PubMed Health⌕ Search

Biomedical subjects

N Dubrovinskaia

Publications and source records attributed to N Dubrovinskaia.

5 recordsLinked to original sources
PubMed2005

Beating the miscibility barrier between iron group elements and magnesium by high-pressure alloying.

Iron and magnesium are almost immiscible at ambient pressure. The low solubility of Mg in Fe is due to a very large size mismatch between the alloy components. However, the compressibility of Mg is much higher than that of Fe, and therefore the difference in atomic sizes between elements decreases dramatically with pressure. Based on the predictions of ab initio calculations, we demonstrate in a series of experiments in a multianvil apparatus and in electrically and laser-heated diamond anvil cells that high pressure promotes solubility of magnesium in iron. At the megabar pressure range, more than 10 at. % of Mg can dissolve in Fe and then the alloy can be quenched to ambient conditions. A generality of the concept of high-pressure alloying between immiscible elements is demonstrated by its application to two other Fe group elements, Co and Ni.

Journal Article↗
PubMed2003

Iron-silica interaction at extreme conditions and the electrically conducting layer at the base of Earth's mantle.

The boundary between the Earth's metallic core and its silicate mantle is characterized by strong lateral heterogeneity and sharp changes in density, seismic wave velocities, electrical conductivity and chemical composition. To investigate the composition and properties of the lowermost mantle, an understanding of the chemical reactions that take place between liquid iron and the complex Mg-Fe-Si-Al-oxides of the Earth's lower mantle is first required. Here we present a study of the interaction between iron and silica (SiO2) in electrically and laser-heated diamond anvil cells. In a multianvil apparatus at pressures up to 140 GPa and temperatures over 3,800 K we simulate conditions down to the core-mantle boundary. At high temperature and pressures below 40 GPa, iron and silica react to form iron oxide and an iron-silicon alloy, with up to 5 wt% silicon. At pressures of 85-140 GPa, however, iron and SiO2 do not react and iron-silicon alloys dissociate into almost pure iron and a CsCl-structured (B2) FeSi compound. Our experiments suggest that a metallic silicon-rich B2 phase, produced at the core-mantle boundary (owing to reactions between iron and silicate), could accumulate at the boundary between the mantle and core and explain the anomalously high electrical conductivity of this region.

Journal Article↗
PubMed2001

Chemical interaction of Fe and Al(2)O3 as a source of heterogeneity at the Earth's core-mantle boundary.

Seismological studies have revealed that a complex texture or heterogeneity exists in the Earth's inner core and at the boundary between core and mantle. These studies highlight the importance of understanding the properties of iron when modelling the composition and dynamics of the core and the interaction of the core with the lowermost mantle. One of the main problems in inferring the composition of the lowermost mantle is our lack of knowledge of the high-pressure and high-temperature chemical reactions that occur between iron and the complex Mg-Fe-Si-Al-oxides which are thought to form the bulk of the Earth's lower mantle. A number of studies have demonstrated that iron can react with MgSiO3-perovskite at high pressures and high temperatures, and it was proposed that the chemical nature of this process involves the reduction of silicon by the more electropositive iron. Here we present a study of the interaction between iron and corundum (Al(2)O3) in electrically- and laser-heated diamond anvil cells at 2,000-2,200 K and pressures up to 70 GPa, simulating conditions in the Earth's deep interior. We found that at pressures above 60 GPa and temperatures of 2,200 K, iron and corundum react to form iron oxide and an iron-aluminium alloy. Our results demonstrate that iron is able to reduce aluminium out of oxides at core-mantle boundary conditions, which could provide an additional source of light elements in the Earth's core and produce significant heterogeneity at the core-mantle boundary.

Journal Article↗
PubMed2001

Pressure-induced Invar effect in Fe-Ni alloys.

We have measured the pressure-volume (P-V) relations for cubic iron-nickel alloys for three different compositions: Fe 0.64Ni (0.36), Fe 0.55Ni (0.45), and Fe 0.20Ni (0.80). It is observed that for a certain pressure range the bulk modulus does not change or can even decrease to some minimum value, after which it begins to increase under still higher pressure. In our experiment, we observe for the first time a new effect, namely, that the Fe-Ni alloys with high Ni concentrations, which show positive thermal expansion at ambient pressure, become Invar system upon compression over a certain pressure range.

Journal Article↗