some peptides have previously been reported to bind low molecular weight chemicals. One such peptide with the amino acid sequence His-Ala-Ser-Tyr-Ser was selectively screened from a phage library and bound to a cationic porphyrin, 5,10,15,20-tetrakis(N-methylpyridinium-4-yl)-21H,23H-porphine (TMpyP), with a binding constant of 10(5) M(-1) (J. Kawakami, T. Kitano, and N. Sugimoto, Chemical Communications, 1999, pp. 1765-1766). The proposed binding was due to pi-electron stacking from two aromatic amino acids of histidine and tyrosine. In this study, the weak interactions between TMpyP and the peptide were further investigated by force curve analysis using atomic force microscopy (AFM). The mechanical force required to unbind the peptide-porphyrin complex was measured by vertical movement of the AFM tip. Peptide self-assembled monolayers were formed on both a gold-coated mica substrate and a gold-coated AFM tip. The TMpyPs could bind between the two peptide layers when the peptide-immobilized AFM tip contacted the peptide-immobilized substrate in solution containing TMpyP. In the retracting process a force that ruptured the interaction between TMpyPs and peptides was observed. The unbinding force values correlated to the concentration of TMpyP. A detection limit of 100 ng/mL porphyrin was obtained for the force measurement, and was similar to surface plasmon resonance sensor detection limits. Furthermore, we calculated the product of the observed force and the length of the molecular elongation to determine the work required to unbind the complexes. The obtained values of unbinding work were in a reasonable range compared to the binding energy of porphyrin-peptide.

Biomechanical Phenomena↗