Biomedical subjects

Ove Axner

Publications and source records attributed to Ove Axner.

11 recordsLinked to original sources

PubMed2007

Dual-trap technique for reduction of low-frequency noise in force measuring optical tweezers.

High-resolution long-time force measurements by optical tweezers are often limited by low-frequency (1/f) noise. A dual-trap technique is presented that can reduce such noise in the force signal. It incorporates a second trap (a reference trap) that probes the noise in the system and it is based upon the assumption that the low-frequency parts of the noise from the two traps are correlated. A subtraction of the low-frequency signal from the reference trap from the signal from the force measuring trap will therefore yield a net signal that is significantly less influenced by noise. It is shown that this dual-trap technique can reduce the noise in the force signal up to 60% depending on detection bandwidth.

Equipment Design↗

PubMed2006

Dynamic force spectroscopy of E. coli P pili.

Surface organelles (so-called pili) expressed on the bacterial membrane mediate the adhesion of Escherichia coli causing urinary tract infection. These pili possess some extraordinary elongation properties that are assumed to allow a close bacterium-to-host contact even in the presence of shear forces caused by urine flow. The elongation properties of P pili have therefore been assessed for low elongation speeds (steady-state conditions). This work reports on the behavior of P pili probed by dynamic force spectroscopy. A kinetic model for the unfolding of a helixlike chain structure is derived and verified. It is shown that the unfolding of the quaternary structure of the PapA rod takes place at a constant force that is almost independent of elongation speed for slow elongations (up to approximately 0.4 mum/s), whereas it shows a dynamic response with a logarithmic dependence for fast elongations. The results provide information about the energy landscape and reaction rates. The bond length and thermal bond opening and closure rates for the layer-to-layer bond have been assessed to approximately 0.76 nm, approximately 0.8 Hz, and approximately 8 GHz, respectively. The results also support a previously constructed sticky-chain model for elongation of the PapA rod that until now had been experimentally verified only under steady-state conditions.

Escherichia coli↗

PubMed2006

Absorption spectrometry by narrowband light in optically saturated and optically pumped collision and Doppler broadened gaseous media under arbitrary optical thickness conditions.

This work examines absorption spectrometry by narrowband light in gaseous media with arbitrary optical thickness when the light induces optical saturation or optical pumping. Two quantities are defined: the observed absorbance, A(obs), and the true absorbance, A(true). The former is the absorbance that is measured under the existing conditions, whereas the latter represents the absorbance one would measure if the light acted solely as a probe of the populations of the various levels, and it is therefore directly proportional to the concentration or density of absorbers. A general integral equation for the propagation of light in media of arbitrary optical thickness in which the light influences the populations of the levels involved is derived. This expression is transcendental in the observed absorbance and cannot be solved analytically. It is shown that an analytical expression can be derived by investigating the inverse relationship, i.e., A(true) = f(A(obs)). Inasmuch as collision and Doppler broadened media react differently to optical saturation, they are considered separately. It is shown that a nonlinear response results if the medium is optically saturated (or pumped) and not optically thin. Expressions for the error introduced if the technique of standard additions is uncritically applied to such a system are derived.

Journal Article↗

PubMed2005

A sticky chain model of the elongation and unfolding of Escherichia coli P pili under stress.

A model of the elongation of P pili expressed by uropathogenic Escherichia coli exposed to stress is presented. The model is based upon the sticky chain concept, which is based upon Hooke's law for elongation of the layer-to-layer and head-to-tail bonds between neighboring units in the PapA rod and a kinetic description of the opening and closing of bonds, described by rate equations and an energy landscape model. It provides an accurate description of the elongation behavior of P pili under stress and supports a hypothesis that the PapA rod shows all three basic stereotypes of elongation/unfolding: elongation of bonds in parallel, the zipper mode of unfolding, and elongation and unfolding of bonds in series. The two first elongation regions are dominated by a cooperative bond opening, in which each bond is influenced by its neighbor, whereas the third region can be described by individual bond opening, in which the bonds open and close randomly. A methodology for a swift extraction of model parameters from force-versus-elongation measurements performed under equilibrium conditions is derived. Entities such as the free energy, the stiffness, the elastic elongation, the opening length of the various bonds, and the number of PapA units in the rod are determined.

Computer Simulation↗

PubMed2005

The unfolding of the P pili quaternary structure by stretching is reversible, not plastic.

P pili are protein filaments expressed by uropathogenic Escherichia coli that mediate binding to glycolipids on epithelial cell surfaces, which is a prerequisite for bacterial infection. When a bacterium, attached to a cell surface, is exposed to external forces, the pili, which are composed of approximately 10(3) PapA protein subunits arranged in a helical conformation, can elongate by unfolding to a linear conformation. This property is considered important for the ability of a bacterium to withstand shear forces caused by urine flow. It has hitherto been assumed that this elongation is plastic, thus constituting a permanent conformational deformation. We demonstrate, using optical tweezers, that this is not the case; the unfolding of the helical structure to a linear conformation is fully reversible. It is surmised that this reversibility helps the bacteria regain close contact to the host cells after exposure to significant shear forces, which is believed to facilitate their colonization.

Escherichia coli↗

PubMed2004

Physical properties of Escherichia coli P pili measured by optical tweezers.

The mechanical behavior of individual P pili of uropathogenic Escherichia coli has been investigated using optical tweezers. P pili, whose main part constitutes the PapA rod, composed of approximately 10(3) PapA subunits in a helical arrangement, are distributed over the bacterial surface and mediate adhesion to host cells. They are particularly important in the pathogenesis of E. coli colonizing the upper urinary tract and kidneys. A biological model system has been established for in situ measurements of the forces that occur during mechanical stretching of pili. A mathematical model of the force-versus-elongation behavior of an individual pilus has been developed. Three elongation regions of pili were identified. In region I, P pili stretch elastically, up to a relative elongation of 16 +/- 3%. The product of elasticity modulus and area of a P pilus, EA, was assessed to 154 +/- 20 pN (n=6). In region II, the quaternary structure of the PapA rod unfolds under a constant force of 27 +/- 2 pN (n approximately 100) by a sequential breaking of the interactions between adjacent layers of PapA subunits. This unfolding can elongate the pilus up to 7 +/- 2 times. In region III, pili elongate in a nonlinear manner as a result of stretching until the bond ruptures.

Bacterial Adhesion↗

PubMed2004

Optical tweezers based force measurement system for quantitating binding interactions: system design and application for the study of bacterial adhesion.

An optical force measurement system for quantitating forces in the pN range between micrometer-sized objects has been developed. The system was based upon optical tweezers in combination with a sensitive position detection system and constructed around an inverted microscope. A trapped particle in the focus of the high numerical aperture microscope-objective behaves like an omnidirectional mechanical spring in response to an external force. The particle's displacement from the equilibrium position is therefore a direct measure of the exerted force. A weak probe laser beam, focused directly below the trapping focus, was used for position detection of the trapped particle (a polystyrene bead). The bead and the condenser focus the light to a distinct spot in the far field, monitored by a position sensitive detector. Various calibration procedures were implemented in order to provide absolute force measurements. The system has been used to measure the binding forces between Escherichia coli bacterial adhesins and galabiose-functionalized beads.

Bacterial Adhesion↗

PubMed2003

Laser-based micromanipulation for separation and identification of individual Frankia vesicles.

In studies of symbiotic efficiency it is of great importance to identify and separate individual Frankia strains from a nodule. Therefore, a new laser-based micromanipulation technique has been developed in which individual vesicles from root nodules of two Frankia-Alnus symbioses have been successfully cut loose and separated from clusters of vesicles in sterile conditions under light microscopy using a laser scalpel and optical tweezers. Vesicles from the Alnus incana-Frankia AvCI1 symbiosis were successfully isolated and grown in culture using this technique. The DNA from both Frankia sources was amplified by polymerase chain reaction (PCR). The work shows that a combination of laser-based manipulation techniques and PCR can be used for the separation and study of individual vesicles. This novel laser-based micromanipulation technique opens up various new possibilities, for instance, to study whether several Frankia strains can grow simultaneously in the same root nodule.

Cytoplasmic Vesicles↗

PubMed2003

Influence of a glass-water interface on the on-axis trapping of micrometer-sized spherical objects by optical tweezers.

A systematic study of the influence of a glass-water interface on the on-axis trapping of micrometer-sized spherical objects by optical tweezers is presented. The ways in which the escape force and the trapping position, as well as the stiffness of the trap, depend on the focusing depth, the numerical aperture, and the degree of overfilling of the objective entrance pupil are investigated. It is concluded, among other things, that objectives with the highest numerical aperture and the use of large degrees of overfilling do not always provide the optimum trapping conditions at finite depths.

Journal Article↗

PubMed2002

Stress response in Caenorhabditis elegans caused by optical tweezers: wavelength, power, and time dependence.

Optical tweezers have emerged as a powerful technique for micromanipulation of living cells. Although the technique often has been claimed to be nonintrusive, evidence has appeared that this is not always the case. This work presents evidence that near-infrared continuous-wave laser light from optical tweezers can produce stress in Caenorhabditis elegans. A transgenic strain of C. elegans, carrying an integrated heat-shock-responsive reporter gene, has been exposed to laser light under a variety of illumination conditions. It was found that gene expression was most often induced by light of 760 nm, and least by 810 nm. The stress response increased with laser power and irradiation time. At 810 nm, significant gene expression could be observed at 360 mW of illumination, which is more than one order of magnitude above that normally used in optical tweezers. In the 700-760-nm range, the results show that the stress response is caused by photochemical processes, whereas at 810 nm, it mainly has a photothermal origin. These results give further evidence that the 700-760-nm wavelength region is unsuitable for optical tweezers and suggest that work at 810 nm at normal laser powers does not cause stress at the cellular level.

Animals↗

PubMedDate not supplied

Measurements of the binding force between the Helicobacter pylori adhesin BabA and the Lewis b blood group antigen using optical tweezers.

Helicobacter pylori is a world-wide spread bacterium that causes persistent infections and chronic inflammations that can develop into gastritis and peptic ulcer disease. It expresses several adhesin proteins on its surface that bind to specific receptors in the gastric epithelium. The most well-known adhesin is BabA, which has previously been shown to bind specifically to the fucosylated blood group antigen Lewis b (Leb). The adhesion forces between BabA and the Leb antigen are investigated in this work and assessed by means of optical tweezers. A model system for in situ measurements of the interaction forces between individual bacteria and beads coated with Leb is developed. It is found that the de-adhesion force in this model system, measured with a loading rate of approximately 100 pNs, ranges from 20 to 200 pN. The de-adhesion force appears predominantly as multiples of an elementary force, which is determined to 25+/-1.5 pN and identified as the unbinding force of an individual BabA-Leb binding. It is concluded that adhesion in general is mediated by a small number of bindings (most often 1 to 4) despite that the contact surface between the bacterium and the bead encompassed significantly more binding sites.

Adhesins, Bacterial↗