PubMed Health⌕ Search

Biomedical subjects

Mohamed Daoud

Publications and source records attributed to Mohamed Daoud.

2 recordsLinked to original sources

Assembling and compressing a semifluorinated alkane monolayer on a hydrophobic surface: structural and dielectric properties.

We investigate the dynamic behavior upon lateral compression of a semifluorinated alkane F (CF2)8(CH2)18H (denoted F8H18), spread on the hydrophobic top of a suitable amphiphilic monolayer: namely, a natural alpha-helix alamethicin peptide (alam). We show, in particular, the formation of an asymmetric flat bilayer by compressing at the air-water interface a mixed Langmuir film made of F8H18 and alam. The particular chemical structure of F8H18 , the suitable structure of the underlying alam monolayer and its collapse properties, allow for a continuous compression of the upper F8H18 monolayer while the density of the lower alam monolayer remains constant. Combining grazing incidence x-ray reflectivity, surface potential, and atomic force microscopy data allow for the determination of the orientation and dielectric constant of the upper F8H18 monolayer.

Journal Article↗

beta-casein and symmetrical triblock copolymer (PEO-PPO-PEO and PPO-PEO-PPO) surface properties at the air-water interface.

A comparison of beta-casein and symmetrical triblock copolymer (PEO-PPO-PEO and PPO-PEO-PPO) adsorption layer properties at the air-water interface has been carried out by bubble tensiometry and ellipsometry. It has been verified that the equation of state parameters (pi approximately gamma(y)) obtained from surface pressure (pi) and ellipticity in Brewster conditions (rhoB), which is proportional to the surface concentration (gamma) data, are the same as those obtained from dilational modulus epsilon and pi data. These two consistent approaches give further support to the theoretical model of block copolymers which has been previously developed for protein adsorption at fluid interfaces. It is shown that the interfacial behavior of the copolymer adsorption layer changes strongly as a function of the length of the hydrophilic and hydrophobic block sequences. The theoretical model may be used for the interpretation of the adsorption properties of the synthetic copolymers only when the size of the blocks is large enough. In the case of block copolymers, the coil is in a self-avoiding walk conformation (y = 3) whatever the temperature, while in the case of beta-casein, the polypeptide chain is partly collapsed at room temperature due to thermolabile noncovalent bonds. At the end of the first semidilute regime, there is clear evidence for a crossover toward a second semidilute regime for synthetic copolymers as well as for beta-casein but it is presently only partially characterized.

Journal Article↗