Biomedical subjects

Paul L Dubin

Publications and source records attributed to Paul L Dubin.

8 recordsLinked to original sources

PubMed2006

Carboxylated ficolls: preparation, characterization, and electrophoretic behavior of model charged nanospheres.

Carboxylated ficolls were prepared as model spherical colloids of variable charge and size, with radii ranging from 3.0 to 19.3 nm. Capillary electrophoresis (CE), electrophoretic light scattering (ELS), and potentiometric titration were used to determine mobilities as a function of pH, degree of ionization alpha, and surface potential psi(0). Measured mobilities typically display a plateau at high pH, corresponding to high alpha and psi(0), confirming the general nature of this effect for charged spheres, seen also for charged dendrimers and charged latex particles. This result is examined in the context of a discontinuity in mobility predicted by the Wiersema, O'Brien, and White (WOW) theory and a more recent primitive model electrophoresis (PME) theory, in which bound counterions are considered either as point charges or as hard spheres. While no mobility maximum can be determined as expected by these two theories, our data seem more to support Belloni's theoretical expectations on charged polymers and spheres. Here we explain the mobility plateaus in terms of counterions accumulated close to the surface (surface potential-determining ions) or within the shear plane (mobility-determining ions).

Carboxylic Acids↗

PubMed2006

Electrostatically driven protein aggregation: beta-lactoglobulin at low ionic strength.

The aggregation of beta-lactoglobulin (BLG) at ambient temperature was studied using turbidimetry and dynamic light scattering in the range 3.8<pH<5.2 in 0.0045 M NaCl, and in the ionic strength range 0.0045-0.5 M at fixed pH=5.0. The initial rate of aggregation, taken as the initial slope of turbidity vs time, (dtau/dt)0, indicated maximum aggregation near pH 4.6 (below the isoelectric point of 5.2), but the dependence of the initial rate of aggregation on pH was highly asymmetric. At pH 5.0, (dtau/dt)0 strongly increased with a decrease in ionic strength I from 0.1 to 0.0045 M and was found to be nearly linear with 1/I. DLS measurements revealed an increase in particle size with time, with the appearance of bimodal distributions in which the fast and slow modes corresponded, respectively, to a BLG dimer and to larger aggregates in the 100-800 nm range. At conditions of slower aggregation, DLS revealed the consumption of dimers to form higher order aggregates with no intermediate species. Computer modeling (Delphi) was used to visualize the electrostatic potential around the dimer to elucidate the pH and ionic strength dependence of the initial aggregation rates. The aggregation process appears to comprise an initial fast consumption of the dimer, whose dependence on pH and I arises from the interaction of the positive and negative domains of interacting dimers, followed by the slow formation of much larger aggregates with relatively little sensitivity to pH and I. The open-ended nature of BLG aggregation is thought to arise from the asymmetry of the dimer charge distribution.

Hydrogen-Ion Concentration↗

PubMed2006

Effects of polyelectrolyte chain stiffness, charge mobility, and charge sequences on binding to proteins and micelles.

The binding affinities of polyanions for bovine serum albumin in NaCl solutions from I = 0.01-0.6 M, were evaluated on the basis of the pH at the point of incipient binding, converting each such pH(c) value into a critical protein charge Zc. Analogous values of critical charge for mixed micelles were obtained as the cationic surfactant mole fraction Yc. The data were well fitted as Yc or Zc = KI a, and values of K and a were considered as a function of normalized polymer charge densities (tau), charge mobility, and chain stiffness. Binding increased with chain flexibility and charge mobility, as expected from simulations and theory. Complex effects of tau were related to intrapolyanion repulsions within micelle-bound loops (seen in the simulations) or negative protein domain-polyanion repulsions. The linearity of Zc with radicalI at I < 0.3 M was explained by using protein electrostatic images, showing that Zc at I < 0.3 M depends on a single positive "patch"; the appearance of multiple positive domains I > 0.3 M (lower pH(c)) disrupts this simple behavior.

Animals↗

PubMed2005

Uptake of organic pollutants by silica--polycation-Immobilized micelles for groundwater remediation.

Interest has grown in designing new materials for groundwater treatment via "permeable reactive barriers". In the present case, a model siliceous surface, controlled pore glass (CPG), was treated with a polycation (quaternized polyvinyl pyridine, QPVP) which immobilizes anionic/nonionic mixed micelles, in order to solubilize a variety of hydrophobic pollutants. Polymer adsorption on CPG showed atypically slow kinetics and linear adsorption isotherms, which may be a consequence of the substrate porosity. The highest toluene solubilization efficiency was achieved for the silica-polycation-immobilized micelles (SPIM) with the highest polymer loading and lowest micelle binding, a result discussed in terms of the configuration of the bound polymer and the corresponding state of the bound micelles. The ability of SPIM to treat simultaneously a wide range of pollutants and reduce their concentration in solution by 20-90% was demonstrated. Optimization of SPIM systems for remediation calls for a better understanding of both the local environment of the bound micelles and their intrinsic affinities for different hydrophobic pollutants.

Adsorption↗

PubMed2005

Toluene solubilization induces different modes of mixed micelle growth.

The effect of toluene solubilization on the size and mobility of Triton X100 (TX100) micelles and TX100/sodium dodecyl sulfate (SDS) mixed micelles was studied by turbidimetry, dynamic light scattering, and capillary electrophoresis. Micelle growth due to toluene solubilization was observed for both surfactant systems; however, two different modes of growth were seen. Mixed micelles in 0.1 M NaCl are spherical (apparent diameter d(app) = 8 nm) and remain so while taking up 3 mM toluene, with a volume increase per micelle of deltaV(m) = 50 nm3. In 0.5 M NaCl, the large d(app) of both nonionic and mixed micelles (14 and 24 nm, respectively) indicate ellipsoidal or rodlike shapes, and their large increases in d(app) upon addition of 3 mM toluene thus correspond to elongational growth, with the same deltaV(m) = 50 nm3. Further addition of toluene to TX100/SDS in 0.5 M NaCl results in a dramatic increase in micelle size followed by an unexpected bimodal size distribution. The addition of excess toluene leads to the formation of ca. 140 nm toluene droplets, stabilized mainly by monomers of the high critical micelle concentration surfactant, SDS. These microemulsions coexist with the smaller (20 nm) swollen mixed micelles.

Journal Article↗

PubMed2005

Characterization of polyanion-protein complexes by frontal analysis continuous capillary electrophoresis and small angle neutron scattering: effect of polyanion flexibility.

The binding constant (K(obs)) for the beta-lactoglobulin-poly(vinylsulfate) (BLG-PVS) complex was measured by frontal analysis continuous capillary electrophoresis at pH values above the isoelectric point of BLG, and the persistence length (L(p)) of PVS was measured by small angle neutron scattering, to examine the effect of polyelectrolyte chain stiffness on its binding efficiency to proteins. The values of K(obs) and L(p) were compared with those of BLG-PSS and BLG-PAMPS (poly(2-acrylamido-2-methylpropanesulfonate)) reported previously. The relationship between K(obs) and L(p) was reciprocal, indicating that protein binding is enhanced by the flexibility of the polyanion, at least in the case where the net protein charge is negative. In addition, at a fixed pH, the polymer systems displayed a similar ionic strength dependence of K(obs). This similarity was consistent with the proposal that the binding properties of PVS and PAMPS polyanions are governed purely by electrostatic interactions and are independent of their molecular structure.

Electrophoresis, Capillary↗

PubMed2004

Frontal analysis continuous capillary electrophoresis for protein-polyelectrolyte binding studies.

A novel technique, frontal analysis continuous capillary electrophoresis (FACCE), has been described as an effective way to study protein-polyelectrolyte binding. FACCE involves continuous sampling, integrating sample injection and separation into one process that provides advantages over conventional frontal chromatography. The method provides rapid and precise determination of binding isotherms, and allows for quantitative binding analysis in terms of binding constant and the binding-site size by considering the protein as the ligand and allowing the polyelectrolyte to bind to a number of proteins with variable levels of cooperativity. FACCE is particularly suitable for binding systems involving rapid binding kinetics because it allows for the determination of the concentrations of free or bound ligands under conditions that avoid perturbation of the binding equilibrium. This chapter focuses on studies of the binding of bovine serum albumin (BSA) to heparin using FACCE. These investigations are demonstrated within the context of this chapter as representative of a model protein-polyelectrolyte system from which extensions to other systems can be made.

Animals↗

PubMedDate not supplied

Ionic strength dependence of protein-polyelectrolyte interactions.

The effect of univalent electrolyte concentration on protein-polyelectrolyte complex formation has been measured by frontal analysis continuous capillary electrophoresis (FACCE) and turbidimetry for the interaction of bovine serum albumin (BSA) with a synthetic hydrophobically modified polyacid, for BSA with (porcine mucosal) heparin (Hp), a highly charged polyanion, and for Hp and insulin. All three highly diverse systems display maxima or plateaus in complex formation in the range of ionic strength 5 < I < 30 mM, confirmed in the case of BSA-Hp by multiple techniques. Similar maxima are reported in the literature, but with little discussion, for BSA-poly(dimethyldiallylammonium chloride), lysozyme-hyaluronic acid, and lysozyme-chondroitin sulfate, always in the I range 5-30 mM. While inversion of salt effect has been discussed specifically for the interaction of gelatin and sodium polystyrenesulfonate with gelatin(28) and with beta-lactoglobulin,(10) the general nature of this phenomenon, regardless of polyelectrolyte origin, molecular weight, and charge sign has not been recognized. The position of the maxima and their occurrence when protein and polyelectrolyte have the same net charge imply that they arise when Debye lengths extend, at low I, beyond half the protein diameter so that addition of salt screens repulsions, as well as attractions. This appears to be a general effect caused by electrostatic repulsions that can coexist simultaneously with hydrophobic interactions. Modeling of protein electrostatics via Delphi is used to visualize this effect for BSA, lysozyme, insulin, and beta-lactoglobulin.

Electrolytes↗