Biomedical subjects

Paul L McEuen

Publications and source records attributed to Paul L McEuen.

11 recordsLinked to original sources

PubMed2006

Measurement of the adhesion force between carbon nanotubes and a silicon dioxide substrate.

Carbon nanotube adhesion force measurements were performed on single-walled nanotubes grown over lithographically defined trenches. An applied vertical force from an atomic force microscope (AFM), in force distance mode, caused the tubes to slip across the 250-nm-wide silicon dioxide trench tops at an axial tension of 8 nN. The nanotubes slipped at an axial tension of 10 nN after being selectively coated with a silicon dioxide layer.

Microscopy, Atomic Force↗

PubMed2006

Probing electrostatic potentials in solution with carbon nanotube transistors.

We have used single-walled carbon nanotube transistors to measure changes in the chemical potential of a solution due to redox-active transition-metal complexes. The interaction of the molecules with a gold electrolyte-gate wire changes the electrostatic potential sensed by the nanotube, which in turn shifts the gate-voltage dependence of the nanotube conductance. As predicted by the Nernst equation, this shift depends logarithmically on the ratio of oxidized to reduced molecules.

Algorithms↗

PubMed2005

Band structure, phonon scattering, and the performance limit of single-walled carbon nanotube transistors.

Semiconducting single-walled carbon nanotubes are studied in the diffusive transport regime. The peak mobility is found to scale with the square of the nanotube diameter and inversely with temperature. The maximum conductance, corrected for the contacts, is linear in the diameter and inverse temperature. These results are in good agreement with theoretical predictions for acoustic phonon scattering in combination with the unusual band structure of nanotubes. These measurements set the upper bound for the performance of nanotube transistors operating in the diffusive regime.

Journal Article↗

PubMed2005

Coulomb oscillations and Hall effect in quasi-2D graphite quantum dots.

We perform low-temperature electrical transport measurements on gated, quasi-2D graphite quantum dots. In devices with low contact resistances, we use longitudinal and Hall resistances to extract carrier densities of 9.2-13 x 10(12) cm(-2) and mobilities of 200-1900 cm(2)/V.s. In devices with high resistance contacts, we observe Coulomb blockade phenomena and infer the charging energies and capacitive couplings. These experiments demonstrate that electrons in mesoscopic graphite pieces are delocalized over nearly the whole graphite piece down to low temperatures.

Electric Conductivity↗

PubMed2004

The Kondo effect in the presence of ferromagnetism.

We measured Kondo-assisted tunneling via C60 molecules in contact with ferromagnetic nickel electrodes. Kondo correlations persisted despite the presence of ferromagnetism, but the Kondo peak in the differential conductance was split by an amount that decreased (even to zero) as the moments in the two electrodes were turned from parallel to antiparallel alignment. The splitting is too large to be explained by a local magnetic field. However, the voltage, temperature, and magnetic field dependence of the signals agree with predictions for an exchange splitting of the Kondo resonance. The Kondo effect leads to negative values of magnetoresistance, with magnitudes much larger than the Julliere estimate.

Journal Article↗

PubMed2004

A tunable carbon nanotube electromechanical oscillator.

Nanoelectromechanical systems (NEMS) hold promise for a number of scientific and technological applications. In particular, NEMS oscillators have been proposed for use in ultrasensitive mass detection, radio-frequency signal processing, and as a model system for exploring quantum phenomena in macroscopic systems. Perhaps the ultimate material for these applications is a carbon nanotube. They are the stiffest material known, have low density, ultrasmall cross-sections and can be defect-free. Equally important, a nanotube can act as a transistor and thus may be able to sense its own motion. In spite of this great promise, a room-temperature, self-detecting nanotube oscillator has not been realized, although some progress has been made. Here we report the electrical actuation and detection of the guitar-string-like oscillation modes of doubly clamped nanotube oscillators. We show that the resonance frequency can be widely tuned and that the devices can be used to transduce very small forces.

Journal Article↗

PubMed2004

Determination of electron orbital magnetic moments in carbon nanotubes.

The remarkable transport properties of carbon nanotubes (CNTs) are determined by their unusual electronic structure. The electronic states of a carbon nanotube form one-dimensional electron and hole sub-bands, which, in general, are separated by an energy gap. States near the energy gap are predicted to have an orbital magnetic moment, mu(orb), that is much larger than the Bohr magneton (the magnetic moment of an electron due to its spin). This large moment is due to the motion of electrons around the circumference of the nanotube, and is thought to play a role in the magnetic susceptibility of CNTs and the magnetoresistance observed in large multiwalled CNTs. But the coupling between magnetic field and the electronic states of individual nanotubes remains to be quantified experimentally. Here we report electrical measurements of relatively small diameter (2-5 nm) individual CNTs in the presence of an axial magnetic field. We observe field-induced energy shifts of electronic states and the associated changes in sub-band structure, which enable us to confirm quantitatively the predicted values for mu(orb).

Journal Article↗

PubMed2003

Controlled assembly of dendrimer-like DNA.

DNA possesses many desirable chemical/physical properties as a polymeric material. With the myriad of tools available to manipulate DNA, there is great potential for using DNA as a generic instead of a genetic material. Although much progress has been made in DNA computing and DNA nanotechnology, the full achievement of DNA-based materials has not yet been realized. As almost all DNA molecules are either linear or circular, to rationally construct DNA materials one must first create additional shapes of DNA as basic building blocks. In addition, these DNA building blocks must be readily incorporated into larger structures in a controlled manner. Here, we show the controlled assembly of dendrimer-like DNA (DL-DNA) from Y-shaped DNA (Y-DNA). The synthesis of Y-DNA and controlled assembly of DL-DNA were robust and efficient; the resulting DL-DNA was stable and almost monodisperse. The multivalent DNA dendrimers can be either isotropic or anisotropic, providing great potential to link other entities.

Base Sequence↗

PubMed2003

Tuning carbon nanotube band gaps with strain.

We show that the band structure of a carbon nanotube (NT) can be dramatically altered by mechanical strain. We employ an atomic force microscope tip to simultaneously vary the NT strain and to electrostatically gate the tube. We show that strain can open a band gap in a metallic NT and modify the band gap in a semiconducting NT. Theoretical work predicts that band gap changes can range between +/-100 meV per 1% stretch, depending on NT chirality, and our measurements are consistent with this predicted range.

Journal Article↗

PubMed2002

Coulomb blockade and the Kondo effect in single-atom transistors.

Using molecules as electronic components is a powerful new direction in the science and technology of nanometre-scale systems. Experiments to date have examined a multitude of molecules conducting in parallel, or, in some cases, transport through single molecules. The latter includes molecules probed in a two-terminal geometry using mechanically controlled break junctions or scanning probes as well as three-terminal single-molecule transistors made from carbon nanotubes, C(60) molecules, and conjugated molecules diluted in a less-conducting molecular layer. The ultimate limit would be a device where electrons hop on to, and off from, a single atom between two contacts. Here we describe transistors incorporating a transition-metal complex designed so that electron transport occurs through well-defined charge states of a single atom. We examine two related molecules containing a Co ion bonded to polypyridyl ligands, attached to insulating tethers of different lengths. Changing the length of the insulating tether alters the coupling of the ion to the electrodes, enabling the fabrication of devices that exhibit either single-electron phenomena, such as Coulomb blockade, or the Kondo effect.

Journal Article↗

PubMed2002

Scanned probe imaging of single-electron charge states in nanotube quantum dots.

An atomic force microscope was used to study single-electron motion in nanotube quantum dots. By applying a voltage to the microscope tip, the number of electrons occupying the quantum dot could be changed, causing Coulomb oscillations in the nanotube conductance. Spatial maps of these oscillations were used to locate individual dots and to study the electrostatic coupling between the dot and the tip. The electrostatic forces associated with single electrons hopping on and off the quantum dot were also measured. These forces changed the amplitude, frequency, and quality factor of the cantilever oscillation, demonstrating how single-electron motion can interact with a mechanical oscillator.

Journal Article↗