Biomedical subjects

Mitchel J Doktycz

Publications and source records attributed to Mitchel J Doktycz.

6 recordsLinked to original sources

PubMed2006

Reversible electrowetting of vertically aligned superhydrophobic carbon nanofibers.

Reversible electrostatically induced wetting (electrowetting) of vertically aligned superhydrophobic carbon nanofibers has been investigated. Carbon nanofibers on a 5 x 5 microm pitch were grown on Si substrates, electrically insulated with a conformal dielectric, and hydrophobized with fluoropolymer. This nanostructured scaffold exhibited superhydrophobic behavior for saline (theta approximately 160 degrees). Electrowetting induced a contact angle reduction to theta approximately 100 degrees. Competitive two-liquid (dodecane/saline) electrowetting exhibited reversibility on the same nanostructured scaffold. Without applied bias, ultra-fine-point tip (approximately 25 nm radius) nanofibers result in effectively zero capacitance with the overlying saline layer. Complete electrowetting of the substrate is confirmed as capacitance values increase by several orders of magnitude with increased wetting. These results demonstrate the applicability of reversible electrowetting on nanostructured scaffolds and use of nanofabricated structures that can be integrated with various micro- and nanoelectronic technologies.

Electrons↗

PubMed2006

Evaluation of a surface-sampling probe electrospray mass spectrometry system for the analysis of surface-deposited and affinity-captured proteins.

A combined self-aspirating electrospray emitter/surfacing-sampling probe coupled with an ion trap mass spectrometer was used to sample and mass analyze proteins from surfaces. The sampling probe mass spectrometer system was used to sample and detect lysozyme that had been deposited onto a glass slide using a piezoelectric spotter or murine gamma-interferon affinity captured on a glass slide using surface-immobilized anti-gamma-interferon antibody. The detection level for surface-deposited lysozyme (spot size < or =200 microm) was approximately 1.0 fmol (approximately 100 fmol/mm2) as determined from the ability to measure accurately the protein molecular mass from the mass spectrum acquired by sampling the deposit. These detection limits may be sufficient for certain applications in which protein fractions from a separation method are collected onto a surface. Radiolabeled proteins were used to quantify the surface density of immobilized antibody and the efficiency of capture of the gamma-interferon on glass and higher surface area ceramic supports. The capture density of gamma-interferon at surface saturation ranged from about 23 to 50 fmol/mm2 depending on the capture surface. Nonetheless, mass spectrometric detection of affinity capture protein was successful in some cases, but the results were not reproducible. Thus, improvement of the sampling system, ionization efficiency and/or capture density will be necessary for practical sampling of affinity-captured proteins. The means to accomplish improved sampling system detection limits and to increase the absolute amounts of protein captured per unit area are discussed.

Affinity Labels↗

PubMed2004

Surface patterning of silica nanostructures using bio-inspired templates and directed synthesis.

Natural systems excel in directing the synthesis of inorganic materials for various functional purposes. One of the best-studied systems is silica synthesis, as occurs in diatoms and marine sponges. Various biological and synthetic polymers have been shown to template and catalyze silica formation from silicic acid precursors. Here, we describe the use of poly-L-lysine to promote the synthesis of silica in neutral, aqueous solution and when immobilized onto a silicon support structure under similar conditions. Either reagent jetting or conventional photolithography techniques can be used to pattern the templating polymer. Spots created by reagent jetting led to the creation of silica structures in the shape of a ring that may be a result of the spotting process. Photolithographically defined poly-L-lysine spots led to thin laminate structures after exposure to a dilute aqueous silicic acid solution. The laminate structures were nanostructured and highly interconnected. Photolithographic patterning of (3-aminopropyl)trimethoxysilane, a reagent that mimics the lysine functional group, led to similar silica coatings even though low-molecular-weight materials do not rapidly promote silica synthesis in solution. This result highlights the importance of functional-group arrangement for templating and promoting the synthesis of inorganic materials. The described surface-patterning techniques offer a route to integrate conventional silicon-patterning technologies with biologically based material synthesis. Such combined fabrication techniques enable controlled assembly over multiple length scales and an approach to understanding interfacial silica synthesis, as occurs in natural systems.

Biomimetics↗

PubMed2004

Optimized beadmilling of tissues for high-throughput RNA production and microarray-based analyses.

The preparation of RNA samples has become the rate-limiting step when performing genome-scale analyses by DNA microarrays. Methods to improve throughput of RNA isolation from tissues are needed. The effects of bead size and composition for disrupting mouse tissues have been evaluated in small centrifuge tubes and optimized for RNA production. The resulting process is inexpensive, resistant to cross-contamination, and amenable to robotic processing. After optimization, very-high-quality RNA can be produced. Comparisons between RNAs isolated by beadmilling (followed by solid-phase purification) and those by conventional isolation processes show that RNA produced by beadmilling is suitable for microarray analyses. Parallel implementation of beadmilling will enable a high-throughput tissue-to-RNA processing system for large-scale microarray analyses.

Animals↗

PubMed2003

Fingerprinting of prokaryotic 16S rRNA genes using oligodeoxyribonucleotide microarrays and virtual hybridization.

An oligonucleotide microarray hybridization system to differentiate microbial species was designed and tested. Seven microbial species were studied, including one Bacillus and six Pseudomonas strains. DNA sequences near the 5' end of 16S rRNA genes were aligned and two contiguous regions of high variability, flanked by highly conserved sequences, were found. The conserved sequences were used to design PCR primers which efficiently amplified these polymorphic regions from all seven species. The amplicon sequences were used to design 88 9mer hybridization probes which were arrayed onto glass slides. Single-stranded, fluorescence-tagged PCR products were hybridized to the microarrays at 15 degrees C. The experimental results were compared with the DeltaG(0) values for all matched and mismatched duplexes possible between the synthetic probes and the 16S target sequences of the seven test species, calculated using a 'virtual hybridization' software program. Although the observed hybridization patterns differed significantly from patterns predicted solely on the basis of perfect sequence matches, a unique hybridization fingerprint was obtained for each of the species, including closely related Pseudomonas species, and there was a reasonable correlation between the intensity of observed hybridization signals and the calculated DeltaG(0) values. The results suggest that both perfect and mismatched pairings can contribute to microbial identification by hybridization fingerprinting.

Bacillus↗

PubMed2002

Genomes to Life "Center for Molecular and Cellular Systems": a research program for identification and characterization of protein complexes.

Goal 1 of Department of Energy's Genomes to Life (GTL) program seeks to identify and characterize the complete set of protein complexes within a cell. Goal 1 forms the foundation necessary to accomplish the other objectives of the GTL program, which focus on gene regulatory networks and molecular level characterization of interactions in microbial communities. Together this information would allow cells and their components to be understood in sufficient detail to predict, test and understand the responses of a biological system to its environment. The Center for Molecular and Cellular Systems has been established to identify and characterize protein complexes using high through-put analytical technologies.A dynamic research program is being developed that supports the goals of the Center by focusing on the development new capabilities for sample preparation and complex separations, molecular level identification of the protein complexes by mass spectrometry, characterization of the complexes in living cells by imaging techniques, and bioinformatics and computational tools for the collection and interpretation of data and formation of databases and tools to allow the data to be shared by the biological community.

Animals↗