PubMed Health⌕ Search

Biomedical subjects

P M Lintilhac

Publications and source records attributed to P M Lintilhac.

8 recordsLinked to original sources
PubMed2001

Root elongation against a constant force: experiment with a computerized feedback-controlled device.

Axial force was applied to the root tip of corn (Zea mays L. cv. Merit) seedlings using a computerized, feedback-controlled mechanical device. The system's feedback capability allowed continuous control of a constant tip load, and the attached displacement transducer provided the time course of root elongation. Loads up to 7.5 g decreased the root elongation rate by 0.13 mm h-1 g-1, but loads 7.5 to 17.5 g decreased the growth rate by only 0.04 mm h-1 g-1. Loads higher than 18 g stopped root elongation completely. Measurement of the cross-sectional areas of the root tips indicated that the 18 g load had applied about 0.98 MPa of axial pressure to the root, thereby exceeding the root's ability to respond with increased turgor pressure. Recorded time-lapse images of loaded roots showed that radial thickening (swelling) occurred behind the root cap, whose cross-sectional area increased with tip load.

Biophysical Phenomena↗
PubMed2001

An insight into cell elasticity and load-bearing ability. Measurement and theory.

We have studied the elasticity and load bearing ability of plant tissue at the cellular level, using onion (Allium cepa) epidermal cells. The Young's modulus and Poisson's ratio of the cells were obtained by loading a tensile force on onion epidermal peels of different turgor pressures, and measuring the elongation and the lateral contraction of the peels. The Young's moduli and the Poisson's ratios ranged from 3.5 to 8.0 MPa and 0.18 to 0.30, respectively. To determine the effects of cell elasticity and turgor pressure on the cell's ability to bear load, we loaded a small glass ball onto a cell and measured the projected contact area between the ball and the cell. Unlike previous studies, we considered the cell as a whole entity, and utilized the Boussinesq's solution to derive the relevant equations that related the elastic parameters and cell deformation. For cells with a turgor pressure > or = 0.34 MPa, the predicted contact area agreed well with the measured area. The equations could also predict cell turgor pressure with a deviation from the measured value of 0.01 MPa. This study gives strong support to ball tonometry, a new method of measuring cell turgor pressure.

Allium↗
PubMed2000

Ball tonometry: a rapid, nondestructive method for measuring cell turgor pressure in thin-walled plant cells.

In this article we describe a new method for the determination of turgor pressures in living plant cells. Based on the treatment of growing plant cells as thin-walled pressure vessels, we find that pressures can be accurately determined by observing and measuring the area of the contact patch formed when a spherical glass probe is lowered onto the cell surface with a known force. Within the limits we have described, we can show that the load (determined by precalibration of the device) divided by the projected area of the contact patch (determined by video microscopy) provides a direct, rapid, and accurate measure of the internal turgor pressure of the cell. We demonstrate, by parallel measurements with the pressure probe, that our method yields pressure data that are consistent with those from the pressure probe. Also, by incubating target tissues in stepped concentrations of mannitol to incrementally reduce the turgor pressure, we show that the pressures measured by tonometry accurately reflect the predicted changes from the osmotic potential of the bathing medium. The advantages of this new method over the pressure probe are considerable, however, in that we can move rapidly from cell to cell, taking measurements every 20 s. In addition, the nondestructive nature of the method means that we can return to the same cell repeatedly for periodic pressure measurements. The limitations of the method lie in the fact that it is suitable only for superficial cells that are directly accessible to the probe and to cells that are relatively thin walled and not heavily decorated with surface features. It is also not suitable for measuring pressures in flaccid cells.

Cell Physiological Phenomena↗
PubMed1998

Mechanotransduction molecules in the plant gravisensory response: amyloplast/statolith membranes contain a beta 1 integrin-like protein.

It has been hypothesized that the sedimentation of amyloplasts within root cap cells is the primary event in the plant gravisensory-signal transduction cascade. Statolith sedimentation, with its ability to generate weighty mechanical signals, is a legitimate means for organisms to discriminate the direction of the gravity vector. However, it has been demonstrated that starchless mutants with reduced statolith densities maintain some ability to sense gravity, calling into question the statolith sedimentation hypothesis. Here we report on the presence of a beta 1 integrin-like protein localized inside amyloplasts of tobacco NT-1 suspension culture, callus cells, and whole-root caps. Two different antibodies to the beta 1 integrin, one to the cytoplasmic domain and one to the extracellular domain, localize in the vicinity of the starch grains within amyloplasts of NT-1. Biochemical data reveals a 110-kDa protein immunoprecipitated from membrane fractions of NT-1 suspension culture indicating size homology to known beta 1 integrin in animals. This study provides the first direct evidence for the possibility of integrin-mediated signal transduction in the perception of gravity by higher plants. An integrin-mediated pathway, initiated by starch grain sedimentation within the amyloplast, may provide the signal amplification necessary to explain the gravitropic response in starch-depleted cultivars.

Gravity Sensing↗
PubMed1997

Mechanical signals in plant development: a new method for single cell studies.

Cell division, which is critical to plant development and morphology, requires the orchestration of hundreds of intracellular processes. In the end, however, cells must make critical decisions, based on a discrete set of mechanical signals such as stress, strain, and shear, to divide in such a way that they will survive the mechanical loads generated by turgor pressure and cell enlargement within the growing tissues. Here we report on a method whereby tobacco protoplasts swirled into a 1.5% agarose entrapment medium will survive and divide. The application of a controlled mechanical load to agarose blocks containing protoplasts orients the primary division plane of the embedded cells. Photoelastic analysis of the agarose entrapment medium can identify the lines of principal stress within the agarose, confirming the hypothesis that cells divide either parallel or perpendicular to the principal stress tensors. The coincidence between the orientation of the new division wall and the orientation of the principal stress tensors suggests that the perception of mechanical stress is a characteristic of individual plant cells. The ability of a cell to determine a shear-free orientation for a new partition wall may be related to the applied load through the deformation of the matrix material. In an isotropic matrix a uniaxial load will produce a rotationally symmetric strain field, which will define a shear-free plane. Where high stress intensities combine with the loading geometry to produce multiaxial loads there will be no axis of rotational symmetry and hence no shear free plane. This suggests that two mechanisms may be orienting the division plane, one a mechanism that works in rotationally symmetrical fields, yielding divisions perpendicular to the compressive tensor, parallel to the long axis of the cell, and one in asymmetric fields, yielding divisions parallel to the short axis of the cell and the compressive tensor.

Cell Division↗
PubMed1993

Fluorescence microscopy of fresh tissue as a rapid technique for assessing early injury to mesophyll.

A technique was developed for sectioning fresh red spruce foliage (Picea rubens Sarg.) for use in fluorescence microscopy. This allowed rapid examination of mesophyll in 3-5 mm needle sections. Healthy, ozone treated and cold stressed needles were examined to assess the utility of this technique for early detection of damage. Healthy mesophyll cells fluoresced bright red, while injured cells fluoresced yellow-green in ozone treated needles, and yellow-orange green in ozone treated needles, and yellow-orange in frozen needles. Shifts in fluorescence wave-lengths may be useful for early detection of injury to mesophyll before it is evident by standard light or electron microscopy.

Cryopreservation↗