PubMed Health⌕ Search

Biomedical subjects

Masanori Mitome

Publications and source records attributed to Masanori Mitome.

6 recordsLinked to original sources

Visibility of Si nanoparticles embedded in an amorphous SiO2 matrix.

The visibility of a Si crystalline nanoparticle of diameter 2 nm embedded in an amorphous SiO(2) layer is evaluated quantitatively by multislice calculation. The visibility depends on the crystal orientation of the Si nanoparticle, the thickness of the amorphous SiO(2) layer and the defocus. Scherzer defocus always gives the highest visibility at any crystal orientation. The visibility is higher when the incident beam is parallel to the (111) planes and the (111) fringes are most visible. The image of a Si nanoparticle is obscured by random images from the amorphous SiO(2) layer and the Si nanoparticle becomes invisible when it is misoriented or the amorphous layer is thicker than 60 nm. The probability that a Si nanoparticle can be distinguished from the random noise of amorphous images is 89% when the thickness of the amorphous SiO(2) layer is 12 nm, but this is reduced to 21% when the layer is 48 nm thick. These quantitative results are useful when estimating the density of Si nanoparticles including invisible nanoparticles.

Nanoparticles↗

Transmission electron microscopy and electron diffraction study of the short-range ordering structure of alpha-LiFeO2.

The basic structure of alpha-LiFeO2, lithium iron oxide, is a cubic NaCl-type structure with a lattice constant of 0.42 nm; some short-range ordering characterized by octahedral clusters exists. The local structure of the short-range ordering was investigated by transmission electron microscopy and electron diffraction. A new short-range ordering structure was found in local areas. The local structure has a cubic lattice with a doubled lattice constant. The occupation factors of cations on Wyckoff sites 4(a) and 4(b) are different from those on 24(d) sites, but the stoichiometric composition in cubic clusters is the same as the macroscopic composition. The number of pairs in which iron cations exist in nearest-neighbor sites and next nearest-neighbor sites is reduced in the structure. This means that a magnetic interaction between the iron cations is reduced by cation ordering even without spin ordering at room temperature.

Journal Article↗

Unusual freezing and melting of gallium encapsulated in carbon nanotubes.

The freezing and melting behavior of gallium (Ga) encapsulated in carbon nanotubes was investigated through in situ observation in a transmission electron microscope. It is shown that Ga remains liquid up to -80 degrees C when encapsulated in carbon nanotubes. Results of detailed electron diffraction analysis show that the encapsulated Ga can crystallize in either beta phase or gamma phase rather than the common alpha phase upon freezing. Both beta-Ga and gamma-Ga melt at around -20 degrees C. While this is very close to the melting point of bulk beta-Ga (-16 degrees C), it is considerably higher than that of bulk gamma-Ga (-35.6 degrees C). It was observed that upon solidification, Ga has its unique crystallographic orientation relative to the host carbon nanotube.

Journal Article↗

Nanoanalysis by a high-resolution energy filtering transmission electron microscope.

An energy-filtering transmission electron microscope with 300 kV acceleration voltage was developed and the spatial resolution of elemental distribution images was improved. Observing oxygen monolayers in Al(11)O(3)N(9), it was shown that the actual resolution attained is up to 0.5 nm. Surface plasmon loss images of silver particles were taken with a resolution of better than 0.4 nm. Furthermore, the sensitivity is sufficiently high to distinguish indium content differences of 2.5 atomic percent in In(x)Al(1-x)As. This performance is good enough to analyze elemental distribution with atomic-level resolution. Furthermore, since analysis with the energy-filtering microscope is easy and practical, nanoanalysis may come into wide use not only in academic fields but also in industry.

Journal Article↗

Formation, structure, and structural properties of a new filamentary tubular form: hollow conical-helix of graphitic boron nitride.

A novel tubular form of graphitic boron nitride (BN) displaying a hollow conical-helix was discovered. It was generated via wrapping a single beltlike filament according to the geometry of an Archimedes spiral. Cone apex angles of helical-conical nanotubes (HCNTs) were found to exhibit specific values, each of which refers to a certain coincidence site lattice. A unique structural property of HCNTs was observed, displaying the transformation of apex angles during the annealing process. The observed apex angles were reduced with decreasing annealing temperature, which is in accordance with an estimated HCNT strain energy decrease for a given tubular radius. It is suggested that the curvature and apex angle of a HCNT are determined by a sole dynamic element, that is, enthalpy (DeltaH), whereas the HCNT disclination configuration changes through helical sliding of the filament.

Journal Article↗

In situ electrical measurements and manipulation of B/N-doped C nanotubes in a high-resolution transmission electron microscope.

B/N-doped multiwalled C nanotubes were electrically probed by means of a tungsten needle attached to a piezo-driven stage of a high-resolution transmission electron microscope holder. Two-terminal transport measurements were performed in a 'W needle-nanotube-ground' circuit. The I-V curves were recorded in situ while viewing the nanotubes in the imaging mode of the microscope. This allows us to trace nanotube array morphological changes under applied voltage (up to 50 V). Specific manipulation with nanotube assemblies was found to be possible under applied electrical field: attachment of a tiny nanotube bundle to the W needle and extraction of a given nanotube fragment from an entangled complex bunch were achieved. The electrically-probed B/N-doped C nanotubes exhibited alternating B-rich and C-rich B-C-N domains within tubular layers, as revealed by elemental mapping during energy-filtered TEM (Omega filter). At room temperature the nanostructures displayed resistivity (rho) of approximately 1.8 x 10(-5) omegam and linear I-V curves. The key role of a given contact between the probing needle and a nanotube during electrical measurements was particularly verified.

Electricity↗