PubMed Health⌕ Search

Biomedical subjects

Mathias Brust

Publications and source records attributed to Mathias Brust.

18 recordsLinked to original sources
PubMed2007

Design of polymeric stabilizers for size-controlled synthesis of monodisperse gold nanoparticles in water.

A new methodology is described for the one-step aqueous preparation of highly monodisperse gold nanoparticles with diameters below 5 nm using thioether- and thiol-functionalized polymer ligands. The particle size and size distribution was controlled by subtle variation of the polymer structure. It was shown that poly(acrylic acid) (PAA) and poly(methacrylic acid) (PMAA) were the most effective stabilizing polymers in the group studied and that relatively low molar mass ligands (approximately 2500 g/mol) gave rise to the narrowest particle size distributions. Particle uniformity and colloidal stability to changes in ionic strength and pH were strongly affected by the hydrophobicity of the ligand end group. "Multidentate" thiol-terminated ligands were produced by employing dithiols and tetrathiols as chain-transfer agents, and these ligands gave rise to particles with unprecedented control over particle size and enhanced colloidal stability. It was found throughout that dynamic light scattering (DLS) is a very useful corroboratory technique for characterization of these gold nanoparticles in addition to optical spectroscopy and TEM.

Avidin↗
PubMed2006

Thiol-specific and nonspecific interactions between DNA and gold nanoparticles.

The contribution of nonspecific interactions to the overall interactions of thiol-ssDNA and dsDNA macromolecules with gold nanoparticles was investigated. A systematic investigation utilizing dynamic light scattering and cryogenic transmission electron microscopy has been performed to directly measure and visualize the changes in particle size and appearance during functionalization of gold nanoparticles with thiol-ssDNA and nonthiolated dsDNA. The results show that both thiol-ssDNA and dsDNA do stabilize gold nanoparticle dispersions, but possible nonspecific interactions between the hydrophobic DNA bases and the gold surface promote interparticle interactions and cause aggregation within rather a short period of time. We also discuss the adsorption mechanisms of dsDNA and thiol-ssDNA to gold particles.

Adsorption↗
PubMed2006

Formation of spherical nanostructures by the controlled aggregation of gold colloids.

Stable suspensions of size-uniform spherical assemblies of 5-8 nm gold colloids in toluene are readily obtained by cross linking the colloidal particles using alkanedithiols within a defined range of gold-dithiol molar ratios. The assemblies are very stable and remain suspended in toluene for several months without significant aggregation. These porous gold spheres can be further organized into hierarchically assembled relatively linear chains by the addition of ethanol.

Gold Colloid↗
PubMed2006

Kinase-catalyzed modification of gold nanoparticles: a new approach to colorimetric kinase activity screening.

Peptide-stabilized gold nanoparticles have been enzymatically biotinylated by a kinase-catalyzed reaction using biotin-ATP as a cosubstrate. Upon mixing with avidin-modified particles, solutions of biotinylated particles change color from red to blue, indicating aggregation of particles. On the basis of this reaction, we have developed a simple colorimetric test to monitor kinase inhibitor activity.

Avidin↗
PubMed2005

Aligned two- and three-dimensional structures by directional freezing of polymers and nanoparticles.

The preparation of materials with aligned porosity in the micrometre range is of technological importance for a wide range of applications in organic electronics, microfluidics, molecular filtration and biomaterials. Here, we demonstrate a generic method for the preparation of aligned materials using polymers, nanoparticles or mixtures of these components as building blocks. Directional freezing is used to align the structural elements, either in the form of three-dimensional porous structures or as two-dimensional oriented surface patterns. This simple technique can be used to generate a diverse array of complex structures such as polymer-inorganic nanocomposites, aligned gold microwires and microwire networks, porous composite microfibres and biaxially aligned composite networks. The process does not involve any chemical reaction, thus avoiding potential complications associated with by-products or purification procedures.

Anisotropy↗
PubMed2005

Microarray-based detection of protein binding and functionality by gold nanoparticle probes.

We report a microarray format for the detection of proteins and protein functionality (kinase activity) based on marking either specific antibody-protein binding or peptide phosphorylation events by attachment of gold nanoparticles followed by silver deposition for signal enhancement. The attachment of the gold nanoparticles is achieved by standard avidin-biotin chemistry. The detection principle is resonance light scattering. Highly selective recognition of standard proteins (proteins A and G) down to 1 pg/mL for proteins in solution and 10 fg for proteins on the microarray spots is demonstrated. Enzyme activity of the kinase (PKA) is detected with high specificity down to a limit of 1 fg for an established peptide substrate (kemptide) on the microarray spots. Kinase inhibition by the inhibitor (H89) is shown, demonstrating the potential for high-throughput screening for inhibitors.

Gold↗
PubMed2004

Rational and combinatorial design of peptide capping ligands for gold nanoparticles.

Based on protein folding considerations, a pentapeptide ligand, CALNN, which converts citrate-stabilized gold nanoparticles into extremely stable, water-soluble gold nanoparticles with some chemical properties analogous to those of proteins, has been designed. These peptide-capped gold nanoparticles can be freeze-dried and stored as powders that can be subsequently redissolved to yield stable aqueous dispersions. Filtration, size-exclusion chromatography, ion-exchange chromatography, electrophoresis, and centrifugation can be applied to these particles. The effect of 58 different peptide sequences on the electrolyte-induced aggregation of the nanoparticles was studied. The stabilities conferred by these peptide ligands depended on their length, hydrophobicity, and charge and in some cases resulted in further improved stability compared with CALNN, yielding detailed design criteria for peptide capping ligands. A simple strategy for the introduction of recognition groups is proposed and demonstrated with biotin and Strep-tag II.

Amino Acid Sequence↗
PubMed2004

Adaptive chemistry of bifunctional gold nanoparticles at the air/water interface. A synchrotron X-ray study of giant amphiphiles.

A series of ligand stabilized gold nanoparticles with diameters close to 3 nm were studied as Langmuir monolayers at the air/water interface by synchrotron X-ray diffraction and reflectivity. Alkylthiols with different length and/or terminal functional group (hydrophilic or hydrophobic) were introduced into the ligand shell by ligand place exchange reactions. Synchrotron grazing incidence X-ray diffraction (GIXD) and specular X-ray reflectivity reveal the well known hexagonally packed monolayers. In addition the mixed hydrophilic/hydrophobic ligand shell nanoparticles show a high degree of environmental responsiveness, as they adapt to an amphiphilic distribution of ligands around the gold core when spread at the water surface. Likewise nanoparticles of mixed long and short alkyl chains respond to lateral pressure by adopting a structure where the short alkyl chains determine the in-plane nearest neighbor distance while the long alkyl chains determine the film thickness. Based on X-ray reflectivity measurements, which quantitatively account for the electron density in the monolayers, combined with GIXD we calculate the average size and number of atoms of the individual gold particle cores, and estimate the number of passivating ligand on the particle surface. Typical values are dAU-core = 16 A, dnanoparticle = 26-37 A depending on the ligands, Mw = 30-40000 g mol(-1) number of ligands = 40-60. The thickness of the monolayers was determined by AFM after transfer of the monolayers to a solid support using the Langmuir Schaefer technique. The combination of the different techniques produce a very consistent picture of the structure and adaptive chemical nature of the nanoparticles studied, and reveal a surprisingly monodisperse particle distribution centered around 140 atoms in the gold core.

Air↗
PubMed2002

Thioalkylated tetraethylene glycol: a new ligand for water soluble monolayer protected gold clusters.

Ligand-stabilised, water-soluble gold nanoparticles of two different size ranges (2-4 and 5-8 nm) are readily prepared using monohydroxy (1-mercaptoundec-11-yl) tetraethylene glycol as a novel capping agent. These nanoparticles are as stable as alkylthiol-capped monolayer protected clusters (MPCs) and do not aggregate from aqueous solution under a wide range of stringent conditions. It is expected that this new material will be useful for a number of bio-analytical applications.

Glycols↗
PubMed2002

The fate of sulfur-bound hydrogen on formation of self-assembled thiol monolayers on gold: (1)H NMR spectroscopic evidence from solutions of gold clusters.

It is demonstrated that thiols can adsorb to gold without losing hydrogen. Dodecyl sulfide-capped gold clusters have been prepared and subjected to ligand exchange reactions in perdeuterated benzene by addition of dodecanethiol and subsequently dodecyl disulfide. It is shown by 1H NMR spectroscopy that dodecanethiol molecules are readily taken up as ligands producing characteristic broad signals corresponding to the alpha-methylene and S-H protons, with chemical shifts close to those found for thiol in solution; these signals are absent in spectra of thiolate-capped clusters. Addition of excess disulfide to such clusters capped with both dialkyl sulfides and thiols leads to the appearance of sharp signals for free dialkyl sulfide and intact thiol. Amounts of thiols up to 50% of the ligand shell are, however, taken up by the clusters under rapid and irreversible loss of hydrogen.

Journal Article↗
PubMedDate not supplied

The peptide route to multifunctional gold nanoparticles.

Extremely stable, peptide-capped gold nanoparticles with two different biomolecular recognition motifs expressed on their surface have been prepared, and their specific and selective binding to artificial, DNA-modified target particles and to DNA and protein microarrays has been demonstrated. Stabilization and biofunctionalization has been achieved in a single preparative step starting with citrate-stabilized gold hydrosols and a derivatization cocktail of peptide-capping ligands, which carry the functionalities of choice.

Base Sequence↗
PubMedDate not supplied

Bionanoconjugation via click chemistry: The creation of functional hybrids of lipases and gold nanoparticles.

A simple and versatile method for the preparation of functional enzyme-gold nanoparticle conjugates using "click" chemistry has been developed. In a copper-catalyzed 1,2,3-triazole cycloaddition, an acetylene-functionalized Thermomyces lanuginosus lipase has been attached to azide-functionalized water-soluble gold nanoparticles under retention of enzymatic activity. The products have been characterized by gel electrophoresis and a fluorometric lipase activity assay. It is estimated that the equivalent of approximately seven fully active lipase molecules are attached to each nanoparticle.

Gold↗