Biomedical subjects

Nicola Hagemeister

Publications and source records attributed to Nicola Hagemeister.

6 recordsLinked to original sources

PubMed2005

Comparison of 2 surgical techniques of posterolateral corner reconstruction of the knee.

BACKGROUND: Various surgical techniques to treat posterolateral knee instability have been described. To date, the recommended treatment is an anatomical form of reconstruction, in which the 3 key structures of the posterolateral corner are addressed: the lateral collateral ligament, the popliteofibular ligament, and the popliteus tendon. HYPOTHESIS: Two methods of surgical reconstruction will restore posterolateral knee instability, in terms of static laxity as well as dynamic 6 degrees of freedom kinematics, to statistically significant levels compared with the intact state. STUDY DESIGN: Controlled laboratory study. METHODS: Two surgical techniques (A and B) were used to reconstruct the posterolateral structures in 10 cadaveric knees. Static tests were performed on the intact, sectioned, and reconstructed knees at 30 degrees and 90 degrees of flexion for anterior-posterior laxity and external rotational laxity, as well as at 0 degrees and 30 degrees of flexion for varus laxity; dynamic 6 degrees of freedom kinematic testing, through a path of motion from 90 degrees of flexion to full extension, was also performed. RESULTS: For the static varus tests, external rotation and varus laxity were significantly increased after the posterolateral structures were cut. Both reconstruction techniques restored external rotation and varus laxity to levels not significantly different from the intact state. For technique B, dynamic testing did not show any significant difference for all degrees of freedom kinematics compared with the intact state. However, for technique A, a significant internal tibial rotation was observed throughout the entire path of motion from 0 degrees to 90 degrees of knee flexion. CONCLUSIONS: Both surgical techniques for anatomical posterolateral corner reconstruction showed good results in the static laxity tests. The anatomical reconstruction of all structures, including the popliteus tendon, resulted in an abnormal internal tibial rotation during dynamic testing.

Adult↗

PubMed2005

3D kinematic in-vitro comparison of posterolateral corner reconstruction techniques in a combined injury model.

With the variable injury pattern to the posterolateral structures (PLS) of the knee, a number of reconstructive procedures have been introduced. It was the aim of the present study to evaluate the resulting 3D kinematics following three different surgical techniques of reconstruction in a combined posterior cruciate ligament (PCL)/PLS injury model. In nine human cadaveric knees, 3D kinematics were recorded during the path of flexion-extension using a computer based custom made 6-degree-of-freedom (DOF) testing apparatus. Additional laxity tests were conducted at 30 and 90 degrees of flexion. Testing was performed before and after cutting the PLS and PCL, followed by PCL reconstruction alone. Reconstructing the posterolateral corner, three surgical techniques were compared: (a) the posterolateral corner sling procedure (PLCS), (b) the biceps tenodesis (BT), and (c) a bone patellar-tendon bone (BTB) allograft reconstruction. Posterior as well as rotational laxity were significantly increased after PCL/PLS transection at 30 and 90 degrees of flexion. Isolated PCL reconstruction resulted in a remaining external rotational deficiency for both tested flexion angles. Additional PLS reconstruction closely restored external rotation as well as posterior translation to intact values by all tested procedures. Compared to the intact knee, dynamic testing revealed a significant internal tibial rotation for (b) BT (mean=3.9 degrees, p=0.043) and for (c) BTB allograft (mean=4.3 degrees, p=0.012). (a) The PLCS demonstrated a tendency to internal tibial rotation between 0 and 60 degrees of flexion (mean=2.2 degrees, p=0.079). Varus/valgus rotation as well as anterior/posterior translation did not show significant differences for any of the tested techniques. The present study shows that despite satisfying results in static laxity testing, pathological 3D knee kinematics were not restored to normal, demonstrated by a nonphysiological internal tibial rotation during the path of flexion-extension.

Aged↗

PubMed2005

A reproducible method for studying three-dimensional knee kinematics.

The methods used in movement analysis often rely on the definition of joint coordinate systems permitting three-dimensional (3D) kinematics. The first aim of this research project was to present a functional and postural method (FP method) to define a bone-embedded anatomical frame (BAF) on the femur and tibia, and, subsequently, a knee joint coordinate system. The repeatability of the proposed method was also assessed. Using FP method to define the BAFs, 4 kinematic parameters (flexion/extension, abduction/adduction, tibial internal/external rotation, and antero-posterior translation) were computed for 15 subjects walking on a treadmill. The repeatability for all four kinematic parameters was then assessed, using intra- and inter-observer settings. After pooling the results for all observers, the mean repeatability value ranged between 0.4 degrees and 0.8 degrees for rotation angles and between 0.8 and 2.2 mm for translation.

Adolescent↗

PubMed2004

Effect of ski binding parameters on knee biomechanics: a three-dimensional computational study.

INTRODUCTION: Downhill skiing is a relatively safe sport, but many potentially avoidable injuries do occur. Whereas tibia and ankle injuries have been declining, severe knee sprains usually involving the anterior cruciate ligament (ACL) have increased from the 1970s to the 1990s. The goal of the present study was to evaluate the effect of the position of the binding pivot point and binding release characteristics on ACL strain during a phantom-foot fall. METHODS: We computed ACL strain using a biomechanical computer knee model to simulate the phantom-foot ACL-injury mechanism. This mechanism, which is one of the most common mechanisms of ACL injury in downhill skiing, occurs when the weight of the skier is on the inner edge of the ski during a backward fall, resulting in a sharp uncontrolled inward turn of the ski. RESULTS: The model predicts, that under simulated phantom-foot conditions, a binding with fast-release characteristics with a pivot positioned in front of the center of the boot produces less strain on the ACL. Current bindings have their pivot point approximately at the center of the heel radius. A pivot positioned at the back of the binding is more effective for sensing loads that occur at the tip of the ski. However, it is less effective for sensing loads that occur at the tail of the ski and, therefore, offers less protection during a phantom-foot fall. CONCLUSION: A binding with two pivot points, one positioned in front and the other at the back, could sense twist loads applied to the ski both at the front and at the back, and might, therefore, be a solution to reduce the occurrence of ACL injuries.

Anterior Cruciate Ligament Injuries↗

PubMed2003

In vitro evaluation of combined graft deformation in anterior cruciate ligament reconstructions.

In this paper, we present a simple method of calculating deformation of an anterior cruciate ligament graft in combined elongation, bending and total twisting. We also report our results on these deformations for three types of ligament reconstruction in cadaver knees: two isometric reconstructions, using either a biological bone-patellar tendon-bone autograft or an artificial Trevira prosthesis, and modified over-the-top reconstruction with the prosthesis. The data show that the modified OTT technique produced elongation of the graft equivalent to that of the synthetic isometric technique, but significantly less than isometric reconstruction with the biological graft (p<0.05, ANOVA). Moreover, the grafts were subjected to bending and twisting.

Aged↗

PubMed2002

Quantitative comparison of three different types of anterior cruciate ligament reconstruction methods: laxity and 3-D kinematic measurements.

In this project, we compared knee laxity and 3-D knee kinematics after ACL reconstruction on cadaver knees using (1) bone-patellar tendon-bone two-tunnel; (2) synthetic ligament two-tunnel; and (3) synthetic ligament "over-the-top" technique. We used a computer assisted system, based on the acquisition of the knee's movement with magnetic sensors (Polhemus, Vermont, USA). The use of personalised three-dimensional (3D) models of the bones enabled us to ensure a reproducible measurement of three-dimensional kinematic and laxity parameters. Our results showed that even when knee laxity was restored to normal, 3D kinematic measurements revealed that the reconstructions tended to under or over-constrain the knee's movement. This study shows that 3D kinematics is a complementary measurement that can be useful to get a better comprehension of the knee's function after ligament reconstruction.

Aged↗