PubMed Health⌕ Search

Biomedical subjects

Nancy B Valentine

Publications and source records attributed to Nancy B Valentine.

9 recordsLinked to original sources

Preparation and evaluation of spore-specific affinity-augmented bio-imprinted beads.

A novel, affinity-augmented, bacterial spore-imprinted, bead material was synthesized, based on a procedure developed for vegetative bacteria. The imprinted beads were intended as a front-end spore capture/concentration stage of an integrated biological detection system. Our approach involved embedding bead surfaces with Bacillus thuringiensis kurstaki (Bt) spores (as a surrogate for Bacillus anthracis) during synthesis. Subsequent steps involved lithographic deactivation using a perfluoroether; spore removal to create imprint sites; and coating imprints with the lectin, concanavalin A, to provide general affinity. The synthesis of the intended material with the desired imprints was verified by scanning electron and confocal laser-scanning microscopy. The material was evaluated using spore-binding assays with either Bt or Bacillus subtilis (Bs) spores. The binding assays indicated strong spore-binding capability and a robust imprinting effect that accounted for 25% additional binding over non-imprinted controls. The binding assay results also indicated that further refinement of the surface deactivation procedure would enhance the performance of the imprinted substrate.

Bacillus anthracis↗

Bacterial analysis by MALDI-TOF mass spectrometry: an inter-laboratory comparison.

Bacterial analysis by matrix-assisted laser desorption/ionization time-of-flight (MALDI-TOF) mass spectrometry has been demonstrated in numerous laboratories, and a few attempts have been made to compare results from different laboratories on the same organism. It has been difficult to understand the causes behind the observed differences between laboratories when different instruments, matrices, solvents, etc. are used. In order to establish this technique as a useful tool for bacterial identification, additional efforts in standardizing the methods by which MALDI mass spectra are obtained and comparisons of spectra from different instruments with different operators are needed. Presented here is an extension of our previous single-laboratory reproducibility study with three different laboratories in a controlled experiment with aliquots of the same bacterial culture, matrix stock solution, and calibrant standards. Using automated spectral collection of whole-cell bacteria and automated data processing and analysis algorithms, fingerprints from three different laboratories were constructed and compared. Nine of the ions appeared reproducibly within all three laboratories, with additional unique ions observed within each of the laboratories. An initial evaluation of the ability to use a fingerprint generated within one laboratory for bacterial identification of a sample from another laboratory is presented, and strategies for improving identification rates between laboratories is discussed.

Bacterial Proteins↗

Differentiation of spores of Bacillus subtilis grown in different media by elemental characterization using time-of-flight secondary ion mass spectrometry.

We demonstrate the use of time-of-flight secondary ion mass spectrometry (TOF-SIMS) in a forensics application to distinguish Bacillus subtilis spores grown in various media based on the elemental signatures of the spores. Triplicate cultures grown in each of four different media were analyzed to obtain TOF-SIMS signatures comprised of 16 elemental intensities. Analysis of variance was unable to distinguish growth medium types based on 40Ca-normalized signatures of any single normalized element. Principal component analysis proved successful in separating the spores into groups consistent with the media in which they were prepared. Confusion matrices constructed using nearest-neighbor classification of the PCA scores confirmed the predictive utility of TOF-SIMS elemental signatures in identifying sporulation medium. Theoretical calculations based on the number and density of spores in an analysis area indicate an analytical sample size of about 1 ng, making this technique an attractive method for bioforensics applications.

Bacillus subtilis↗

Identification of sporulated and vegetative bacteria using statistical analysis of fourier transform mid-infrared transmission data.

A combined mid-infrared spectroscopic/statistical modeling approach for the discrimination and identification, at the strain level, of both sporulated and vegetative bacterial samples is presented. Transmission mode spectra of bacteria dried on ZnSe windows were collected using a Fourier transform mid-infrared (FT-IR) spectrometer. Five Bacillus bacterial strains (B. atrophaeus 49337, B. globigii Dugway, B. thuringiensis spp. kurstaki 35866, B. subtilis 49760, and B. subtilis 6051) were used to construct a reference spectral library and to parameterize a four-step statistical model for the systematic identification of bacteria. The statistical methods used in this initial feasibility study included principal component analysis (PCA), classification and regression trees (CART), and Mahalanobis distance calculations. Internal cross-validation studies successfully classified 100% of the samples into their correct physiological state (sporulated or vegetative) and identified 67% of the samples correctly as to their bacterial strain. Analysis of thirteen blind samples, which included reference and other bacteria, nonbiological materials, and mixtures of both nonbiological and bacterial samples, yielded comparable accuracy. The primary advantage of this approach is the accurate identification of unknown bacteria, including spores, in a matter of minutes.

Bacillus↗

Analysis of whole bacterial cells by flow field-flow fractionation and matrix-assisted laser desorption/ionization time-of-flight mass spectrometry.

The purpose of this study is to develop a novel bacterial analysis method by coupling the flow field-flow fractionation (flow FFF) separation technique with detection by matrix-assisted laser desorption/ionization time-of-flight (MALDI-TOF) mass spectrometry. The composition of carrier liquid used for flow FFF was selected based on retention of bacterial cells and compatibility with the MALDI process. The coupling of flow FFF and MALDI-TOF MS was demonstrated for P. putida and E. coli. Fractions of the whole cells were collected after separation by FFF and further analyzed by MALDI-MS. Each fraction, collected over different time intervals, corresponded to different sizes and possibly different growth stages of bacteria. The bacterial analysis by flow FFF/MALDI-TOF MS was completed within 1 h with only preliminary optimization of the process.

Bacillus cereus↗

Identification of bacterial spores using statistical analysis of Fourier transform infrared photoacoustic spectroscopy data.

Fourier transform infrared photoacoustic spectroscopy (FTIR-PAS) has been applied for the first time to the identification and speciation of bacterial spores. A total of forty specimens representing five strains of Bacillus spores (Bacillus subtilis ATCC 49760, Bacillus atrophaeus ATCC 49337, Bacillus subtilis 6051, Bacillus thuringiensis subsp. kurstaki, and Bacillus globigii Dugway) were analyzed. Spores were deposited, with minimal preparation, into the photoacoustic sample cup and their spectra recorded. Principal component analysis (PCA), classification and regression trees (CART), and Mahalanobis distance calculations were used on this spectral library to develop algorithms for step-wise classification at three levels: (1) bacterial/nonbacterial, (2) membership within the spore library, and (3) bacterial strain. Internal cross-validation studies on library spectra yielded classification success rates of 87% or better at each of these three levels. Analysis of fifteen blind samples, which included five samples of spores already in the spectral library, two samples of closely related Bacillus globigii 01 spores not in the library, and eight samples of nonbacterial materials, yielded 100% accuracy in distinguishing among bacterial/nonbacterial samples, membership in the library, and bacterial strains within the library.

Acoustics↗

Analysis of microbial mixtures by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry.

Many different laboratories are currently developing mass-spectrometric techniques to analyze and identify microorganisms. However, minimal work has been done with mixtures of bacteria. To demonstrate that microbial mixtures could be analyzed by matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS), mixed bacterial cultures were analyzed in a double-blind fashion. Nine different bacterial species currently in our MALDI-MS fingerprint library were used to generate 50 different simulated mixed bacterial cultures similar to that done for an initial blind study previously reported (Jarman, K. H.; Cebula, S. T.; Saenz, A. J.; Petersen, C. E.; Valentine, N. B.; Kingsley, M. T.; Wahl, K. L. Anal. Chem. 2000, 72, 1217-1223). The samples were analyzed by MALDI-MS with automated data extraction and analysis algorithms developed in our laboratory. The components present in the sample were identified correctly to the species level in all but one of the samples. However, correctly eliminating closely related organisms was challenging for the current algorithms, especially in differentiating Serratia marcescens, Escherichia coli, and Yersinia enterocolitica, which have some similarities in their MALDI-MS fingerprints. Efforts to improve the specificity of the algorithms are in progress.

Algorithms↗

Direct surface analysis of fungal species by matrix-assisted laser desorption/ionization mass spectrometry.

In this study various methods of sample preparation and matrices were investigated to determine optimum collection and analysis criteria for fungal analysis by matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS). Intact spores and/or hyphae of Aspergillus niger, Rhizopus oryzae, Trichoderma reesei and Phanerochaete chrysosporium were analyzed by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS). The fungal samples were applied to the MALDI sample target as untreated, sonicated, or acid/heat treated samples, or blotted directly from the fungal culture with double-stick tape. Ferulic acid or sinapinic acid matrix solution was layered over the dried samples and analyzed by MALDI-MS. Statistical analysis showed that simply using double-stick tape to collect and transfer to a MALDI sample plate typically worked as well as the other preparation methods, and required the least sample handling.

Aspergillus niger↗