PubMed Health⌕ Search

Biomedical subjects

Peter E Blöchl

Publications and source records attributed to Peter E Blöchl.

6 recordsLinked to original sources

Structural and electronic properties of the interface between the high-k Oxide LaAlO3 and Si(001).

The structural and electronic properties of the LaAlO(3)/Si(001) interface are determined using state-of-the-art electronic structure calculations. The atomic structure differs from previous proposals, but is reminiscent of La adsorption structures on silicon. A phase diagram of the interface stability is calculated as a function of oxygen and Al chemical potentials. We find that an electronically saturated interface is obtained only if Al atoms substitute some of the interfacial Si atoms. These findings raise serious doubts whether LaAlO3 can be used as an epitaxial gate dielectric.

Journal Article↗

Activation and protonation of dinitrogen at the FeMo cofactor of nitrogenase.

The protonation of N2 bound to the active center of nitrogenase has been investigated using state-of-the-art density-functional theory calculations. Dinitrogen in the bridging mode is activated by forming two bonds to Fe sites, which results in a reduction of the energy for the first hydrogen transfer by 123 kJ/mol. The axial binding mode with open sulfur bridge is less reactive by 30 kJ/mol and the energetic ordering of the axial and bridged binding modes is reversed in favor of the bridging dinitrogen during the first protonation. Protonation of the central ligand is thermodynamically favorable but kinetically hindered. If the central ligand is protonated, the proton is transferred to dinitrogen following the second protonation. Protonation of dinitrogen at the Mo site does not lead to low-energy intermediates.

Binding Sites↗

Model for acetylene reduction by nitrogenase derived from density functional theory.

The catalytic cycle of acetylene reduction at the FeMo cofactor of nitrogenase has been investigated on the basis of density functional theory. C2H2 binds to the same site as N2, but it binds to a less reduced state of the cofactor. In a manner similar to that of N2 binding, one of the sulfur bridges opens during acetylene binding. The model explains the strong noncompetitive inhibition of N2 reduction by C2H2 and the weak competitive inhibition of C2H2 reduction by N2. Our proposed mechanism is consistent with experimentally observed stereoselectivity and the ability of C2H2 to suppress H2 production by nitrogenase.

Acetylene↗

The interface between silicon and a high-k oxide.

The ability of the semiconductor industry to continue scaling microelectronic devices to ever smaller dimensions (a trend known as Moore's Law) is limited by quantum mechanical effects: as the thickness of conventional silicon dioxide (SiO(2)) gate insulators is reduced to just a few atomic layers, electrons can tunnel directly through the films. Continued device scaling will therefore probably require the replacement of the insulator with high-dielectric-constant (high-k) oxides, to increase its thickness, thus preventing tunnelling currents while retaining the electronic properties of an ultrathin SiO(2) film. Ultimately, such insulators will require an atomically defined interface with silicon without an interfacial SiO(2) layer for optimal performance. Following the first reports of epitaxial growth of AO and ABO(3) compounds on silicon, the formation of an atomically abrupt crystalline interface between strontium titanate and silicon was demonstrated. However, the atomic structure proposed for this interface is questionable because it requires silicon atoms that have coordinations rarely found elsewhere in nature. Here we describe first-principles calculations of the formation of the interface between silicon and strontium titanate and its atomic structure. Our study shows that atomic control of the interfacial structure by altering the chemical environment can dramatically improve the electronic properties of the interface to meet technological requirements. The interface structure and its chemistry may provide guidance for the selection process of other high-k gate oxides and for controlling their growth.

Journal Article↗

Nitrogen binding to the FeMo-cofactor of nitrogenase.

Density functional calculations are presented to unravel the first steps of nitrogen fixation of nitrogenase. The individual steps leading from the resting state to nitrogen binding at the FeMo-cofactor with a central nitrogen ligand are characterized. The calculations indicate that the Fe-Mo cage opens as dinitrogen binds to the cluster. In the resting state, the central cage is overall neutral. Electrons and protons are transferred in an alternating manner. Upon dinitrogen binding, one protonated sulfur bridge is broken. An axial and a bridged binding mode of dinitrogen have been identified. Adsorption at the Mo site has been investigated but appears to be less favorable than binding at Fe sites.

Binding Sites↗