Biomedical subjects

Peter S Pershan

Publications and source records attributed to Peter S Pershan.

8 recordsLinked to original sources

PubMed2006

Capillary filling of anodized alumina nanopore arrays.

The filling behavior of a room temperature solvent, perfluoromethylcyclohexane, in approximately 20 nm nanoporous alumina membranes was investigated in situ with small angle x-ray scattering. Adsorption in the pores was controlled reversibly by varying the chemical potential between the sample and a liquid reservoir via a thermal offset, DeltaT. The system exhibited a pronounced hysteretic capillary filling transition as liquid was condensed into the nanopores. These results are compared with Kelvin-Cohan theory, with a modified Derjaguin approximation, as well as with predictions by Cole and Saam.

Aluminum Oxide↗

PubMed2006

Capillary wave fluctuations and intrinsic widths of coupled fluid-fluid interfaces: an x-ray scattering study of a wetting film on bulk liquid.

An x-ray specular reflectivity (XR) and off-specular diffuse scattering (XDS) study of the coupled thermal capillary fluctuations and the intrinsic profiles of two interacting fluid-fluid interfaces is presented. The measurements are carried out on complete wetting films of perfluoromethylcyclohexane (PFMC) on the surface of bulk liquid eicosane (C20), as a function of film thickness 30 infinity), determined by either the radius of gyration (5.3 A) or the bulk correlation length (4.8 A) of the alkane C20. The intrinsic liquid-vapor interfacial width is sharper (approximately 2 A) and remains essentially constant over the entire probed range of D .

Journal Article↗

PubMed2006

Surface crystallization in a liquid AuSi alloy.

X-ray measurements reveal a crystalline monolayer at the surface of the eutectic liquid Au82Si18, at temperatures above the alloy's melting point. Surface-induced atomic layering, the hallmark of liquid metals, is also found below the crystalline monolayer. The layering depth, however, is threefold greater than that of all liquid metals studied to date. The crystallinity of the surface monolayer is notable, considering that AuSi does not form stable bulk crystalline phases at any concentration and temperature and that no crystalline surface phase has been detected thus far in any pure liquid metal or nondilute alloy. These results are discussed in relation to recently suggested models of amorphous alloys.

Journal Article↗

PubMed2005

Liquids on topologically nanopatterned surfaces.

We report here surface x-ray scattering studies of the adsorption of simple hydrocarbon liquid films on nanostructured surfaces-silicon patterned by an array of nanocavities. Two different regimes, filling and growing, are observed for the wetting film evolution as a function of the chemical potential offset from the bulk liquid-vapor coexistence. The strong influence of geometrical effects is manifested by a dependence of liquid adsorption in the nanocavities that is stronger than the van der Waals behavior for flat surfaces. The observed dependence is, however, much weaker than predicted for the infinitely deep parabolic cavities, suggesting that the finite-size effects contribute significantly to the observed adsorption behavior.

Journal Article↗

PubMed2005

Atomic-scale surface demixing in a eutectic liquid BiSn alloy.

Resonant x-ray reflectivity of the surface of the liquid phase of the Bi(43)Sn(57) eutectic alloy reveals atomic-scale demixing extending over three near-surface atomic layers. Because of the absence of an underlying atomic lattice which typically defines adsorption in crystalline alloys, studies of adsorption in liquid alloys provide unique insight on interatomic interactions at the surface. The observed composition modulation could be accounted for quantitatively by the Defay-Prigogine and Strohl-King multilayer extensions of the single-layer Gibbs model, revealing a near-surface domination of the attractive Bi-Sn interaction over the entropy.

Journal Article↗

PubMed2005

Structure of mercaptobiphenyl monolayers on mercury.

The molecular-scale structure and phase behavior of single-component Langmuir films of 4'-methyl-4-mercaptobiphenyl (MMB) and 4'-perfluoromethyl-4-mercaptobiphenyl (FMMB) on mercury were studied using surface tensiometry, grazing incidence X-ray diffraction, and X-ray reflectivity. At low coverages, a condensed but in-plane disordered single layer of surface-parallel molecules is found for both compounds. At high coverages, both compounds exhibit in-plane-ordered phases of standing-up molecules. For MMB, the biphenyl core dominates the structure, yielding a centered-rectangular unit cell with an area A(x) of 21.8 A(2)/molecule, with molecules tilted by approximately 14 degrees from the surface normal in the nearest-neighbor direction, and a coherence length xi of >1000 A for the crystalline domains. For FMMB, the perfluoromethyl group dominates the structure, yielding a hexagonal unit cell with untilted molecules, an area A(x) of 24.2 A(2)/molecule, and a much smaller xi of approximately 110 A. The structure is discussed in comparison with self-assembled monolayers of MMB on crystalline Au(111) and similar-length alkanethiolate SAMs on Au(111) and on mercury. The differences in the structure are discussed and traced to the differences in the substrate's surface structure, and in the molecular cross section and rigidity.

Journal Article↗

PubMed2005

Critical Casimir effect in three-dimensional Ising systems: measurements on binary wetting films.

The critical Casimir force (CF) is observed in thin wetting films of a binary liquid mixture close to the liquid/vapor coexistence. X-ray reflectivity shows thickness (L) enhancement near the bulk consolute point. The extracted Casimir amplitude Delta(+-)=3+/-1 agrees with the theoretical universal value for the antisymmetric 3D Ising films. The onset of CF in the one-phase region occurs at L/xi approximately 5 regardless of whether the bulk correlation length xi is varied with temperature or composition. The shape of the Casimir scaling function depends monotonically on the dimensionality.

Journal Article↗

PubMed2004

Monolayer/bilayer transition in Langmuir films of derivatized gold nanoparticles at the gas/water interface: an x-ray scattering study.

The microscopic structure of Langmuir films of derivatized gold nanoparticles has been studied as a function of area/particle on the water surface. The molecules (AuSHDA) consist of gold particles of mean core diameter D approximately 22 angstroms that have been stabilized by attachment of carboxylic acid terminated alkylthiols, HS-(CH2)15-COOH. Compression of the film results in a broad plateau of finite pressure in the surface pressure versus area/particle isotherm that is consistent with a first-order monolayer/bilayer transition. X-ray specular reflectivity (XR) and grazing incidence diffraction show that when first spread at large area/particle, AuSHDA particles aggregate two dimensionally to form hexagonally packed monolayer domains at a nearest-neighbor distance of a = 34 angstroms. The lateral positional correlations associated with the two-dimensional (2D) hexagonal order are of short range and extend over only a few interparticle distances; this appears to be a result of the polydispersity in particle size. Subsequent compression of the film increases the surface coverage by the monolayer but has little effect on the interparticle distance in the close-packed domains. The XR and off-specular diffuse scattering (XOSDS) results near the onset of the monolayer/bilayer coexistence plateau are consistent with complete surface coverage by a laterally homogeneous monolayer of AuSHDA particles. On the high-density side of the plateau, the electron-density profile extracted from XR clearly shows the formation of a bilayer in which the newly formed second layer on top is slightly less dense than the first layer. In contrast to the case of the homogeneous monolayer, the XOSDS intensities observed from the bilayer are higher than the prediction based on the capillary wave model and the assumption of homogeneity, indicating the presence of lateral density inhomogeneities in the bilayer. According to the results of Bragg rod measurements, the 2D hexagonal order in the two layers of the bilayer are only partially correlated.

Colloids↗