Biomedical subjects
Publications and source records attributed to N Cohenca.
Traumatized teeth present a clinical challenge with regard to their diagnosis, treatment plan and prognosis. The injuries to the permanent dentition include crown and root fractures, subluxations, luxations and tooth avulsion. Common complications are pulp necrosis, periapical pathosis and root resorption. This article will describe new clinical modalities for the treatment of avulsed teeth and discuss the rational for their use.
Eighty identical samples of IRM were prepared and embedded in acrylic resin. The samples were polished, rinsed, and divided into experimental groups and controls, 10 specimens each. Each experimental group was treated for 1 or 5 min with one of the following gutta-percha solvents: chloroform, xylene, or halothane. Sterile saline was used as a control. Treatment consisted of pipetting each solvent onto the external IRM surface. The specimens were then sealed in plastic assay tubes for the corresponding exposure periods. At each time period, surface microhardness of the samples was measured using a mini-load hardness tester with a 500 g load for 20 s. It was found that xylene and halothane caused significant reduction in surface microhardness of IRM after 5 min (p < 0.01). Chloroform caused significant reduction in surface microhardness of IRM after 1 min of treatment (p < 0.01). Chloroform caused total dissolution after 5 min of treatment. Saline caused only minor and nonsignificant changes in surface microhardness of IRM.
OBJECTIVE: The purpose of this study was to assess in vitro the effect of commonly used gutta-percha solvents on the microhardness of human enamel and dentin. STUDY DESIGN: Crowns of human teeth were cut and treated with chloroform, xylene, and halothane. Treatment consisted of exposing the specimens for 5 or 15 minutes to the test solvents. Acid-treated and saline-treated specimens served as controls. After each treatment period, the specimens were rinsed, dried, and prepared for Vicker's microhardness analysis. Vicker's microhardness values for each specimen were recorded before and after treatment, and the differences were statistically compared. RESULTS: A statistically significant decrease in enamel and dentin microhardness was found in most solvent-treated groups; the amount of the decrease was directly related to the exposure time. CONCLUSIONS: Chloroform, xylene, and halothane may cause a significant softening effect on both enamel and dentin. This softening is already apparent after 5 minutes of treatment.
Variations in tooth morphology present a clinical challenge when endodontic treatment is required. A case of conservative endodontic therapy for a fused mandibular second and third molar is presented.
Anatomical and morphological variations in teeth may affect the success and prognosis of endodontic therapy. The reported data regarding such variations in the maxillary central incisors are limited. This article presents a case of endodontic retreatment in unusually long maxillary central incisors.
Apical periodontitis is a common development associated with teeth with necrotic pulp. Although rare, some cases may present further complications, such as neuropathies in areas adjacent to the affected tooth. A case is described in which mental nerve paresthesia was associated with a non-vital mandibular premolar. Endodontic therapy resolved the paresthesia completely without further clinical complications.
The effect of 10% carbamide peroxide or 10% hydrogen peroxide on the surface morphology and zinc oxide levels of IRM fillings was tested. Ninety IRM samples were treated with either 10% carbamide peroxide, 10% hydrogen peroxide or phosphate buffer which served as control. Treatment consisted of placing the samples in a dry incubator at 37 degrees C for 1, 3 or 7 days. At each time point, the samples were removed from the test solutions, dried and prepared for surface scanning electron microscopy and energy dispersive spectrometric analysis. After 3 days, 10% carbamide peroxide significantly reduced the zinc oxide levels as compared to the 10% hydrogen peroxide group (<0.01) and the controls (p<0.01). 10% hydrogen peroxide reduced the zinc oxide levels similarly to the control. No significant changes in the zinc oxide levels were found between 3 and 7 days in any of the groups tested. Microscopy examination of the carbamide peroxide group revealed granular surface with well defined crystalline areas. In the hydrogen peroxide group, numerous cracks with multiple sun burst-like areas were found. At the macroscopic level, the samples of this group appeared cracked and more swollen, as compared to controls and samples treated with carbamide peroxide. In conclusion, both 10% carbamide peroxide and 10% hydrogen peroxide altered the surface morphology and the zinc oxide levels of IRM fillings, but their modes of action differed.
Explore the source record for details and available documents.