Biomedical subjects

P Milani

Publications and source records attributed to P Milani.

At least 19 recordsLinked to original sources

PubMed2006

Changes in the recruitment curve of the soleus H-reflex associated with chronic low back pain.

OBJECTIVE: We investigated whether patients with chronic low back pain (CLBP) manifest changes in the excitability of the soleus H-reflex. METHODS: H-reflex stimulus-response curve was studied in 14 CLBP patients and 14 age-matched healthy subjects. H-threshold, H-maximum size, H-steepness and H-latency were determined for both legs. Homosynaptic depression (HD), following a train of H-reflexes, and presynaptic inhibition (PI) from flexor afferents onto soleus Ia afferents were also evaluated. RESULTS: H-threshold was significantly increased, H-size as a function of stimulus intensity was significantly different, and H-recruitment curve steepness was significantly lower in CLBP patients compared to healthy subjects. No significant difference in the amount of HD and PI of the H-reflex was found between the two groups. H-latency and Hmax/Mmax ratio was comparable between the subjects groups. CONCLUSIONS: In CLBP there is a reduced excitability of group Ia afferent fibres from the soleus muscle to which presynaptic factors do not seem to contribute and that presumably depend on changes in the peripheral sensory input. SIGNIFICANCE: Changes in H-reflex excitability may underlie a decrease in the gain of a peripheral sensor in CLBP. Estimation of soleus H-threshold and H-recruitment curve may contribute to the diagnostic evaluation of CLBP and may be used to monitor the efficacy of treatment.

Adult↗

PubMed2006

The role of gas dynamics in operation conditions of a Pulsed Microplasma Cluster Source for nanostructured thin films deposition.

This study intends to explain the fluid dynamic characteristics of a Pulsed Microplasma Cluster Source (PMCS). An axially symmetric steady state simulation is performed for modeling the real-life three-dimensional unsteady flow of hypersonic helium inside our PMCS. Hypersonic helium flow is simulated using Realizable k-epsilon turbulent model. We obtained the jet velocity, density, and pressure field inside our PMCS for the conditions considered and discussed them with respect to our experimental observations. We also presented a qualitative discussion on the formation-termination process of this hypersonic jet. In particular, simulation, in agreement with the experiment, indicates that the middle stage of the injection process, where the Mach disk stands close to the ablation target and at the same time the mass flow rate is relatively high, is almost the appropriate time for firing the electric discharge. We simulated the jet-electrode impingement and tracked the trajectory of the ablated carbon clusters, considered as rigid spheres, inside the PMCS. We noticed that the spatial distribution of the clusters inside PMCS is highly conserved during the free expansion of the cluster beam out of the nozzle (in the vacuum chambers) and is recognizable in the deposited carbon film. This indicates that the geometry of PMCS plays a significant role in the uniformity of the deposited film.

Computer Simulation↗

PubMed2005

Post-activation depression in various group I spinal pathways in humans.

This investigation was designed to study the effects of post-activation depression in different spinal pathways fed by group I afferents available to investigation in human subjects. It was precipitated by a recent investigation in the cat showing that-contrary to the general assumption-post-activation depression is not a widespread phenomenon in the spinal cord. In 24 healthy subjects comparison was made between the effects of low and high-test stimulus rates on the monosynaptic Ia excitation, known to be subject to post-activation depression, and on oligosynaptic pathways fed by group I afferents. Both the amplitude of monosynaptic H reflexes and the amount of heteronymous monosynaptic Ia facilitation were significantly smaller at high than at low-test stimulus rates (1-2 s compared with 6-8 s between two consecutive stimuli). So was the amount of reciprocal Ia inhibition of tibialis anterior motoneurones. In contrast, the amount of other non-monosynaptic group I effects directed to the same motor nuclei (peroneal-induced excitation of quadriceps motoneurones, disynaptic non-reciprocal group I inhibition of flexor carpi radialis motoneurones, and D1 inhibition of flexor carpi radialis and soleus H reflexes) were enhanced at high stimulus rates. Results in humans confirm that post-activation depression depends on the type of group I afferents, and/or on the target neurones. The functional significance of the discrepancy between post-activation depression in pure Ia pathways and in other group I pathways is discussed with regard to the fusimotor-driven servo-assistance from Ia afferent discharges.

Adult↗

PubMed2005

Micro- and nanoscale modification of poly(2-hydroxyethyl methacrylate) hydrogels by AFM lithography and nanoparticle incorporation.

Poly(2-hydroxyethyl methacrylate) (PHEMA) hydrogels are widely used as biomaterials. Due to their unique combination of biocompatibility and good mechanical properties, they have potential as scaffolds for tissue engineering applications. To this purpose, topographic and chemical patterning at the nano- to the mesoscale is crucial in order to favor and to characterize cell adhesion and proliferation. Here we report the characterization of as-prepared and patterned PHEMA hydrogels, produced by conventional radical polymerization in water and dimethylformamide. We have obtained chemical and morphological micro- and nanoscale patterning by atomic force microscopy based lithography. We also demonstrate that it is possible to incorporate carbon nanoparticles in the hydrogel matrix by supersonic cluster beam deposition.

Biocompatible Materials↗

PubMed2005

Nanocrystalline metal/carbon composites produced by supersonic cluster beam deposition.

In this work we show that supersonic cluster beam deposition is a viable method for the synthesis of nanocrystalline metal/carbon composites. By assembling carbon and metallic clusters seeded in a supersonic beam, we have grown films consisting of metal nanoparticles embedded in a nano-structured carbon matrix. Samples containing 3d transition metals (Ti, Ni) and noble metals (Au, Pd, Pt) with different metal abundances, particle size and dilution have been characterized by transmission electron microscopy. The influence of different metals on the structure of the carbon matrix has been investigated. Spatially resolved ultraviolet photoemission electron spectroscopy showed substantial surface oxidation of 3d transition metal clusters. On a micrometric scale, the spatial distribution of the metallic nanoparticles appeared to be homogeneous.

Carbon↗

PubMed2004

Hugoniot data for carbon at megabar pressures.

We present an experimental point for the carbon equation of state (EOS) at megabar pressures, obtained by laser-driven shock waves. The rear side emissivity of "two-materials two-steps" targets (Al-C) was recorded with space and time resolution and, by applying the impedance mismatch method, allowed a direct determination of relative EOS points. Experiments were performed at the PALS and LULI laboratories using carbon samples with two different values of initial density, in order to explore a wider region of the phase diagram. Previously unreached pressures were obtained. The results are compared with previous experiments and with available theoretical models and seem to show a high compressibility of carbon at megabar pressures.

Journal Article↗

PubMed2004

Explosive-aggressive behavior related to bilateral subthalamic stimulation.

We describe a patient with Parkinson's Disease who underwent bilateral subthalamic nucleus deep brain stimulation and later presented with episodes of aggressive behavior disorder with disturbed impulse control and an inability to control anger likely related to the deep brain stimulation "switch-on stimulation". We hypothesize that increasing voltage intensity could influence neighboring passing fibers coming from basal limbic system that are involved in the regulation of affect and emotional behavior. We suggest investigating these neuropsychological disturbances considering their influence on quality of life after surgery.

Aggression↗

PubMed2004

Atomic force microscopy study of DNA deposited on poly L-ornithine-coated mica.

Analyses of individual biomolecules, like DNA, or DNA-protein complexes, via atomic force microscopy, require 'gentle' methods to immobilize DNA on surfaces, which allow the ensemble of molecules to adopt conformations dictated primarily by their physical characteristics, and which possibly permit the use of a wide selection of buffers. We show that poly-L-ornithine-coated mica is a good substrate for fast, reliable deposition of DNA for wet or dry imaging. The surface firmly secures DNA, which retains the B-form helical rise (0.34 nm bp(-1)). The conformations of DNA that result are reminiscent of three-dimensional random coils projected on to a plane. The contrast is good, especially in solution, and buffers with physiological concentrations of salt with or without divalent cations may be used. This is important for comparison of scanning probe microscopy results with those obtained by different techniques.

Aluminum Silicates↗

PubMed2002

Cluster-beam deposition and in situ characterization of carbyne-rich carbon films.

Nanostructured carbon films produced by supersonic cluster beam deposition have been studied by in situ Raman spectroscopy. Raman spectra show the formation of a sp2 solid with a very large fraction of sp-coordinated carbyne species with a long-term stability under ultrahigh vacuum. Distinct Raman contributions from polyyne and cumulene species have been observed, as well as different stabilities under gas exposure. Our experiments confirm theoretical predictions and demonstrate the possibility of producing a carbyne-rich pure carbon solid. The stability of the sp2-sp network has important implications for astrophysics and for the production of novel carbon-based systems.

Journal Article↗

PubMed2002

Fractal analysis of sampled profiles: systematic study.

A quantitative evaluation of the influence of sampling on the numerical fractal analysis of experimental profiles is of critical importance. Although this aspect has been widely recognized, a systematic analysis of the sampling influence is still lacking. Here we present the results of a systematic analysis of synthetic self-affine profiles in order to clarify the consequences of the application of a poor sampling (up to 1000 points) typical of scanning probe microscopy for the characterization of real interfaces and surfaces. We interpret our results in terms of a deviation and a dispersion of the measured exponent with respect to the "true" one. Both the deviation and the dispersion have always been disregarded in the experimental literature, and this can be very misleading if results obtained from poorly sampled images are presented. We provide reasonable arguments to assess the universality of these effects and propose an empirical method to take them into account. We show that it is possible to correct the deviation of the measured Hurst exponent from the "true" one and give a reasonable estimate of the dispersion error. The last estimate is particularly important in the experimental results since it is an intrinsic error that depends only on the number of sampling points and can easily overwhelm the statistical error. Finally, we test our empirical method calculating the Hurst exponent for the well-known 1+1 dimensional directed percolation profiles, with a 512-point sampling.

Journal Article↗

PubMed2002

Nanofriction behavior of cluster-assembled carbon films.

We have characterized the frictional properties of nanostructured carbon films grown by supersonic cluster beam deposition via an atomic force-friction force microscope (AFM-FFM). The experimental data are discussed on the basis of a modified Amonton's law for friction, stating a linear dependence of friction on load plus an adhesive offset accounting for a finite friction force in the limit of null total applied load. Molecular dynamics simulations of the interaction of the AFM tip with the nanostructured carbon confirm the validity of the friction model used for this system. Experimental results show that the friction coefficient is not influenced by the nanostructure of the films nor by the relative humidity. On the other hand the adhesion coefficient depends on these parameters.

Carbon↗

PubMed2002

A simple method for the synthesis of silicon carbide nanorods.

SiC nanorods were synthesized by a reaction at a temperature of 1200 degrees C, under an argon gas atmosphere, from silicon and amorphous carbon powders mixed by ball milling. The reaction product, which contain SiC nanorods and nanoparticles, has been characterized by high-resolution transmission electron microscopy, X-ray diffraction, and micro-Raman spectroscopy. The synthesized nanorods are more than 1 micron long with a mean diameter of about 10-30 nm. The nanorods possess a well-defined crystalline structure with a thin layer of amorphous SiO2 on the surface. Raman shifts of SiC nanorods and the role of structural defects are discussed.

Carbon Compounds, Inorganic↗

PubMed1992