PubMed Health⌕ Search

Biomedical subjects

Peter S Ungar

Publications and source records attributed to Peter S Ungar.

9 recordsLinked to original sources
PubMed2006

Dental microwear texture analysis: technical considerations.

Dental microwear analysis is commonly used to infer aspects of diet in extinct primates. Conventional methods of microwear analysis have usually been limited to two-dimensional imaging studies using a scanning electron microscope and the identification of apparent individual features. These methods have proved time-consuming and prone to subjectivity and observer error. Here we describe a new methodological approach to microwear: dental microwear texture analysis, based on three-dimensional surface measurements taken using white-light confocal microscopy and scale-sensitive fractal analysis. Surface parameters for complexity, scale of maximum complexity, anisotropy, heterogeneity, and textural fill volume offer repeatable, quantitative characterizations of three-dimensional surfaces, free of observer measurement error. Some results are presented to illustrate how these parameters distinguish extant primates with different diets. In this case, microwear surfaces of Cebus apella and Lophocebus albigena, which consume some harder food items, have higher average values for complexity than do folivores or soft fruit eaters.

Alouattinae↗
PubMed2006

Molar microwear in Praeanthropus afarensis: evidence for dietary stasis through time and under diverse paleoecological conditions.

Molar microwear fabrics in extant mammals vary with diet and, more particularly, the physical properties of the items that are consumed. Praeanthropus afarensis is well represented in the fossil record over a prolonged and radiometrically controlled temporal span, and reasonably robust paleoecological reconstructions are available for the various localities from which it is known. We therefore examined molar microwear in this species to determine whether diet varied in relation to time or in response to different ecological conditions. Of more than 70 specimens of Pr. afarensis that contain one or more worn permanent molars, only 19 were found to be suitable for microwear analysis. These derive from eight temporal horizons in the Laetolil Beds and Hadar Formation spanning approximately 400kyr (3.6-3.2Ma). Six paleoecological categories have been reconstructed for these horizons, and these were ranked on the basis of floral cover. None of the microwear variables observed for Pr. afarensis is significantly associated with either temporal or paleoecological rank. Thus, microwear and, by extension, diet does not appear to have altered significantly in Pr. afarensis through time or in response to different paleoecological circumstances. The wear pattern that appears to have characterized Pr. afarensis overlaps extensively that of Gorilla gorilla beringei and differs notably from the fabrics of extant primates (e.g., Cebus apella and Cercocebus albigena) that consume hard objects. The high proportion of scratches on Pr. afarensis molars suggests the inclusion of fine abrasives in or on the food items consumed by those individuals sampled in this study. Although Pr. afarensis may have been morphologically equipped to process hard, brittle items, the microwear data suggest that it did not necessarily do so, even in the face of varying environmental circumstances. Explanatory scenarios that describe Pr. afarensis as part of an evolutionary trajectory involving a more heavily masticated diet with an increased reliance on hard, brittle items need to be reconsidered. However, fallback foods that were consumed during relatively short, albeit critical periods may have exerted sufficient selective pressure to explain the evolution of the comparatively robust Pr. afarensis trophic apparatus. Because it is unlikely that many individuals from such restricted temporal intervals would be sampled in the paleontological record, we suggest that the most productive approach to the elucidation of paleodiet is the integration of genetic (morphological) and epigenetic (microwear and isotopic) lines of evidence.

Animals↗
PubMed2005

Dental microwear and diets of African early Homo.

Conventional wisdom ties the origin and early evolution of the genus Homo to environmental changes that occurred near the end of the Pliocene. The basic idea is that changing habitats led to new diets emphasizing savanna resources, such as herd mammals or underground storage organs. Fossil teeth provide the most direct evidence available for evaluating this theory. In this paper, we present a comprehensive study of dental microwear in Plio-Pleistocene Homo from Africa. We examined all available cheek teeth from Ethiopia, Kenya, Tanzania, Malawi, and South Africa and found 18 that preserved antemortem microwear. Microwear features were measured and compared for these specimens and a baseline series of five extant primate species (Cebus apella, Gorilla gorilla, Lophocebus albigena, Pan troglodytes, and Papio ursinus) and two protohistoric human foraging groups (Aleut and Arikara) with documented differences in diet and subsistence strategies. Results confirmed that dental microwear reflects diet, such that hard-object specialists tend to have more large microwear pits, whereas tough food eaters usually have more striations and smaller microwear features. Early Homo specimens clustered with baseline groups that do not prefer fracture resistant foods. Still, Homo erectus and individuals from Swartkrans Member 1 had more small pits than Homo habilis and specimens from Sterkfontein Member 5C. These results suggest that none of the early Homo groups specialized on very hard or tough foods, but that H. erectus and Swartkrans Member 1 individuals ate, at least occasionally, more brittle or tough items than other fossil hominins studied.

Africa, Eastern↗
PubMed2005

Dental microwear texture analysis shows within-species diet variability in fossil hominins.

Reconstructing the diets of extinct hominins is essential to understanding the paleobiology and evolutionary history of our lineage. Dental microwear, the study of microscopic tooth-wear resulting from use, provides direct evidence of what an individual ate in the past. Unfortunately, established methods of studying microwear are plagued with low repeatability and high observer error. Here we apply an objective, repeatable approach for studying three-dimensional microwear surface texture to extinct South African hominins. Scanning confocal microscopy together with scale-sensitive fractal analysis are used to characterize the complexity and anisotropy of microwear. Results for living primates show that this approach can distinguish among diets characterized by different fracture properties. When applied to hominins, microwear texture analysis indicates that Australopithecus africanus microwear is more anisotropic, but also more variable in anisotropy than Paranthropus robustus. This latter species has more complex microwear textures, but is also more variable in complexity than A. africanus. This suggests that A. africanus ate more tough foods and P. robustus consumed more hard and brittle items, but that both had variable and overlapping diets.

Animals↗
PubMed2004

Dental topography and molar wear in Alouatta palliata from Costa Rica.

Paleoprimatologists depend on relationships between form and function of teeth to reconstruct the diets of fossil species. Most of this work has been limited to studies of unworn teeth. A new approach, dental topographic analysis, allows the characterization and comparison of worn primate teeth. Variably worn museum specimens have been used to construct species-specific wear sequences so that measurements can be compared by wear stage among taxa with known differences in diet. This assumes that individuals in a species tend to wear their molar teeth in similar ways, a supposition that has yet to be tested. Here we evaluate this assumption with a longitudinal study of changes in tooth form over time in primates. Fourteen individual mantled howling monkeys (Alouatta palliata) were captured and then recaptured after 2, 4, and 7 years when possible at Hacienda La Pacifica in Costa Rica between 1989-1999. Dental impressions were taken each time, and molar casts were produced and analyzed using dental topographic analysis. Results showed consistent decreases in crown slope and occlusal relief. In contrast, crown angularity, a measure of surface jaggedness, remained fairly constant except with extreme wear. There were no evident differences between specimens collected in different microhabitats. These results suggest that different individual mantled howling monkeys wear their teeth down in similar ways, evidently following a species-specific wear sequence. Dental topographic analysis may therefore be used to compare morphology among similarly worn individuals from different species.

Alouatta↗
PubMed2003

A solution to the worn tooth conundrum in primate functional anatomy.

Worn teeth are a bane to paleobiologists interested in the diets of human ancestors and other fossil primates. Although worn teeth dominate fossil assemblages, their shapes are usually not used to reconstruct the diets of extinct species. The problem is that traditional studies of primate dental functional anatomy have focused on unworn morphology. This has limited most functional analyses to only a few well-represented fossil species. This paper introduces a method to characterize and compare worn occlusal morphology in primates using laser scanning and geographic information systems technologies. A study of variably worn chimpanzee and gorilla molars indicates that differences between these species in tooth shape remain consistent at given stages of wear. Although cusp slope decreases with wear in both taxa, angularity values remain unchanged. These results indicate that African ape teeth wear in a manner that keeps them mechanically efficient for fracturing specific foods. Studies of changes in tooth shape with wear add a new dimension to dental functional anatomy, and offer a more complete picture of dental-dietary adaptations. Also, given how rare unworn teeth are in the fossil record, the ability to include worn specimens in analyses opens the door to reconstructing the diets of many more extinct primate groups, allowing us to better understand the adaptive radiation of our order.

Analysis of Variance↗
PubMed2003

Occlusal relief changes with molar wear in Pan troglodytes troglodytes and Gorilla gorilla gorilla.

Most research on primate tooth form-function relationships has focused on unworn teeth. This study presents a morphological comparison of variably worn lower second molars (M(2)s) of lowland gorillas (Gorilla gorilla gorilla; n=47) and common chimpanzees (Pan troglodytes troglodytes; n=54) using dental topographic analysis. High-resolution replicas of occlusal surfaces were prepared and scanned in 3D by laser scanning. The resulting elevation data were used to create a geographic information system (GIS) for each tooth. Occlusal relief, defined as the ratio of 3D surface area to 2D planometric area of the occlusal table, was calculated and compared between wear stages, taxa, and sexes. The results failed to show a difference in occlusal relief between males and females of a given taxon, but did evince differences between wear stages and between taxa. A lack of significant interaction between wear stage and taxon factors suggests that differences in occlusal relief between chimpanzees and gorillas are maintained throughout the wear sequence. These results add to a growing body of information on how molar teeth change with wear, and how differences between primate species are maintained at comparable points throughout the wear sequence. Such studies provide new insights into form-function relationships, which will allow us to infer certain aspects of diet in fossils with worn teeth.

Animals↗
PubMedDate not supplied

Quantification of dental microwear by tandem scanning confocal microscopy and scale-sensitive fractal analyses.

Dental microwear analysis is among the most commonly used approaches to reconstructing the diets of extinct animal species and past peoples. The usual procedure involves imaging tooth wear surfaces by scanning electron microscopy (SEM). Surfaces are characterized quantitatively by measurement of individual wear features (pits and scratches) on photomicrographs. Recent studies of living animals have shown associations between diets on one hand and patterns of dental microwear on the other. Furthermore, patterns on fossil teeth have been used to reconstruct diets in extinct forms. However, conventional methods for microwear analysis are limited. Scanning electron microscopy does not provide a true representation of these surfaces in three dimensions, and identification and measurement of individual features is time consuming, subjective, and subject to high interobserver error. This paper describes a new approach to the analysis of dental microwear using tandem scanning confocal microscopy and scale-sensitive fractal analyses. The instrument used in this study provides three-dimensional coordinates representing surfaces at a resolution equivalent to that employed by most SEM microwear studies. Fractal analyses offer objective, repeatable, quantitative characterization of surfaces. This approach eliminates major sources of error and increases power to resolve differences between species. Moreover, rapid surface characterization will allow examination of large samples to assess within species variation and to make finer distinctions between species.

Animals↗