PubMed Health⌕ Search

Biomedical subjects

Paul E Sojka

Publications and source records attributed to Paul E Sojka.

2 recordsLinked to original sources

Droplet dynamics and ionization mechanisms in desorption electrospray ionization mass spectrometry.

A droplet pickup and other mechanisms have been suggested for the ionization of biomolecules like peptides and proteins by desorption electrospray ionization. To verify this hypothesis phase Doppler particle analysis was used to study the sizes and velocities of droplets involved in DESI. It was found that impacting droplets typically have velocities of 120 m/s and average diameters of 2-4 microm. Small differences in sprayer construction influence the operating conditions at which droplets of these dimensions are produced. Under these conditions, the kinetic energy per impacting water molecule is less than 0.6 meV and sputtering through momentum transfer during collisions or ionization by other electronic processes is unlikely. Droplets arrive at the surface with velocities well below the speed of sound in common materials, thereby excluding the possibility of ionization by shockwave formation. Some droplets appear to roll along the surface, increasing contact time and presumably the amount of material that is taken up into droplets during conditions typical of the DESI experiment.

Journal Article↗

Design and atomization properties for an inside-out type effervescent atomizer.

Atomization of aqueous polymer solutions is a key step in the formulation of several pharmaceutical products. Droplet size control is essential in order to produce pharmaceutical products with the desired properties. The purpose of this paper is to investigate design issues for an inside-out type of effervescent atomizer used to spray water and aqueous solutions of polyvinylpyrrolidone (Kollidon K-30) and hydroxypropyl methylcellulose (Pharmacoat 603). The atomizer was operated at air-to-liquid mass ratios of 0.1, 0.3, and 0.5 and a feed pressure of 1172 kPa. Fluid viscosities ranged from 1 to 47 mPa.s. The influence of several atomizer design features was considered, including exit orifice length-to-diameter ratio, exit orifice diameter, the total area of the air injection holes, the distance between the air injection point and the exit orifice, the diameter of the mixing chamber, and the orientation of both air and liquid flows. Droplet size distributions were shown to vary significantly with the atomizer's exit orifice diameter, air injector design, and air injector distance to the exit orifice. In all cases air-to-liquid mass ratio played a key role in the mean droplet size. The design of the atomizer was shown to have the most pronounced effect on the mean droplet size at the lowest air-to-liquid mass ratios. Optimization of the atomizer design is very important in order to obtain small droplet sizes in pharmaceutical processes where the amount of air/gas should be minimized, e.g., closed-cycle spray drying and agglomeration processes.

Chemical Phenomena↗