Biomedical subjects
Publications and source records attributed to O N Guerra.
The use of Silastic Medical Adhesive Type A in the fabrication of facial prostheses may cause health hazards to the patient and the operator because of acetic acid emissions. Caution must be exercised to remove acetic acid vapors from the air and unliberated acetic acid from material applied directly to the skin.
Explore the source record for details and available documents.
Air sampling was conducted in three maxillofacial laboratories to determine whether vinyl chloride, a carcinogen, was released during the formulation of polyvinylchloride facial prostheses. Results show that time-weighted average exposures of technicians were less than 0.1 ppm, a concentration meeting current U.S. Department of Labor standards.
A new (open-cast) technique for the fabrication of metal molds has been presented. Its simplicity relies on the use of gummed asbestos tape as a boxing agent for the investment models. This technique has the following advantages over the "lost wax" technique: (1) it requires approximately one-quarter the amount of investment material, (2) it eliminates the use of investing rings or wax patterns, (3) it eliminates the boil-out step for the wax pattern and reduces the total time required to make a metal mold, and (4) it affords a high degree of visibility. The only disadvantage is that the larger prostheses require large amounts of Lino-type metal which is very heavy. However, this has not restricted the use of this technique since these metals cast well and can be easily placed in large ovens. This technique, because of its advantages, offers more efficient use of laboratory time and personnel.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.