PubMed Health⌕ Search

Biomedical subjects

N V Churaev

Publications and source records attributed to N V Churaev.

8 recordsLinked to original sources
PubMed2005

Reversible adsorption inside pores of ultrafiltration membranes.

A range of experiments were performed on the dead-end ultrafiltration (UF) of poly(ethylene glycol) (PEG) of different molecular weights. Deviations from a linear dependence of the filtration rate with the applied membrane pressure difference were found. It is shown that these deviations are not caused by an osmotic pressure influence but determined by the reversible adsorption of PEG molecules inside the pores of the ultrafiltration membranes used. A theoretical model of the process is suggested, which describes the reversible adsorption inside the membrane pores and the corresponding reduction of the filtration velocity. Comparison of the theory predictions with experimental data on the ultrafiltration of PEG shows a good agreement between the theoretical predictions and experimental data. A theory is presented for calculation of the PEG rejection coefficient in the case of ultrafiltration.

Journal Article↗
PubMed2003

Foam and wetting films: electrostatic and steric stabilization.

Foam films and wetting films on quartz, obtained from aqueous solutions of two different surfactants [cetyltrimethylammonium bromide (CTAB) and PEO-PPO-PEO triblock copolymer (F108)] with NaCl as a background electrolyte, are considered as convenient models to compare the properties of symmetric (free thin liquid films) and asymmetric (thin liquid films on solid substrate) films with the same air/solution interface. Microinterferometric methodology of assessment of foam and wetting films is used to allow precise determination of the film thickness. In the case of CTAB films, experimental data for the potential phi(0) of the diffuse electric layer at the solution/air interface and the potential phi(1) at the solution/quartz interface are used to analyze the stability of the films studied. A conclusion drawn is that electrostatic interaction forces stabilize both kinds of films studied. It is shown that with increasing CTAB concentration a charge reversal occurs at both the solution/air and solution/quartz interfaces that determines the stability/instability of the foam and wetting films. Concentration ranges where both types of films produce stable (equilibrium) films are found. There are also concentration ranges where the films either rupture or are metastable (quasi-equilibrium). The CTAB concentration ranges, which provide formation of unstable (rupturing and metastable) and stable films, are different for symmetric (foam) and asymmetric (wetting) thin liquid films. It is only at high CTAB concentrations (>2 x 10(-4) mol dm(-3)) that both cases render formation of stable equilibrium films. In the case of F108 films, the comparison of foam films and wetting films on quartz indicates film stability that is either electrostatic or steric in origin. On the basis of the effect of electrolyte concentration on film thickness, the transition from electrostatic to steric stabilization is demonstrated for both kinds of films. The critical electrolyte concentration at which this transition occurs is determined. Foam films are found to be always stable (equilibrium). Formation of either unstable (rupturing and metastable) or stable (equilibrium) wetting films on quartz is established depending on the solution composition. The effects are similar for both hydrophilic and hydrophobic quartz surfaces. The results obtained show certain similarity between foam and wetting films. In both cases, electrostatic forces below the critical electrolyte concentration, and above it steric forces govern film stability. Some specific properties of the wetting films are induced by the asymmetric boundary conditions as distinct from symmetric foam films.

Journal Article↗
PubMed2003

Surface forces in wetting films.

A short review of various components of surface forces acting in a non-symmetrical system such as wetting films is presented here. Experimental results are compared with modified DLVO theory, which includes, besides dispersion and electrostatic, structural (solvation) forces caused by a change in liquid structure in conditions of confined geometry. The peculiarities of disjoining pressure isotherms and conditions of the film stability of non-polar and polar simple liquids, as well as of aqueous solutions of electrolytes and surfactants, are systematically considered from a historical perspective.

Colloids↗
PubMed2002

Disjoining pressure of thin nonfreezing interlayers.

At subzero temperatures, it has been found that nonfreezing water interlayers form between the inner smooth surface of a thin quartz capillary and the ice in the capillary core. The dilatometry method has been used to measure the thicknesses of these nonfreezing interlayers over a range of temperatures between -1 and -0.14 degrees C and for applied pressures up to 8 MPa. The measured data are used to calculate the disjoining pressure isotherms of nonfreezing water interlayers. It is shown that structural forces caused by structural changes of nonfreezing water are the main contribution to the disjoining pressure. The structural changes are also responsible for the phenomenon of the nonfreezing interlayers.

Journal Article↗
PubMed2002

Electrokinetic properties of methylated quartz capillaries.

Electrokinetic (zeta)-potentials of methylated (trimethylchlorosilane) quartz capillaries (5-6 microm in radius) were determined in 10(-4) M KCl solution. Over the course of time, the absolute values of the zeta-potential decrease, as a result of the formation of small bubbles on the rough methylated surface, generated from the flowing, nitrogen gas-saturated solution. This decrease is attributed to screening of a part of the solid surface. After the passage of time, a sharp increase in the zeta-potentials was observed, as the pressure was increased and the initial potential values were recovered. Sometimes, oscillations in the zeta-potentials were observed. This behaviour was explained by detachment of bubbles from the methylated surfaces by the flowing solution. Addition of non-ionic surfactant, which made the methylated surface hydrophilic, decreased the measured zeta-potentials. This was attributed to suppression of water slippage, an effect known to occur for hydrophobic solid surfaces. A mixed mechanism of charge formation is characteristic for these methylated quartz surfaces and is connected with presence of hydrophobic and hydrophilic areas. The ratio between these areas controls both the formation of surface charge as well as the contact angles.

Journal Article↗
PubMed1993

Separation of electrolyte solutions by reverse osmosis.

The paper presented is subdivided into two parts. The first one includes a survey of current notions concerning the physico-chemical nature of interaction potential phi between dissolved molecules or ions and water with a membrane material. Special attention is paid to the structural potential and the potential of image forces. The main conclusion is that the potential of interaction phi determines the major part of phenomena which are relevant for reverse osmosis (RO) separation. In the second part the distribution coefficient gamma = exp (phi) is supposed to be known and a survey of theoretical investigations of RO processes is undertaken. The so called homogeneous model of RO membranes is employed and concentration polarization is taken into account. Two main points in this investigation should be emphasized, that is, taking into account concentration polarization and a theory of RO separation of electrolyte mixtures. The maximum value of rejection coefficient and corresponding optimum velocity of filtration are calculated. Negative rejection of some ions from the mixture is explained, as well as a change in pH of filtrate. The streaming potential is calculated as a function of Peclet number, distribution coefficients, membrane charge and so on in all cases. The suggested theory gives the possibility to explain a number of phenomena in RO separation of electrolyte solutions.

Electrolytes↗